Find experienced local tradies in Chatswood

Looking for a skilled installer to source and mount a flat (non-corrugated) polycarbonate patio awning onto an existing timber frame structure. Awning dimensions are approximately 4.2 metres wide by 3 metres deep. Preferably durable, flat polycarbonate sheeting.

Looking for a licensed electrician to supply and install a faulty power point. The power point has two standard outlets plus one dedicated switch that connects to a wall heater. Preferred time is Wed 13th 8am-1pm.

I would like a licensed electrician to install a ceiling light, light switch for the ceiling light and a wall power point in my sunroom. I can only supply the light, you will need to supply everything else. Would like the wires to be hidden.

Repair of small indentation in hollow door (80mm x 60 mm) and repair of hole in plasterboard wall (300mm round) - Due date: Flexible

I’ve attached photos of a food trailer awning corner that needs attention. There is a crack in the aluminium composite panel at the awning corner caused by the awning load bearing on the panel rather than the frame. The internal frame appears intact, but the area needs reinforcement before delivery to a customer. Scope of works required: • Stabilise the crack (crack-stop + seal) • Install an aluminium backing plate or angle to spread the awning load into the wall frame (not the composite panel) • Check and adjust the awning bracket / gas strut load if required • Ensure the area is sealed and delivery-ready This is time-sensitive as the trailer is due for delivery. Please let me know if this is something you can assist with and your availability. Happy to provide any additional photos or details. Thanks, Lachlan

Install this awning on a brick wall (Suburb: Willoughby)

Help to dissemble 3 wall gyprock into bins provided

I purchased two aluminium frame awnings (4m length 1.5m projection) to be delivered to my house around mid to late December . I would like both to be installed side by side on the side over my 3m driveway. I prefer quotes from licensed builders or tradesman who have actual/first hand experience installing awnings or car ports, that I can verify on your Airtasker profile before I appoint you.

Patch holes in gyprock wall - I have bought the plasterboard patch (refer to images). Please provide quote

Need to install door jamb before plasterboard.

Power Libby to be relocated on brick wall. Would like it channeled into wall.

Prefer tonight or tomorrow before 2pm. Task: We have 6 picture frames (16 inch x 16 inch) from Kmart that we’d like to hang onto our dry wall above a console. We want it the frames to form a rectangular shape above the console and spaced apart evenly. I have 6x 3M Claw Hangers, however, they don’t work with the current set-up at the moment as the back of the picture frame is quite thick and the bezel doesn’t reach further than the frame hence can’t grip onto the hangers. To sort out your own materials to complete this task but feel free to use the hangers I’ve bought. Only professional picture hangers will be considered as need to be exactly even and hung safely.

Need to gyprock and set top of double doors and complete the edges ready for paint Roughly 1200x400 both sides. Customer is aware of vent above and advised it is not in use

Installed some soundproofing which had a peel off adhesive application. Over the years the adhesive seems to have gotten incredibly stuck. I've tried removing a few but evidently this is going to cause more damage. There are also two holes (different incident) which need fixing, if possible. I have a heat gun available to use if helpful. The task is to remove the panels photo'd, and fix the damage/clean the walls

Leakingf roof from 2yrs prior damage ceiling and was waiting to ensure leak was repaired before replacing. There were no leaks during recent rain so confident to move ahead. Would like supply and install new plasterboard to replace existing ceiling section damaged by prior water intrusion, including disposal of affected material.

I would like a licensed electrician to attend my two bedroom apartment and check over all the power points. There is one identified power point that is causing a short.

3 x lights need to be replaced to new oyster lights, I have the oyster lights, just need to be replace and installed Additionally 2 power points need replacement, supply materials needed please

Hi, we are intending to add a shoe cabinet near front entrance. To prepare the job, we need to cut out existing gyprock wall, cut is approx 2000mm length, height same as door, about 400mm deep; Install new timber studs and Gyprock wall to the rear.

Looking for a professional handyman to complete the following (Refer to images): 1. Curtain Rod Repair - The middle curtain rod bracket (1 out of 3) is loose due to damaged drywall (top part of the bracket screw hole is approx 5mm) - Likely needs a wall anchor or toggle bolt to secure properly after fixing drywall 2. Drywall Patch - Small dent in drywall from impact (approx. 10cm x 5cm) - Needs filling, sanding, and smoothing to make it look normal again (white like the rest of the wall). 3. Bookshelf Stabilisation - Screw 2 screws (5mm width) into existing holes to secure large bookshelf to wall. Must be correct screws for the drywall and hold in place properly. Note: There is a small gap between the angle bracket and the wall — may need spacers or appropriate adjustment to close the gap and secure properly. Prefer if you supply all materials but can negotiate. Should take around 1.5–2 hours.

Couple of chips appeared in the drywall after removing nonstick hangers that were used to hang up painting.