Find trusted local electricians in Kew VIC

I need to connect a cook top,rangehood and oven All the wires are there We just change the appliance just need to connect the new ones. Thank you in advance

There are 10 downlights in one of our dance studios that are buzzing and missing covers. They have a dimmer switch which makes the buzzing worse so likely needs to be replaced. I'd like these down lights to be replaced with LIFX Colour Down lights (that change colour). There is also one downlight in a bathroom that is flickering and needs to be replaced with a normal globe. Ideally not too white/fluorescent, but more warm toned. There are a few ceiling tiles with some stains/water damage and one that is hanging down a bit in one of the studio spaces that need replacing. Following the above tasks, dependant on cost, we may need some reconfiguring of other ceiling lights to make them more symmetrical and some re-wiring to have switches correspond to the different spaces better.

Existing switches need to be swapped out for new ones which i will provide. Price is per switch plate. There are approx 12 to be done. Price is all inclusive (gst + airtasker).

Hourly electrician work. Quoted first hour rest pay on spot

I need the current light fitting removed (third photo) and this light fitting (chandelier carcus) hardwired into the ceiling in its place (first and second photo) :)

Fix off connected duct bathroom fan Add timber to fan switch Thermostats relocation Intercoms Pier light Hallway sensor light 2 wire fix Etc Hourly based

Van review of electrical system

Fix electrical issue with light which doesn't turn on. Changed the globe but still doesn't turn on.

Two down lights not working. This has happened before with other down lights and electrician fixed it in about a few mins last time. Need someone to look at it for me. I can supply led light bulb. Just needs a repair.

Looking for a licensed electrician to install a ceiling fan, a pendant lighting and a led tube. The installer must be experienced and able to provide an electrical Certificate of Compliance.

Smoke alarm is needing new battery, high ceiling (3.1m high), I'm unable to reach with my step ladder

The location is in a garage. Need a 15amp power point fitted for a small single phase pottery kiln. about 2m from the fuse box. Images: Fuse box, Existing plug, Kiln

LED downlight not working despite replacing with new unit as shown

I have five light fittings to be installed. All are in celing. They will go adjacent to existing lights. Also have an electric cooktop I need installed . All the fittings are at my house.

Switch in picture has died. Needs to be swapped out (i will provide spare - box photo).

I have 3 blown LED downlights in ceiling, have replacement bulbs. Need someone who knows the trick on removing dead globe & replacing with new one.

Replace 2 hard wired smoke alarms

I need an electrician to finish the last bit of work. Wires already in. Just need to connect and Install cctv, two way bell, alarm system, finish some power point have not been done. Issue electricial certificate for occupancy permit.

Have a 2 door under counter bar fridge that has lost it chill .On hot days drinks are bearly cold , I did notice it last summer .

Kitchen fan failed It is a simple exhaust fan Alec style Approx 317 mm (approx) Please quote accordingly