Find experienced local tradies in Sydney Northern Beaches

Looking for an experienced handyman/carpenter to complete some finishing work on an outdoor sauna in Narraweena Tasks include: Re-fix some loose asphalt roof shingles Install rubber edging to the front and rear cladding Fit timber trim around the front and back of the sauna Cut ventilation holes using a hole saw Unbox the sauna heater and place it inside the sauna Cut up and remove rubbish from site Most materials will be supplied. Must have your own tools and be experienced with general carpentry/handyman finishing work. Looking for someone reliable who can complete the works neatly and efficiently.

3 sqm white render . around window

Water leak upstairs wet ceiling Gyprock. Needs redoing

Licensed Electrician – Sauna & GPO Connection Looking for a licensed electrician to complete electrical connection work at my home. I have already run and roughed-in all cabling/conduit from the sauna to the meter box, including the locations for the switch and GPO. Work required: * Connect dedicated sauna circuit to switchboard/mains * Supply and install required breaker/RCBO * Install isolator switch * Install 20A GPO * Hardwire 6kW Harvia sauna heater into the dedicated circuit * Test and certify installation All cabling and conduit have been installed; electrician to supply the required switchboard components and fittings. Must be a licensed electrician

cover about 58sqm of gyprocking, including coatings and filling

Repair the ceiling hole and paint the whole room ceiling. I have the prime and paint.

Looking for EXPERIENCED 2 person team to assemble the Vikara Epoch 3 sauna. Full construction manual available for exterior and interior. All items have been unpacked and are ready for assembly. Requirements is 2 people allowing 5-8hrs depending on experience.

Looking for a licensed electrician to update around 50 switches/power points in our home. We’d like to replace the existing switches with new ones that we have already purchased. All replacement switches, outlets, dimmers and fan controls have already been purchased and will be supplied. The job consists of: 27 switches / controls Narrow switches: * 5 × single * 9 × double Standard switches: * 1 × five-gang * 3 × double * 1 × triple * 1 × single Components: * 2 × fan controls * 5 × dimmers 23 power outlets * 23 × double power points In addition to replacing the existing switches, We’d also like to: * Add 3 new power points/switches * Install 1 new ceiling light Looking for someone experienced, reliable and reasonably priced. Please send through your availability and an approximate quote. Thank you!

Looking for an experienced handyman/render repairer to repair the damaged section of rendered wall shown in the photo and repaint the area once repaired. The task will include: * Removing any loose or damaged render/paint * Repairing and patching the damaged render properly * Sanding/preparing the surface for a smooth finish * Painting the repaired section to blend in with the existing wall We already have the matching paint. Tasker will need to supply all other materials required for the repair, as well as their own tools and equipment. Please only apply if you have experience repairing rendered walls and painting and can achieve a neat, professional finish. Please include labour and any required repair materials in your offer.

Due to change of the position of light and fan we require patch & repair of laundry ceiling. Tasks gyprock hole, sand and paint ceiling

Looking for a licensed electrician for a few small jobs in one visit: 1. Replace 2 existing wall sconces with new light fittings (new fittings will be supplied) 2. Install a new backlit mirror (power connection required) 3. Fix a double power point – one socket isn’t switching on All fittings/fixtures will be on-site and ready to go. Looking for someone with the right licence/certification who can provide a compliance certificate if needed. Category: Electrical Location: Allambie Heights, NSW 2100 When: Flexible – within the next week Budget: $300

We're looking for a licensed electrician to install a new power point above our shelving. The cable can be run down from the ceiling cavity directly above, so it should be a straightforward installation. We expect the job to take around an hour, and our budget is approximately $500. Please send through your offers. **Licensed electricians only, please** Thanks!

After someone to install small section of cornice. Today or Tomorrow morning Cornice onsite

Looking for an electrician to complete a small residential job in my apartment. The apartment was built around 2000, so the wiring is relatively modern and I don’t anticipate any major issues. Work required: Light switches and power points + two LED lights replaced, includes - * Replace 11 × double power points * Replace 1 × quad power point * Replace 6 × single light switches * Replace 1 × two gang light switch * Install 2 × two gang LED dimmer/switch combinations * Might need 1 × surface mounting block (bathroom) * Install 2 × new Martec Fino LED ceiling lights, replacing two existing LED ceiling lights (same locations, pretty much the same lights just a bit bigger, no new wiring required ect) I will supply everything, it’s Clipsal Iconic and I think the old ones are HMP: * Clipsal Iconic switches and power points * Martec Fino LED lights * Dimmers * Mounting block I’m looking for: * Licensed and insured electrician * Neat, professional installation * Experience installing Clipsal Iconic products and LED dimmers Preferred, not necessary though Photos of the existing switches, power points and lights can be provided if needed

I’m after someone to replace the gyprock in a bulkhead and wardrobe and then paint. Paint provided. Bulkhead is roughly 1400mm wide by 250mm high. Wardrobe section is 600mm by 1300mm

Render 2 bathrooms and patch other walls in a three bedroom unit in Narrabeen. We have stripped out the whole apartment and completed plumbing and electrical roughing. We now need to render everything ready for waterproofing and painting

Repair set and patch approximately 2 m² of Chiprock in a bathroom ceiling. No painting required. Just get ceiling set and ready to be painted.

Have two mirrors about 1.8x0.9 I need to get off the wall in the garden. They are mounted on add two bar mounting system. I’m able to help. I just need another strong guy to help lift it and get them both of the wall of the mounting hooks and take into the van which is all flat level surface. Strictly 1pm should be about a 15 min task

Rendering patch up under neath balcony to prep for painting. Repair x 1 tile on edge of balcony.

Looking for an experienced handyman to install a baby gate securely into drywall, bottom of staircase. The gate needs to be properly mounted into the wall (not pressure-fit), so experience with plasterboard fixings is important. It must be strong and safe for a toddler. - Install 1 baby gate (pictured) - Fix into drywall on both sides - Ensure it is level, secure, and child-safe - Use appropriate anchors (e.g. wall mates / toggle bolts / into studs if available) - Clean, neat finish