Find trusted local electricians in Lidcombe

Bedroom requires the ceiling light fitting to be replaced. This includes uninstalling the current light fitting, replacing with a new fitting and light bulb.

Need an electrician to install 1 GPO and trunking for some small wires Photos provided

Please provide a quote for the installation of new light fittings. Light points preinstalled with light batten in place, please refer to photos. New light Fittings provided by owner, refer photo for fitting type. Lights Ensuite: 2x wall lights Powder room: 2x wall lights Stairs: 2x wall lights Kitchen Island: 3x pendant lights 9 lights total

We have an upright stove/oven and a ceiling fan that need wiring up.

Switch has malfunctioned in bathroom, the faulty switch runs the light and exhaust fan (top switch only).

Need a cable ran from internal subboard down to basement, ev is already installed but to main swb

Looking for a licensed electrician to replace 10 existing LED Bollard Lights with ones that we will supply. Easy access on a shared/common driveway The scope of work would include: *Establish safe works exclusion zone. * Isolate power. * Replace 10 x LED bollard lights. Lights to be supplied * Supply & replace 1 x 20A RCBO. * Energise, test & commission. * Disposal of all waste Must provide GST invoice upon completion of the works (Not the Air Tasker one)

Replace two electrical wall sockets

I have solar panels that have mesh fitted as a pigeon has found a way in. I need the pigeon removed and the mesh repaired.... double story house Lidcombe

Seeking a Level 2 ASP for a consumer mains upgrade at a residential property in Lidcombe. The current 6mm consumer mains are insufficient for a new 42kW battery storage system and 6kW PV array. I require an upgrade to 16mm² XLPE mains to meet AS/NZS 3000 standards and ensure adequate current carrying capacity for high load off peak charging. The site is currently equipped with an EDMI Atlas Mk7A smart meter (NMI available upon request). The scope of work includes the mains upgrade and a full switchboard compliance check to prepare for a transition to a Time of Use EV energy plan. Please include your NSW Electrical License, ASP Category 1/4 credentials, and confirm that a CCEW will be issued upon completion. Point of attachment is easily accessible.

NBN connection is active. Using available multi core cables, the terminations and RJ45 patching to be done

I have a bunch of old downlights that have been hardwired. They all work just fine, but I want 3 of them converted to 413 sockets so I can plug in some warm LED downlights.

Need licensed electrician to replace 2 light fittings. Replacement lights will be provided.

Hi, need electrical wiring done to add a wall mounted mirror with led, plus ceiling exhaust fan. Job is only for the electrical wiring part.

I need an electrician to change one downlight in our bathroom from hard wired to plug and play. Located in Lidcombe. I will reimburse the cost of the light in cash so the offer is only for labour.

Bathroom downlight not working. Replaced bulb, no difference. Sometimes when the switch is turned on, the light flickers. Have tried reseating into socket. May be issue with transformer? The cable is connected to SAL Mini Electronic Transformer.

I have a simple job to replace 1 LED light. I have the replacement light (don't need to supply) already with power cable however the old light has a power driver without power point for me to connect to LED and hence will need this converted

Hey, as per the title, house is double story 2010 build with attic access and cabling shouldnt be too difficult. Need it to two rooms which are approx 15m from the main cable point. Thank you

Need to change or fix bulbs or Globes

Need to get a quote for 20 downlights installed upstairs. Already have existing downlights upstairs but want to add more