Find experienced local tradies in North East Melbourne

x1 Power point needs to be fixed anytime we plug something its trips the main board

Need a plasterer to patch up hole cut in the wall and ceiling. Ceiling hole is about 1Mx1M and wall about 700mm x 1200mm. Job is in Heidelberg

Large, heavy artwork to be hung over sofa in lounge room. Walls are plasterboard.

Sand & repaint white gate and verandah white railing gate 2.2x1.8 and fence length 10.50

Garage front and back render Front pier both side right and left Polystyrene to front porch between piers back and front for smooth finish use 75mm or 100mm Two colour - colour scheme will be provided

Plasterboard repair required. Refer to picture.

Looking for an experienced renderer to apply a top coat to a 5m long single storey wall. The wall is sound, recoating to match other parts of the house. The area is at ground level and easily accessible. Looking to use Rockcote Coarse with oxide. Both will be supplied.

Repair of a hole left from air conditioner being removed and possibly one wall painted

I need a power point installed to the side of my timber kitchen counter. There is already a power point for the dishwasher underneath the kitchen counter.

Need to fix the low patches and low edges of new concrete, remove concrete stains on the exterior render skirting, patch up/paint the exterior renser skirting, and the. seal+paint 40 m2 of new and old concrete. I can share photos through chat or call.

I am looking for an electrician to change the power point on the wall in laundry and add a new one as well. So there will be two power points. One under the bench-top for the washing machine and the other on the splash-back.

So we have these exposed pipes in the room that is our office/spare room and i hate them. Looking for someone to build a white box around them...or even a shelf?

Supply and install 7 Double GPOs in a Vacant two-storey home - refer to photos, blue tape roughly where we’d like the installation 5 points upstairs (existing PowerPoint exists in each room) 2 points downstairs (below split system AC unit, and in front walk way) Note: I am repainting, so if you need to make small cuts in the plaster to fish cables downstairs, that is fine. I have the 7 Wall Plates (Clipsal Iconic) already. Will need to supply Cabling + Mounting Hardware. Must be a Licensed Electrician (COES required).

Supply and replace power point

I am building a plaster wall, I need the power point moved on the other side of the red line that I have marked up. Please advise if that would be cheaper or if better to just add another power point. Please quote for a complete job. This is in a factory with concrete walls. Minimal damage to concrete is required

Looking for someone to reattach this piece of plasterboard in our garage that has started dropping. There are also a couple of pieces of cornice to reattach. Doesn’t have to be a super perfect job as just in the garage. Just want to have it reattached and blending in to the rest. Please quote PER HOUR and how many hours it will likely take.

Installed mdf need professional plasterer to installl base coat and top coat sand

One corner of the fence the screw has come off

Part of an internal wall has been removed due to plumbing work and I need a plasterer to remove the remainder of the wall and replace the plasterboard on the whole wall. Wall size approx: 2950mmx230mm.

I need a small inspection cut made in my drywall/plasterboard to check for possible moisture/mould inside the wall cavity. Cut should be around 10–15cm square (enough to inspect behind the wall). Tasker will need to locate wall studs first to ensure the cavity section chosen is not on/near a stud. No need to patch/repair afterwards (just the cut and leave the off-cut piece).