Find trusted local electricians in Erskineville

"Smeg Gas cooktop (5-burner stainless) sparking/arcing from electrodes on 2 burners (top-right + bottom left) even knobs OFF—no gas smell. Recent cleaning caused moisture short. Need licensed gasfitter to replace igniter/module/switch.

Hello, hoping a licensed electrician can come fix one of our fire alarms that’s wired into the ceiling either today or tomorrow (7/03 - 8/03). It keeps making a beeping/chirping noise, we suspect it was a flat battery, but when we changed the battery it was fine for a few days but now beeping/chirping again and can hear a slight static noise coming from it. Can someone please fix or replace it. Thank you.

I have the following that require rewiring: - 5 Floor Lamps - 6 Table Lamps

Need to change 3 electrical sockets. Can provide picture if needed

Looking for an electrician to install an IKEA pendant light

Plasterboard pillar with metal stud in bedroom has 1x double powerpoint and 1x ethernet point on one side. Would like to relocate to the other side. Would like the existing hole to be patched up. I have paint to supply and/or can paint myself.

I own a SMEG cooktop. Gas works completely fine. Ignition does not spark/work on any burner. Have tried different power outlet and does not work. Seems it could be the spark generator and/or ignition module. Looking for someone to repair for me as I'm not qualified nor able to. Thanks.

I’m looking for a licensed electrician to inspect an ILVE built-in electric oven. The clock/display turns on, but the oven does not heat on any setting. Have cash.

Looking to run a PowerPoint to a different location in a lounge room and add a PowerPoint to an outdoor area of a balcony (power close)

I have had some external powerpoints and lights installed and to better integrate with the surroundings I want them to be painted. Also to patch where a couple of existing lights were replaced by smaller ones. Note - I’ve put a budget in as I don’t know the range - the Airtasker community will obviously guide I can arrange paint or you can source - I can supply the details of the colour scheme. Plenty of photos included - so please ask questions to clarify. Flexible in timing but ideally completed before November 9

I want to change four light fittings and need a licenced electrician , there may be also be some repair work required due to the hole in the ceiling the last oyster light left and I changed to a bar lighting

Fuse for dashboard circuit on cb125e keeps blowing - need diagnosis and fix

Huawei modem, NBN to house input cable already set up for connection. I can’t get down to floor so need younger knees! Ensure set up OK

I need two things looked at: 1. The LED light on my Martec ceiling fan needs replacing. I’ve already ordered the replacement part – it just needs to be installed. 2. The TV aerial connection isn’t working properly. The input plug is bent and likely needs to be repaired or replaced to restore the signal.

Our bathroom ceiling light has stopped working. On inspection, the wires appear brown/discoloured, so we suspect there may be an issue with the wiring. We have a spare fitting that can be used.

Install both Dishwasher and Oven - details as follows: 1. Dishwasher - Bosch Series 4 Built Under Dishwasher 2. Oven - Bosch Servies 4 60cm Pyrolytic Oven

Removal of 6 roller blinds and 8 light fittings needed.

Tradesperson required to procure and replace exhaust fan in terrace bathroom, and replace lightbulb in antique downlight

Electrician to fix He saying that gill has to be read 15M plug and 20M individual breaker

4 x PowerPoints - 1 may need conduit