Find a trusted local electrician in East London

Two external lights needed to be fixed and one socket to be changed

The Problem: Hot water stopped working recently after a circuit trip Hot water runs for ~1 minute then goes lukewarm/cold System pressure is fine (topped up to 1.5 bar) ViewSmart controller is on and set to Comfort mode Heat meter shows good inlet temp (65°C) but poor output temp What I've Already Done: Checked and adjusted system pressure Confirmed KWF mode is set to Comfort Attempted power reset Likely Issues (to save you time): Based on troubleshooting, the problem is most likely: Failed/stuck PICV actuator (Item #2) - not opening properly after power cut Clogged Y-strainer on primary circuit (visible corrosion from an old leak present) Scaled/fouled plate heat exchanger What I Need: Gas Safe registered heating engineer with HIU/district heating experience Diagnosis and repair of the faulty component(s) Service/clean the corroded Y-strainer while accessing the system Test to ensure hot water is restored Access: Easy access to HIU in utility cupboard Flat is in a managed building with district heating Please include in your offer: Your experience with HIU systems (especially Evinox ModuSat) Estimated time to complete Whether parts (actuator, strainer seals) are included or extra Your Gas Safe registration number Looking for a professional who can get this sorted quickly. Happy to provide more photos or details if needed.

Need an electric heater and mirror fixed on the wall

Cracked faces of 2 x floor sockets require replacements. And some lighting needs to be de-rated due to open circuit.

Mount cooker hood and chimney

Circuit board on electric golf trolley blown

Recently had a handyman accidentally drill into wiring in bedroom ( to put up and secure a wardrobe. ). This caused a spark and related RCD control circuits to flip. Was able to get the RCD circuits back up to get electrics back for other sockets but currently for safely, this socket is out of use. Need a qualified and insured person to repair the wiring above this socket ( will provide costs for materials needed ofc ). It is a solid wall. Would need to move the wardrobe ( which I can help with too ) to access this socket/wall I DO NOT currently have specific images as they will not show anything other than a standard socket image attached and a small hole 1.5m above it where it was drilled.

I would like electric socket moved from side of the wall to in the middle of the chimney brest

Please refer to the floor plan on, I need to complete installation a kitchenette in the ground floor store room (1st of 3 floor plans, this is now empty and turned into a granny amex for my mum). Previous "multitrader" did a runner after asking to go off Airtasker to save his fee, but taking a hefty deposit for an expanded job he proposed, you can see his unfinished work, that also needs fixing, like the shower hole and the bathroom sink casing he removed to pass his plumbing though the adjacent bathroom (that basic shower panel needs replacing). Now plumbing and electrics has been done by qualified tradesmen. A cupboard containing an extractor hob has installed above the kitchenette,, as there is ducting running through the west (right) wall of the store room, for the bathrooms extractor fan to the outside garden, the kitchens extractor hob would need to be connected to it. However this jokers carpentry work is unsafe getting unstuck from wall, so it needs to be redone. The kitchennete is a pre-built "Elfin Kitchens" 1.2m wide model "M-120-Ms/sMOS-K/T/C/I" in the 100kg weight mark, alar containing a single height fridge, small oven and 2 hobs. Dimensions in one of photos and you, can also check it out on the companys website which also has instructions on how to install each model. Basic knowledge of electrics & plumbing is also needed to turn off water supply and disconnect plumbing so the kitchennete can be pulled back and the carpentry work fir the upper walk cupboard carpentry redone, and then fit the sockets to your carpentry (that should secure the cupboard and make a proper plaster wall)

The generator need to be repaired

Cabinet Replacement: Kitchen cabinets are damaged and need to be replaced. Cleaning & Painting: Full cleaning of the affected area, followed by repainting of walls and ceiling. Lighting & Electrical: Two ceiling lights are damaged and need replacement. The underlying electrical wiring should be inspected and any issues fixed to ensure safety.

hi this is the flat with electric tank(boiler) was wondering if can add (install) electric shower in the flat. thank you

Fit electric meter - fully qualified Electrician

I want an electrician to replace 4 light switches to dimmer switches and install a couple of ceiling lamps.

Some of my outdoor roof lights need to be stuck on. My ladder is not tall enough for this job so this task requires a really long ladder. Only accept if you are capable of doing this. The light has stickers attached to it so no drilling job required. Picture shown shows the red line which needs to be installed. The blue line is what I installed already

To fix electric outdoor light

I’m looking for an engineer or electrician who can remove my existing chimney cooker hood and install a new one. I haven’t bought the replacement yet.

Fault find. Electrical lighting

Replace 2 light switches. I will provide the replacement switches.

The previous owner of my flat has left some ceiling lights up in the bedroom and I’d just like someone to bring a ladder, unscrew and reconnect a new ceiling light. Someone who is comfortable with electrics.