Find experienced local tradies in Surry Hills

We have 2 built in robes (one in each bedroom) and are looking to have the interior fitted out with more functional storage (hanging rails/shelves etc). Looking for quotes to remove the current shelving and replace with a new fit out that we can discuss.

We removed a wall in our office, and have since moved back so need to make good and put the wall back. It is the wall between office 2 and 3 on this plan. No need to over engineer it, just done as simply and easily as possible.

Finish up this wall for a cleaner look with a plasterboard cover and white paint (lexicon half). The wall is ~240x150cm minus the washing machine hole.

4 hinged door melamine / laminex built in robe with mixture of hanging space, draws and open shelving.

* need bedroom built-in doors flipped around. Wrongly installed with handles inside rather than outside post painting * need window shutter put back onto window. Was not reinstalled by painter. May need to supply certain parts / hinges

Remove existing limestone render About 30m^2 of acrylic render across a few walls Frame up and gyrock around the house Plaster walls and ceilings and prepare for paint Install 1 door frame and door

We have 2 walls that need to be white set plaster and a ceiling to patch up. Thanks

We've recently removed a box in the bathroom that requires ceiling to be patched and gyprocked, and also wall sanded and painted. The patch is ceiling is approx 60cmx62cm. The bathroom was painted 2 years ago with lexicon quarter and ceiling white. This is a bathroom in an apartment building, parking available for cars under 2.0 metres. I can supply paint There are some bolts in the wall if you could also include or I'll get an angle grinder to remove them.

We need a qualified electrician to check 2x power points which are loose and change 1x globe

There is a small area on the ceiling which needs a light patch-up and paint

Looking for an experienced plasterer / gyprock installer to repair and replace sections of walls following damp remediation works. I attempted to remove some of the damp brittle gyprock Property is a Victorian terrace in Surry Hills, and some wall sections at low level have deteriorated and been partially removed. Scope of works needed: • Remove any remaining damaged plaster / gyprock where required in addition to another room that needs replacing • Assess and prepare wall surfaces (some areas down to brick) • Install new plasterboard where appropriate OR rebuild using base coat plaster (open to recommendation) • Patch, set, and finish walls ready for painting • Ensure smooth, flush finish to match existing walls • Reinstatement around skirting boards

Quote is to reassemble assemble sauna etc on Saturday

Small dividing wall in office needs end finishing, plastering holes, sanding and paint to nice finish . All is 4 m x 3.5m and it’s both sides and the end needs tidying up, as the guy who built the wall didn’t finish job properly - see pics

Pull down change rooms and patch up gyprock walls

Have a rebel home sauna and ice bath, both need to be disassembled as well as a bed. Assume hourly rate when booking, my assumption is that it takes 5 hours

Hi, I need someone to chip away all broken render and paint that wall + perpendicular wall in a cream white colour using exterior paint. I understand that after chipping away the render it’ll look patchy on the smaller wall, but that’s fine as it’ll be covered by plants. Exterior primer and paint to be supplied by you. Wall dimensions approximately; 4.51m x 3.5m and the other is 2.8m x 2.1m NEED DONE AND FINISHED ON MONDAY AT SURRY HILLS

New raked ceiling needs to be sheeted in 13mm gyprock, walls need to be sheeted in 16mm firecheck, and some small sections of sheeting to be done downstairs in aquacheck. Setting and sanding to be done on all gyprock. I will provide materials to be ready on site. I have scaffolding on site.

New gyprock ceiling insulation paint. Also 8m2 of walls to be painted

Need a small box built to cover an exposed pipe. The box will have two 90° corners, a vertical bulkhead to run around, and needs to join the bottom of the bulkhead. Photos of the piping are provided. The other part is a gap in the bulkhead that was an access point needs covering ready for painting. Approx. size for gap in bulkhead: 600–500mm. It’s not the one in the picture. Forgot to get a picture of this. Requirements: • Material: MDF preferred (gyprock may be needed for bulkhead section) • Smooth, paint-ready finish • Screw/fill and sand holes Skills needed: Carpenter / Drywaller with experience in small boxing or feature walls. Happy to pay for materials separately upon receipt.

Hi! Just looking for someone to fill the dry wall where we have nail holes and remove the projector from the ceiling and fill in for an apartment move out