Find a professional gyprocker contractor near you

Walls and ceiling gyprock removed in one room. Re insulated and gyprock and cornice replaced.

Replace gyprock on two sections of a kitchen wall

Gyprock wall metal or wood frame and door, frame, skirting and cornice. L shape wall, 2.6 long with door x 2.4m wide, ceiling height approximately 2.7m

I’m looking for someone to repair a hole in an internal plasterboard/Gyprock wall (see photos). The hole is approximately 15–20 cm across. I’d like the repair to include: • Patching the hole properly • Sanding the repair smooth • Applying undercoat/primer if required • Painting to match the existing wall (or I could possibly find the match myself and happy to supply the paint) Please bring your own tools and materials. If you have experience with plasterboard repairs and can achieve a seamless finish, please get in touch with your quote.

Gyprock a fireplace surround

I am seeking for quality carpenter to perform below tasks, - Supply and install a new solid-core door (External - 1 door) - Supply and install 5 hollow-core door (Internal - 5 doors) - 1 - Gyprock wall reshaping ( it’s very high roof wall, wall to the roof, don’t have ceiling, this wall between common room and kitchen - need to cut some part of it and make a extension room ) - Some 4/5 places in ceilling come down, need to nail it and some walls need to nail it too. Location: Coonamble NSW 2829

Hi, I need a gyprock hole wall repaired. 1. Hole size is approximately 35–40 cm (see attached photo). 2. Supply and install a gyprock patch. 3. Plaster, sand, and make the wall smooth. 4. Apply primer and match the existing white paint on the repaired area. Please send your quote and availability.

Patch hole on ceiling must be available tomorrow

Proven professional gyprocker/plasterer to: 1. Gyprock sheet both sides of a sliding door cavity that has been removed and replaced with studs/noggins ready for sheeting. 2. A non-load bearing wall has been removed (4.5m wide *2.7m high) and gyprock sheet required to lhs and rhs and ceiling where wall removed, including adding cornice to both ceiling sides. 3. Replace gyprock sheets to several ceiling holes that were cut out as inspection ports prior to the wall being removed. Gyprock to be left to a very high standard ready for me to paint. Ignore the far wall in the photo with the insulation batts. That won’t be gyprocked as part of this work. Job can be done in 2 parts: Part 1 to be done ASAP sheet old sliding door cavity and lhs of wall where wall removed. To make way for cabinetry install along that wall. Part 2 : remainder of work over next 4 weeks.

Damage to ceiling gyprock due to an accident several months ago. Scope of work needed: Remove the protective sheeting. Prepare and Clean the ceiling framing. Supply and Install new 10 mm thick ceiling grade plasterboard in approx. 12 m2. Cut holes x 3 for ceiling downlights into new gyprock sheet. Back block edge joints. Fill, Tape and Flush the abutting edges. Sand over the applied fillers ready for painting.

I’m after someone to replace the gyprock in a bulkhead and wardrobe and then paint. Paint provided. Bulkhead is roughly 1400mm wide by 250mm high. Wardrobe section is 600mm by 1300mm

Reattach a plastic strip light to a rock ceiling in the kitchen of a townhouse in Tugun. The Wallmate screws have given way.

Need two holes in grpock fixed up. Both relatively small holes and have been roughly fixed up but need a proper fix. Left in a ready to paint condition.

Looking to get kitchen area and around doors etc ready for painting. Please see attached. Need it done by Wednesday.

Repair some nail holes make surface good and paint over (supplied) Paint one wall, repair minor damage to two internal doors, make good and paint.

Cut open existing plasterboard wall and install some plywood or timber bracing to take the weight of the tv. Reinstate Gyprock and install tv bracket above fireplace

Patch whole in wall gyprock around 30cm

Looking to have some gyprock repaired on stairs where damage was caused from removal of previous floorboards.

Need a timber frame built for a office partition with gyprocking. New frame required as per "red". And gyprock the new frame and also the existing frame (3.57m), excluding door way