Find experienced local tradies in Collaroy NSW

I need an awning g or similar installed. Open to ideas..needs to setup the rain coming into the covered area (only occasionally happens). Needs to not look horrible also

Outdoor sauna 4 person Black cube pocket from SDS

Remove canvas window awning at front of house. X2

Gyprocking to small area of wall and crack in ceiling

I need some Gyprock and villaboard set and then sanded I need Photos attached off the stuff that needs to be set. All walls and ceiling will be sheeted, cornice is being removed wall needs to be square set/set into tiles There will be 2x recessed exhaust fans in the ceilings so need to L bead into the fans

Hi! I need a professional to repair a damaged internal wall. The existing render/skim coat has failed and is peeling away, exposing the brick underneath. I need someone to: Remove all loose/delaminated render Apply bonding agent Re-render/render patch (base coat + top coat) Sand and finish smooth ready for paint The damaged area is rough size, 1m x 1.5m but you’ll need to feather out a bit wider for a clean finish. Must have experience with rendering or plastering. Please bring all tools/materials. Flexible with day/time. Please include: Your experience Photos of previous work Your quote (all inclusive) Thanks!

I need an electrician to provide a quote to cut off power to several power points on a wall that is to be removed during renovations.

We demolished an old overhead cupboard from a walk in wardrobe and require help by a professional gyprocker to finish the job! Work required Finish removing all parts needed for a complete job Install gyprock (top section only if possible?) Finish and paint

50cm x 50cm patch job of ceiling. Removed a chimney and just need it patched up

Its to be dismantled and brought to Sth Hurstville and reinstalled. It is electric and 5.5 mtres wide. Installed at last picture under pergola

I need a wall gyprock wall set and sanded and a cornice installed. Materials not supplied. Wall 800mm wide and 2500 high. Need both sides done.

Install 2 x timber studs to extend a wall Adjust skirting board to suit Repair 7 x small holes in plasterboard ceiling and wall - Due date: Flexible

Hello, We would like to have a new clear glass balustrade installed on our balcony which matches our previously installed railing on the ramp leading to the balcony. Here are the details of what we require: -12 mm glass balustrade on two sides of a balcony. -Height of balustrade to be 1050mm off floor. -Long edge of balcony is 4648mm from edge of tile to wall. This would require 3 panels of suitable length. Three panels of 1500mm wide each should be suitable. -Short edge of balcony is 1475mm from edge of tile to the rendered post. So a panel of 1300mm wide should be suitable. -Stainless steel top mount rail that matches previous railing to balcony which is round 38mm diameter slimline top mount rail 316 stainless satin. -One corner of the top mount rail needs to be joined by either welding or joined together with 90 degree joint piece that can be attached with epoxy or welded. -The spigots (2205 stainless) should be similar to the previous spigots on the ramp, and are to be core drilled. So a total of 8 holes and 8 spigots. Attached with epoxy grout. -Railing to be bracketed to wall at both ends. -See red lines in photos to see approximate location of new balustrade required.