Find an experienced plumber in Spring Hill QLD

Fix leaking expansion control valve on hot water unit

Remove current shower head, install new shower head

Shower head and tool’s provided

Hello! I need 2 PVC 90mm storm water pipes as well as the gutter pieces and 300mm square pit installed in my rear driveway area to allow water to drain out to the street. Needs existing bitumen on the footpath side cut and dug out and also a square hole cut and dug to fit the new 300mm plastic pit and all surfaces covered back with supplied bitumen and concrete. 1. Cut existing stone gutters to fit 2 x Storm water Adapter Kerb 90mm - All supplied 2. Cut and trench two lines at 200mm wide into the existing bitumen on the foot path 150mm deep enough to fit 2 x 90mm PVC Storm water pipes. Length is 3.2m as shown in the supplied photos. 3. Install the 300mm square plastic water pit supplied. Will need to cut the existing concrete surface and dig to suit. Cut holes in the pit to fit the 2 90mm PVC pipes. 4. Cover the PVC pipes in the trench now with bitumen on the footpath side and concrete in the driveway area. 5. Put concrete around to secure the new pit and level as needed. All materials including bitumen and concrete supplied.

Looking for a plumber to install a new kitchen sink tap for me

I currently have a 125L hot water tank and I want to install an additional 125L tank to increase the total hot water capacity. The new tank should be connected in parallel to the existing system, sharing the same cold water feed and combining the hot water outlets into the house supply. The goal is for both tanks to fill and heat at the same time, effectively providing around 250L of hot water capacity. The installation should include the appropriate fittings, valves, and connections so the system runs safely and efficiently.

the fridge door is leaking water need to get if fixed

There is a leaking outdoor trap which is dripping 1 drop every second needs replacement

Toilet overflowing into toilet bowl. I tried to replace inlet valve but unable to undo existing. Task is to replace with new Kinetic inlet valve from Bunnings. Photos show old part (white) and new part (grey).

Kitchen mixer tap has very poor water pressure.

Fit Kangen water filter to kitchen tap. Have had problems with the connection, you work it out. It works fine in the bathroom but we would like it in the kitchen. We pay for parts.

Hello, Ensuite bathroom has been freshly tiled in Spring Hill Need help with Installation of cabinetry - 1x *750mm slimline wall hung vanity - 1x *Shaving cabinet Installation of plumbing services - 1x *toilet (S-trap) - 1 x vanity drain & faucet - 1x *shower mixer diverter tap - 3x Robe hooks

Have a leaking copper elbow, would need help fitting a new one to stop it leaking

Looking for a quote for a supply and install of a new 32mm/40mm pop-up basin waste including labour and a quality replacement part. Thank you.

Someone with plumbing knowledge needed to fix 1) place the wash basin plug back into sink. I tried pushing hard downwards but it keeps bouncing back . Theres a spring there as seen in picture. Should take 20 minutes (guesstimate)

Hi there, I’m looking for a plumber to fix a leak under the kitchen sink. The leak is coming from the drain area and is filling the cupboard underneath. Ideally looking for someone available as soon as possible

Install tap on balcony on other side of kitchen

Our en-suite shower has poor water run off, not related to drainage but slope of floor Located in an apartment

Need to fix the water leakage from Flush Tank and Shower Head, Change

Need to unscrew a tight shower hose that's connected to the wall water outlet. Looking for someone with plumbing experience and tools. Existing hose connection to the wall is very tight and will not loosen. Should be a quick job with the right tools. Any time on Friday (June 20) should suit.