Find trusted local electricians in Carlingford

Need a licensed NSW electrician to: 1. Replace an existing ceiling exhaust fan (photos attached) — same location, existing wiring/ducting already in place 2. Replace one power point under the kitchen sink (photo attached) Please supply and install both. Straightforward swaps, ideally done together in one visit. Must hold a current NSW electrical licence

Installation of Split AC unit on ground floor and removal of previous unit.

Looking for a licensed electrician to remove an existing pendant light and supply and install 4 downlights to match existing downlights. Double storey house (area is on the top floor). Ceiling is 2.7m. Please only make an offer if you are a licensed electrician and can share your valid license number.

My instant water heater, a Bosch Hydropower has been leaking. It's an old model, and costly to repair, so I'm thinking of replacing the entire unit. The leak comes from the water valve (See identical issue here: houzz.com.au/discussions/6421413). The replacement part costs around $300. I believe the threaded part, behind the two pins of the valve has a missing o ring leading to the leak. I've tried tightening the nut as much as possible, but it doesn't fix the leak. NB:Please let me know in your offer if you wish to complete a minor repair, or swap the entire system entirely.

One power point in the study room is not working due to a loose switch.

Move PowerPoint upwards by 5 inches no cabling needed PowerPoint already there

I need level 2 electrician to remove control load

Ceiling light fitting install required. Old one removed for repainting

Hi, I’m looking for a licensed electrician to complete three jobs at my home in one visit. All replacement fixtures will be supplied by me — you just need to bring your tools and expertise. Job 1 – Replace damaged double GPO (kitchen) One of the power points on the kitchen double GPO is burnt out and no longer safe to use (see photo). Needs to be replaced with a new double GPO. Please bring a like-for-like replacement, or let me know in advance if you’d prefer me to supply one. Job 2 – Replace 3 pendant lights (kitchen island) Three existing pendant lights above the kitchen island bench need to be removed and replaced with 3 new pendant lights (available). Existing ceiling mounts/wiring are already in place. Job 3 – Replace bathroom 3-in-1 heater/light/exhaust unit The existing 3-in-1 unit (2 heat lamps + center light/fan + 2 heat lamps) needs to be removed and replaced with a new unit (available ). Same opening size.

Need to run a snake between two brush plates to run tv cords through.

Install 2 x batten fluoro lights in kitchen. Lights will be onsite ready for install. Replace 1 x double power point (which will also be provided).

Position: Technician – Electric Fireplace Repair Location: carlingford Job Type: One-Time Repair / Contract We are seeking an experienced technician to diagnose and repair an electronic fireplace that stopped working after being mishandled during moving/transportation. The unit was functional before relocation but is now powering on but not heating (exact issue to be confirmed upon inspection). Responsibilities Inspect the electronic fireplace for internal damage Diagnose electrical or mechanical faults caused by moving Repair or replace damaged components (wiring, switches, heating element, display panel, etc.) Test the unit to ensure safe and proper operation Ensure all repairs meet electrical safety standards Requirements Experience repairing electric fireplaces or similar home appliances Strong electrical troubleshooting skills Ability to identify and replace faulty components Own diagnostic tools and equipment

need to replace my living room’s pendent light with new light It’s 5.8 meters high and you need to have either long ladder or scaffold

I want to service for below. You have to buy downlight and related things. - install 40 downlight and 10 downlight dimmer to control it. - install 4 fans and switch - install 3 hanging light for the kitchen

I require a licensed electrician (with current NSW registration if applicable) to carry out the following work: Connect four ceiling fans (each with integrated lighting) to the existing lighting circuits/final subcircuits. The fans are already assembled and securely mounted to the ceiling joists using appropriate fan-rated brackets/supports. The previous light fittings have been removed, leaving the existing ceiling roses or junction boxes ready for connection. Each fan includes a light kit, and the supplied remote control receiver/handset allows independent operation of the fan motor and the lights (i.e. separate switching/control via remote). Supply and install two double GPOs (general purpose outlets / power points) in the attic/roof space. This will involve running appropriate TPS cable from the nearest existing circuit or distribution point in the roof space (or as determined on site), installing two flush-mounted or surface-mounted double socket outlets in suitable locations, complete with architrave brackets or wall boxes, attaching to a single timber frame/joist as required, and making safe connections back to the existing cabling. The attic has a catwalk/platform with carpet underlay, allowing comfortable and safe access without risk of falling through the ceiling. Please see the attached photos showing the existing ceiling wiring/rose and the fan's wiring diagram/label for reference.

Hello, I need a quote for electrical labour only. I have a 4800kw electric hot water system and solar panel . And want to install timer and relay to save electricity. I can buy a 20A relay + timer. I just need licensed electrician to install them properly. Previous electrician installed a 10a timer and burnt. All the electrical wiring are done so it is an easy job . Not urgent, weekday or weekend daytime is fine. Address Carlingford NSW. Please quote total labour cost.

Hi there, I’m looking for a licensed electrician with direct experience installing CATCH Power devices (specifically Green CATCH / CATCH Control) to divert excess solar to an electric hot water system. Could you please let me know: • Whether you have previous hands-on experience with CATCH Power installations • If you can install and commission the unit in the meter box • Your availability and an indicative cost for installation I’m located in NSW and already have solar installed. Thanks in advance,

electrician required to install a wifi quad switch, mercator brand

Remove 7 ceiling lights. Install 10 new plug bases and down lights. (In two bedrooms, 6-4.)

Disconnect the (electrical wiring) from old cooktop, remove and install new cooktop (connect wiring of new cooktop)