Find experienced local tradies in St Ives NSW

Install 4 x glass prints 40x50cm on gyprock wall and 2 x small/medium canvas prints on gyprock wall

Cover 4 openings from air conditioning unit not longer used. Size of the opening are 2 openings of 1500 x 200 and 2 openings of 1100 x 200. We will remove the curtains and vent covers prior to arrival. Plaster must be ready for painting.

Render small recess. About 4 sqm

Need a power point on the parking lot of the building, mainly for the EV car ,

Gyprock patch ups needed for approx 15 x 10cm holes in ceiling and walls from putting in down lights throughout my house.

I'm looking for a qualified and insured glazier to replace a cracked pane in a timber-framed awning window. Window size (approx.): 600 mm (W) × 1300 mm (H) Scope of work: - Supply and install replacement glass (to comply with current Australian Standards if required). - Remove and dispose of the cracked pane. - Reglaze and seal the window. - Ensure the awning window opens and closes correctly after installation.

We have some areas of our walls that need rendering. Perhaps a day's job

**Experienced Gyprocker / Plasterer Required – Outdoor Villaboard Pavilion** **Location:** St Ives, NSW 2075 I am looking for an experienced gyprocker/plasterer to complete the finishing work on two newly constructed outdoor Villaboard pavilion screens before painting. **Work Required** * Tape, bed and finish **2 vertical Villaboard joints** (each approximately 1.8 m high) * Sheets have been installed with an **approximately 5 mm gap** between boards to allow for proper tape and setting compound * Fill approximately **90 countersunk screw heads** (around 45 per screen) * Sand and feather all work * Leave ready for primer and paint **Materials Supplied** * Villaboard joint tape supplied * Large tub of filler / compound supplied * Structure fully built and ready to work on **Important** This is a feature structure within a recently renovated pool and garden area. I am looking for a **high-quality paint-ready finish** where the joints and screw heads are not visible after painting. Please only quote if you have experience with: * Villaboard / fibre cement sheeting * Joint setting and finishing * Achieving a professional paint-ready finish I am not looking for the cheapest quote. I am looking for an experienced tradesman who takes pride in their work and can deliver a quality result. Please Provide Phots of your work. Thanks Stephen

Please repair/replace the four damaged gyprock panels and two sections of the timber door frame/trim, as shown in the photos.

Replace a broken double power point in the kitchen A new replacement has been purchased.

Need help moving my 85 inch TV upstairs and mount to the wall - I believe it's gyprock. Please check if the wall upstairs is suitable. Photo of staircase attached. Price for labour. Please supply TV mount bracket AND sound bar bracket mounted to TV and quote extras.

Need a licensed electrician to install 4 new power points: 1. 1 new power point in the downstairs toilet room near the toilet for bidet/toilet seat use 2. 1 new power point in the ensuite near the toilet for bidet/toilet seat use 3. 1 new power point in the living room for a future wall-mounted TV 4. 1 new power point in the upstairs toilet room near the toilet for bidet/toilet seat use Details: - The upstairs toilet room currently has no existing power point, so please advise the best compliant way to install one near the toilet, possibly from the ensuite if suitable - In the ensuite, there is already an existing power point near the entrance, and I would like a new outlet closer to the toilet - Bathroom/toilet areas are tiled - Living room outlet is to prepare for TV wall mounting - Please advise the safest compliant locations for the bathroom/toilet outlets - Please quote labour and materials, and let me know if wall patching is included Must be completed by a licensed electrician. Please provide licence details with your offer.

I have a glass and aluminium balustrade on a first floor balcony. It needs to be removed, then once the concrete repairs are done put back on. (About 6 weeks later). The balustrade is about 25 years old. Before you give the final quote you would need to inspect the job. Thank you

The ventilation needs to go inside a cupboard, the wall is plasterboard and the rear of the wall is open space under the house with difficult access. I am trying to fix poor ventilation in the cupboard. The ventilation grill should have an insect barrier like this one (https://www.bunnings.com.au/builders-edge-150mm-white-grill-vent-with-insect-screen_p0811086)

Seeking a professional awning installer or shade sail specialist to replace the damaged fabric on a fixed curved metal frame over a residential courtyard. Scope of Work: 1. Site Measure & Inspection: Professional measurement of the curved "barrel vault" ribs to ensure a tensioned fit. 2. Removal & Disposal: Safely remove the existing ripped PVC vinyl and dispose of it. 3. Supply & Fabricate: Supply new UV-resistant, waterproof architectural material in a "Sand/Cream" color. Fabric must be seamed to fit the curved frame precisely. 4. Installation: Secure the new fabric to the existing metal frame using professional-grade tensioning methods (e.g., tech screws with load-spreading washers or aluminum tracking, depending on current frame setup). 5. Clean Up: Ensure the courtyard is left clear of debris. Requirements: • Must have experience with fixed-frame awnings or shade sails. • Must provide photos of previous similar "barrel vault" or curved installations. • Must bring own ladders/scaffolding (the courtyard is paved and level).

there are 32 holes showed in the photos, the cutover plates are placed next to the holes, patch them and get them ready to paint. also got about 28 holes after removing the power/phone/tv/vaccum outlet. I’m not expecting to get it done for $100, please offer the price.

Purchased an awning online. The product recommended installing on brickwalls, but we need to install them on timber. Product details here https://www.thebestbackyard.com.au/products/instahut-retractable-folding-arm-awning-manual-sunshade-3mx2-5m-grey

Need to patch and repair 5 holes in my Gyprock wall from sparky. I still have the pucs ( Gyprock)

Install additional 15A wall power point in garage on existing circuit.

Rendering on the wall/side of the roof