Find experienced local tradies in Epping NSW

Need someone to drill 8 clean 10mm holes through acrylic render into brick on a veranda pillar. Must have a hammer drill and experience drilling through rendered surfaces without cracking. 30 min job.

Looking for a licensed electrician to install a single power point (GPO) that I will provide into a kitchen island. Installation details: run cabling from the nearest wall power point, through a timber floor over concrete to the island. Property is a Strata apartment (Owners Corporation may require approvals). I need the electrician (or a carpenter if required) to advise on the best installation options, whether floor cutting or underfloor routing is feasible, and to advise on and arrange any necessary strata/owner approvals and permits. Please include supply of a certificate of electrical safety/compliance on completion. Access to kitchen and building entry will be provided; please advise if you need any specific information or strata documentation before quoting.

Need experienced plasterer to prepare interior walls ready for painting. Scope of works: * Patch holes, cracks, dents and damaged areas * Skim coat / smooth uneven sections where needed * Sand walls to a paint-ready finish * Leave area clean and tidy after completion Materials: * I will supply all plastering materials Requirements: * Must have own tools and sanding equipment * Must have experience with wall prep and plaster repairs * Attention to detail for a smooth finish ready for painter Please provide: * Your experience * Availability * Estimated time to complete * Quote for labour only Location: Epping NSW

Hi, I have a double power point in my kitchen that is broken. Looking for a licensed electrician to replace it with a new double GPO. I am located in Epping (near Rawson St). Preferably looking for Alan T. if available! Thanks.

Needing assistance with fixing and painting a gyprock wall

The front sliding door for built-in wardrobe is jammed. It can't slide anymore. The other sliding door works smoothly. Could any professional help to replace the rollers for the door?

Hi, I am looking for a quote to repair a hole in a plasterboard wall at my rental property in Epping. Details: • Size: The hole is approximately 14-16cm in diameter (caused by an accidental fall). • Scope of work: Plastering, sanding, and color-matched painting. • Paint: I don't have the exact paint code, so a color match will be required. Could you please provide an estimated quote and your earliest availability? I have attached a photo for your reference. Thank you, Hyerin

We had to damage the gyprock to put acquarium now acquarium we need to put the gyprock back in and paint

We have a section of rumpus room wall 2.4 metres long and 40cm high (from floor) that needs replacing. Easy rear door accessible

We had a builder cut into our wall to inspect mould (none found) and we have all the right things for patching it up however the almost 1m X 1m slab is only attached to one wooden post and will be uneven if we don’t get it reinforced behind it properly (will require a professional to do just the reinforcing, we can do the patching ourselves as we have the materials already. I imagine it would take a wooden plank or two behind it, some power drilling and done.

Drill and secure retractable side awning on concrete ground. 3m length.

power point socket is faulty

Need following repairs in the new kitchen area 1. Patch 3 plaster holes on walls 2. Plaster 90mmx2000mm hole under the benchtop. 3. Patch Cracks on the ceiling. Small area. 4. Install cornice on the ceiling for a length of 7 mts in the kitchen area. The cornice (New Yark 90mm) and gyprock items are provided by me.

I need a new 12 A power point installation near carport for my EC car charging. Proposed EV power point location is about 12 -13 meters away from main switchboard. In the attached photo, Circled is proposed power point location and switchboard is about 12-13 meters away in side wall...near red arrow. Also attached is photo is existing main switchboard.

I dropped a mobile phone on a kid's mat and it bounce and hit the wall and made a dent on the drywall. I need it fixed. Not sure about budget so the amount I have put there is just a guess.

Our balconies are north west facing hence direct sunlight throughout the day. Need a solution for that.

gyprock (plasterboard) ceiling for an area of 14 square meters.

Need someone to render this wall, its about 20 metre to 25 metre length and about 80cm high. There are some screws poking out that needs to be trimmed down. Please quote including materials.

I have a retaining wall and its about roughly 20 to 25 metres width x 0.8metre in height. I need someone to just smooth it out by rendering so the surface looks smooth. There are some screws poking out of the wall and need to drill it off too.

Paint external verandah 16mx3.5 approx paint supplied