Find experienced local tradies in Kew VIC

Tape and finish all joints Complete internal and external corners Approximate external corners 2x2.7m 6x3m 1x2.4m 2x1.2m 3x0.8m You supply materials, tools,etc

I need an electrician to install a power point on my bedroom wall (ideally recessed) and hang a “43 Samsung tv on the wall. The power fuse box is on the other side of the wall.

New external 3 pin single phase outlet, up nearer to awning motor. wiring to be internal behind brick work ( no external conduit) there is currently a plug at lower point on bricks as shown on photos

Lime hard plaster internal garage walls (ie water vapour permeable) Height 2500 Length (all walls) approx 24 lineal metres 3 internal corners Surface currently concrete render put on (?) 20 years ago. Photos shows patchy colour but water meter indicates most is low Photos show contents - these will be removed MUST be lime plaster

Detach the awning from my house and dispose. We are on ground level. Awning length is 5 metres.

Taking down adhesive wall hooks before moving out, I removed one wrong, causing the pictured bit of paint to come off, leaving an exposed area that could eat into the bond. Am keen to have this fixed if possible. 7-8cm long x 2 cm wide roughly

I am looking for a qualified electrician to help install two smart toilets in two separate bathrooms at my home. Both bathrooms will potentially require a new power point installed. I need to ensure that all electrical work and the final placement comply fully with local government regulations and safety standards. Toilet 1 - B&H Back-to-Wall toilet suite with a TOTO WASHLET requires a waterproof electrical supply. Will need a new powerpoint installed for this toilet located within reach of the WASHLET’s power cord, typically positioned safely outside the splash zone or discreetly routed according to Australian electrical standards Toilet 2 - Caroma Urbane II CleanFlush BTW Toilet Suite (Back Entry). Not sure if powerpoint in bathroom would be suitable. General Help in setting up. Plumber will also be in attendance. Photos below of 2 bathrooms.

Qualified trade person to install the retractable awning.

I need a certificate of electrical safety for my small unit one room one living one bathroom. Super small. Unit hasn’t had power for about a year or so. Just need this to connect the power again. Thanks 😇

Our curtains came out of the wall. We need a small amount of plastering done and the curtains re-attached.

We recently had done electrical work done and need some spot plastering to cover the holes left behind/channels created. We also need some repair/patching on an area damaged by water. Photos show the work required.

ABBOTSFORD: Power point on wall (20A) not compatible with plug on electric smoker unit (32A). Power supply is adequate, just incorrect power point. Smoker runs on 17A. Runs on a 25A breaker. Location incorrectly listed by Airtasker as Kew--this task is in Abbotsford, VIC.

I have a few holes I need patched up and sanded, before I move out. 5 sections total. Most of the holes are very small, however there is one bigger one (approx 20cm in width).

New powerpoints in living room, kitchen 4 in total

I have cracks in two walls (both side of each wall) and want them filled and sanded ready for painting. One crack is behind a king size bed which will need to be moved out of the way and then moved back.

Looking for an experienced and detail-oriented plasterer/painter to properly fix several patch repairs throughout a residential property. A previous tasker did this work but the finish is unacceptable — the patches were not sanded flat and the paint was not blended, so the repaired areas are clearly visible (uneven texture, trowel marks, mismatched sheen). Scope of work — all-inclusive: Inspect all affected areas (walls near door frames, wall corners, and ceiling line — multiple spots, photos attached) Where needed, scrape back / cut out the poorly done filler Re-apply plaster/filler properly and build up to a flush, even surface Sand all patched areas smooth so there are no ridges, trowel marks or bumps Spot-prime where required Repaint the patched areas and feather/blend the paint into the surrounding wall so the repair is invisible (no visible patch outline, no sheen difference) Requirements: Tasker to supply all materials, tools and paint Must colour-match the existing wall paint (low-sheen / matt white — please confirm or check on site) Quality finish is essential — the whole point of this job is that the repairs must NOT be visible once done Please only quote if you can do a proper professional finish; include examples of similar work or relevant reviews Budget: $300 (all-inclusive — materials + labour). If you genuinely cannot do a quality job within this budget, please let me know your realistic quote rather than under-quoting and rushing the work. Before payment: I will inspect the finished work in good lighting. Payment released once all patches are confirmed smooth and properly blended. Photos attached showing the current poor finish.

Install Roof Top rack for a brand new 4x4 and then install 270 awnings. All hardwares will be provided. During the process, we will also take videos. So it will take sometime.

Here is the pic and link to the awning manufacturer. It's Siena Awning, I believe it is the Standard Model. https://share.google/Zn9aSrvQ8l0D20NRs

Job suitable for newbie plasterer/handyman. I need a first coat of plaster applied to three walls (approx. 20 sqm total) to fill gaps between the bricks and slight levelling. All materials will be supplied. You are welcome to bring your own tools if preferred. Minimal prep and cleaning required, as flooring will be replaced. The job is expected to be completed on the same day (estimated 3–5 hours). Property is a ground floor apartment with private parking available directly beside the unit for easy access.

I’m looking for an experienced tradesperson to install a stainless steel wire (cable) balustrade on my internal staircase. Holes are already drilled and aligned