Hire an affordable Carpenter for any job in Tooting

Install kitchen units in small galley kitchen. On left side of kitchen to fit sink base unit and sink. Next to that space for a slimline dishwasher. Next to that an oven housing unit with space for hob above. Next to that a small 30 cm wide drawer unit. Worktop to be installed with space made available for hob and sink. On right side of kitchen to install 1 tall boiler housing unit. Next to that a small 30 cm wide and deep drawer base unit plus 30 cm deep breakfast bar. Above the breakfast bar to install brackets for microwave.

Shallow fitted wardrobe needed! The space is 1700mm wide, 2310mm high and 355mm deep. Two sliding wooden doors (from B&Q) need fitting, plus a simple, bespoke interior. We're looking for a few shelves inside for clothes and shoes, plus a few front-to-back clothes rails. There will be no sliding or opening drawers inside, as we doubt there's enough room! We have a rough plan drawn up but the job will need measuring properly.

I require my ceiling to be skimmed & wall edging (top & bottom) to be tidied up (as I pulled down my previous ceilling and took off the skirting board). The ceiling is around 18 square meters (joists are exposed).

Assembly of small garden storage shed. It's a 4ft x 2ft shiplap pent roof storage shed.

Build this shed promptly it come many small and large parts. Shed approx dimension 2380mm x 1190mm

We need shelves to be installed into a basement of an office. Floor to ceiling across two walls with dimensions roughly 35cm height, 30cm depth, 6 shelves high. We also want more shelves covering a wider area across a third wall. Happy for you to visit the office to give a proper quote and for me to show you what we want. Attached are photos showing the current set up

I am looking for an experienced carpenter to build a mid height cupboard into the alcove space in my living room. There is already a cupboard in the other alcove so I need the new one to match the existing one. I have attached photos of the space and also the existing one for reference. Anyone bidding please state your experience and also timings to complete the task. Thanks!

We need a wooden counter for a coffee shop 30x210cm. This will have panelling and a marble counter attached to it so just needs to be a base. We also need seating roughly 40/50cm x 300cm again this will be covered with panelling and leather seating so will be a base. We would like to use the seating as storage so we would like it hinged and the ability to lift.

I need the garden to be paved then I need a large shed to be assembled. Shed will be provided.

Hi, I need quotes to do the following all labour only: 1. Existing engineered wood flooring needs relaying. Approx 60sqm in total over 2 floors (loft is one large room 22sqm, first floor is 2 bedrooms (both with fireplaces and one with a bay) 14sqm and 17 sqm, and a hallway 8sqm). There are 3 stair nosings to be fitted, 3 door thresholds, 8 metres of finishing strip over 3 separate runs. The existing floor is tongue and groove but was not glued, so all needs to be lifted and re-layed and glued 2. Pine skirting board to be lifted to enable laying of floor, and then new skirt to be cut and fitted. Approx 30m 3. 2 door apertures to have existing architrave, linings and stops removed and new ones fitted. The existing ones are out of wind and the doors do not sit properly (all pint). 4. Existing doors to be fitted/planed/hung correctly. Currently all furniture is removed from doors 5. there are 2 other doors which were hung but not cleanly. They have been removed for decorating and all furniture has been removed. Rehang/plane/adjust/fit furniture 6. Remove existing window board which is not level. Level base and fit new pine window board. Single straight run of approx 65cm

Small galley kitchen. On left side to fit it 1 sink base unit and sink. Next to that space for slimline dishwasher. Next to that oven housing unit. Next to that small 30 cm wide unit. Worktop to be installed on top with space made available for 4 hob and sink. On right side of kitchen, 1 tall boiler housing unit. Next to that 30 cm deep breakfast bar with 1 unit 30 cm wide unit at one end.

This is a Magnet kitchen and the drawers and framing are coming apart due to weight problems. We want them straightened and reinforced

I need a large wooden but rainproof shelter built for my dog in the garden, materials provided by you Need it done ASAP Need it to last him practically his whole life he’s very big

We would like to have some shelves installed in our living room and bedroom - ideally painted MDF. There would be a total of 16 shelves to be put in!

We have a pantry sized cupboard and want to increase the number of shelves in it. We would like someone to put up 2-4 shelves in the cupboard. Ideally we would like someone to provide the tools and the wood if possible (we do not mind what type of wood and we can provide exact measurements, but the shelves will need to be approx 75 (length) x 40cm (depth)