Find trusted local electricians in Potts Point

I need this plug socket moved about 30 centimetres across to the right as I’m going to have a built in wardrobe installed and don’t want it inside the wardrobe. I also have a table lamp I need someone to look at. It keeps flickering.

I need by bar fridge fixed to the cabinet door please

New kitchen requiring new plugs (one single for fridge, one single for microwave, one double and one quadruple plugs) and install and connect oven, cooktop, dishwasher and rangehood. Connect power to mains from safety switch (already installed)which is 1.5 m away

Title: Modernise TV/Power Outlet & Consolidate Light Switches (Licensed Electrician) Description: I’m renovating my living room and preparing for the installation of a walnut timber feature wall. I’m looking for a licensed electrician to complete the following work and provide a clean, contemporary finish. 1. Replace Existing TV/Power/Data Outlet I’d like the existing bulky combination wall plate replaced with a modern, slimline or recessed solution. The new installation should retain: * Power outlets (4 GPOs or as recommended) * NBN FTTB DSL (RJ11) outlet for my modem * One TV coaxial outlet (for future use) The second coaxial outlet is no longer used and can be removed if appropriate. I’m happy for you to recommend the best solution (e.g. Clipsal Iconic or similar). 2. Consolidate Light Switches There are two switch plates approximately 400 mm apart. I’d like all existing switches and dimmers relocated and consolidated into a single multi-gang switch plate in the location of the current single switch. Please: * Remove the existing larger switch plate. * Extend wiring as required. * Patch and make good the redundant wall opening so it is ready for timber panelling. * Reuse existing dimmers where practical or supply compatible replacements if required. The aim is to minimise the number of visible wall plates before the timber feature wall is installed. Please provide a quote including labour and materials. Photos are attached. Happy to discuss the best solution before work commences.

I need two faulty surface mount down lights replaced. Ideally the tasker will also pick up the replacement lights in the same style

I have 11 light switches and power points that are starting to wear out mechanically. I've already purchased the replacement switches/power points — the replacements just need to be installed by a licensed electrician.

Move two PowerPoints lower so these fit under bed for use (bed base is currently touching them) Gyprock wall Attach blank covers on old PowerPoints

Rewire an old standard lamp

2 new rooms only framing put up, walls are all open : Four power sockets(supply install) Two ceiling fan lights(bought already) 2 led strips(2.2m*2.25m, and 1.7M*3.3m)supply install light strips and also the aluminum profiles Please accept this offer and let me know costs, then we communicate

There’s an issue with the hot plate switch again, Whenever it is turned on, there is a trip. We’ve kept this switch off for now. But the fridge, microwave and washing machine aren’t working. Can you send an electrician urgently to have this fixed?

Need a large pendant light fitted to the ceiling

I need an electrical socket / power point for the cupboard under my stairs as I’ll be converting it to a home office

I’ve recently purchased an apartment in Potts Point and am planning some minor works immediately after settlement. Timing: Works targeted for 1 June 2026, ideally completed in a single visit prior to cabinetry install. Scope of electrical works: Living Room: Install two new double power points. Walls are solid brick Kitchen: Confirm suitability of existing power for a new Fisher & Paykel drawer dishwasher. Existing setup includes a 4-gang GPO inside adjacent cupboard currently used for washing machine and fridge

Currently have ceiling fan without light - need an electrician to uninstall fan (see first photo) and install fam with LEd light (see second photo as ordered). Friday 27 March please. Reach out any questions.

The power in my apartment went out around 7:00 am today. The building still has electricity, so it seems to be limited to my unit. I checked the switchboard and tested the breakers. The RCD safety switch trips immediately when the circuit breakers are turned on. I have already unplugged all appliances in the apartment to rule out overload, but the issue continues, so it may be a fault in one of the circuits or the RCD itself. Looking for a licensed electrician to come diagnose and fix the issue today if possible. Location: Potts Point, Sydney. Please send your call-out fee and estimated hourly rate.

Electrical Rewiring – 35sqm Apartment (Potts Point) Small 35sqm apartment currently has no functioning internal power after previous flooding. The switchboard has already been replaced, and there is currently only one temporary outlet supplying the unit. Looking for a licensed electrician to inspect and provide a rough quote for restoring full power to the apartment. Ideally seeking the quickest safe and compliant solution so the unit remains liveable during works. Open to running new circuits in surface-mounted PVC conduit rather than chasing walls. Scope likely includes: • Running new internal circuits • Installing multiple power points • Installing basic ceiling/batten lighting • Testing and compliance certificate Please provide: • Rough cost estimate • Estimated timeframe • Availability for inspection

Need a pendant light wired I to ceiling. Chased cables and switch already in place

I'd like 3 electrical tasks done in my apartment I've explained in some pics about these 3 things, and I detail a bit below to explain. If you're interested in providing a quote, please let me know. #1 Install new bathroom fan extractor Old fan is 14 years old - decided to replace fan as making horrible noise Have purchased the product - it's getting delivered soon - the model picture from website is attached here. Photos attached in PDF - seems a simple job or just rewiring and installing. Dimensions are: Current ceiling square hole 205mm square Dimensions duct pipe - 95mm diameter #2 Rewire a connector box (to power Philip Hue lightstrip) Fluorescent tube for kitchen splashback was wired into a connector box in the cupboard above Decided to replace the tube with a Philips Hue lightstrip, as that syncs with the Smart Home etc Currently the lightstrip is just plugged into powersocket on kitchen bench (which looks ugly and temporary). Would like this wired up into the connector box in the cupboard above, and rewire the connector box so that it powers the Philip Hue lightstrip instead of the existing fluorescent tube Photos also attached with the above. Again seems a simple job (hopefully no drilling required if you can just poke the power cord for the lightstrip up into the cupboard using the existing hole that the fluorescent tube uses). #3 Install new power socket Want to install a new power socket in a wall - actually it's technically a column per the PDF attached The pocket socket will be used to power appliances on the kitchen benchtop and the Amazon Echo (mini tv screen) above it Attaching building drawings in the PDF if this helps Any questions, please don't hesitate to let me know. If the images are too pixelated, I can send through better images I don't know how much this costs - so looking for quotes to come in. The $300 I just put in to fill the box - if you think you can do fairly for less, then please quote that.

3 light jobs: 1. Bathroom downlight not working (needs replacing to match others). (image 1 and 2) 2. Wardrobe light globe replacement. (image 3) 3. Wardrobe light fitting missing (needs new fitting installed). new globes and fittings I can organise based on what you need. Apartment in Potts Point, corner Macleay & Challis Ave. Street parking available only.

Take down light and install down light on ceiling