Find trusted local electricians in Hawthorn North

- Route electrical cables through ceiling for workstation x 2 - add 2 power points on wall

Run a new socket to other side of room max 4m

Three jobs: 1. Install two pendant lights underneath a balcony into existing light sockets. 2. Swap the locations of two ceiling fans (move the quieter one into a bedroom). 3. Fix pendant in bedroom (water damage from upstairs bathroom about 6 mths ago). All jobs on site in Hawthorn. Ceiling fans and pendants supplied.

Hello wanna connect of this 4powder board 10amp and wanna install 32a around 27m away from the board I removed all so wanna connection back And coffee machine of this also connect

Stack F&P heat pump dryer onto 10kg front loader + level washer Hawthorn, Melbourne. F&P 428122 stacking kit already fitted to the washer — the frame is on, this is the lift and final fixing. The complication: rear brackets can’t be accessed in position. The machines sit in a corner with a shelf overhead. Job needs to be assembled clear of the wall, then the assembled tower repositioned approx 300–400mm back. Two-person job. Levelling: washer needs to be checked and properly levelled with locknuts set before the dryer goes on. No second chance once it’s stacked. Floor is mixed tile and old vinyl, uneven and soft in places. Please bring: appliance glide pads or skates (machines are on rubber feet — they need to be shifted foot by foot, they don’t slide), spirit level, shifter, ratchet strap, and a right-angle drill attachment or stubby driver in case the rear fixings are tight. Rear clearance of at least 20mm must be maintained — heat pump dryer, has had a thermal-related repair. Suit appliance installers or removalists rather than general handyman.

We require a qualified, currently licensed A-Grade electrician to install and connect a large premium custom sculptural chandelier. Current A-Grade electrical licence/qualifications must be provided before assigning the task. CHANDELIER Canopy: 1500mm L × 600mm W Adjustable drop: 1150mm Stainless-steel ceiling canopy Multiple suspended hand-blown clear & amber/gold glass elements Integrated LED lighting 6 recessed spotlights in canopy 3000K warm white + RGB mode Dimmable 220–240V / 50Hz Flush ceiling-mounted installation Full technical drawings and specifications supplied. SCOPE Securely install chandelier and ceiling canopy Check ceiling fixing point and electrical supply Complete electrical connection Connect/test LED, RGB and integrated spotlights Level and correctly position canopy Assist with assembly/hanging of glass elements as required Test all functions on completion Installation must comply with Victorian/Australian electrical requirements Experience installing large, high-end or complex chandeliers is strongly preferred. Please provide your A-Grade licence details, relevant installation experience/photos and confirm whether you are available Tuesday or Wednesday next week.

Install 2 small wall lamps above our menu wall • Check the existing power point/electrical connection on the front façade and confirm it is suitable and safe to power our new signage • Provide/connect power for an illuminated circular café sign • Provide/connect power for illuminated individual letter signage on the front façade • Make any necessary electrical adjustments so the signage can be installed and connected safely We realised there is already an existing power connection near the signage area, so ideally we would like to use this if possible rather than install unnecessary new wiring.

Looking for a licensed electrician for 5 small jobs: 1. Power point – Install 1 new power point (wall is currently open – see photo). 2. Bathroom exhaust fans – Reinstall the exhaust fans in the ensuite and powder room that were removed during plastering (existing connections are available). 3. Infrared heater light – Install a new infrared heater light and connect the required switch. 4. Ceiling fan with light – Install a ceiling fan with light in the living room. Existing ceiling connection/wiring is available. 5. Light fittings – Replace the existing basic ceiling lights with new light fittings in 2 rooms (existing wiring/points). Also reconnect/terminate the existing light wiring in 1 bedroom where the light was removed during plastering. All areas are easily accessible – please see photos. Budget: $750 Hawthorn.

Looking to complete two installation jobs. Job 1: Artwork Hang 1x large artwork (125cm x 155cm, approx 10kg) onto an internal brick wall. It has 2x D-rings on the back (must hang directly on two screws, no wire). Job 2: Ceiling Hook Drill and install 1x hook into the ceiling to hang a plug-in light fixture. Physical installation only, no electrical wiring required. I am unsure what the ceiling is made of (could be plaster, concrete, or brick). Tasker to bring an electronic stud finder / multi-detector to check the ceiling and ensure you do not hit any electrical wires or pipes before drilling. Hardware: Tasker to supply all necessary hardware (or advise prior what needs to be purchased), including 2x heavy-duty masonry wall plugs/screws for the brick wall, and appropriate heavy-duty ceiling anchors (bring options for both hollow plasterboard and solid concrete/brick ceilings). Please bring a hammer drill, masonry bits, and a spirit level. I can assist with lifting the artwork into place.

Need down lights installed at our shop.

Need to relocate a light switch & move 3 power points ready for plasterer.

Floor lamp stopped working

A power socket has popped out of place and needs to be fixed. Should be a simple job for someone who has the skills

Licensed Electrician Needed – Certificate of Electrical Safety We need a fully licensed electrician to attend a residential townhouse in Hawthorn VIC and issue a Certificate of Electrical Safety. The townhouse has been vacant for over 12 months and the electricity retailer requires a Certificate of Electrical Safety before reconnecting the power. This is for a residential townhouse. Please confirm: • Your total price including certificate fees • Your earliest availability We are looking to have this completed urgently so electricity can be reconnected.

We need a new Power point installed about 5 m from The Switch box

Security alarm going off without activating it.

My parents have had issues with their home wifi of which the current provider is Telstra through the Nbn and it is currently not operating at all. They have a Netgear Orbi system installed throughout the house as it is a large house and have multiple tv’s using Greek TV boxes, Sonos Audio which are connected to the internet and as such are also not working. I require someone to do some troubleshooting as to the reason why the connection to the internet through the Nbn is not working (they are using a 4g temp connection atm) as Telstra and Nbn are both not the best at providing solutions which is extremely frustrating so an experienced IT Technician would be most suitable for this job as Telstra techs came out and they are blaming the Nbn and Nbn is blaming Telstra. Identify fault, get system back up and running again ensuring, or I, tv boxes and Sonos are all working correctly.

I need a licensed plumber to replace our 3-phase Instant Electric Water heater. We have the new one already - old and new are pictured.

Need 3 downlights changed by electrician.

Install a conduit with a drawstring from the shelf (pictured) to the external front porch (circled in red). Preferably, this should be concealed within the ceiling.