Find trusted local electricians in Box Hill South

We have a factory being re installed into a factory in box hill south. We need someone to source and install 4 batton lights like in the photos to replicate what was previously there. Would need 2 visits one to rough in the cable and next to install the lights. Have existing lights to put back in. Photos are of the original office. We have the frame back up just now.

Looking for a qualified electrician to install 3 PowerPoint's and move the existing tv aerial further along the wall Box hill south location

Need help to replace smoke alarm A new FirePro 240V Mains Powered Photoelectric Smoke Alarm is provided

I’m a landlord seeking a licensed electrician and/or licensed gas fitter for a rental property in Victoria. This job involves safety inspections and minor repairs, with ongoing work available for the right tradesperson. Electrical Scope: Inspect all outlets, switches, and lighting for safety and functionality Replace cracked or faulty socket outlets Replace faulty or unsafe switches (including architrave switches if needed) Replace faulty LED ceiling lights Check or add earth tag connection at earth rod Provide compliance report Gas Scope: Inspect gas lines and appliances for safety and compliance Cap unused gas lines (e.g., near HWS) Inspect and repair/replace gas meter riser if required Diagnose gas appliances (heater or cooker), including minor repairs Provide compliance documentation Requirements: Valid Victorian electrical licence (for electrical work) Valid Victorian gas fitting licence (for gas work) Can quote for electrical, gas, or both Provide licence evidence before starting Provide photos of defects and completed work Issue compliance certificates Additional Information: Priority: safety compliance and proper documentation Quote should include labour, parts, and all fees Ongoing work available for reliable tradespeople Please include your availability and estimated cost in your offer.

Install 4x GPOs, batten light and switch in small backyard shed. Walls not lined, power supply in building next to shed, I will supply batten light. Pls supply double GPOs and switch

Replace faulty switch mech. and plate in WIR, Replace single power outlet to a double next to bed Replace "Main Switch" circuit breaker to provide overcurrent protection - up to 63A Cert of Electrical Safety

The smoke alarm keeps beeping , could be needs battery replacement or dirty or end of life , please find out the problem and then fix the problem so it does not beep anymore . The alarm is very hard to open so that’s why needs assistance . Please come and do the task after 7pm

I have a partitioned room and the light switch is not in the same room. The light switch is in the next room. I want there to be a light switch in the same room to turn on/off the light.

Lights in our house strayed flickering , power went off and came back up. Voltage is still low and unstable. Needs to be checked urgently. Right now.

Power point seems to be faulty.

I need plaster repaired around two electrical sockets on one wall It is a plaster wall and I do not need painting, just plaster repair

Need to install new wiring for my backyard. Just wiring before landscaping so can have the office pods installed later on next year.

Need an electrician to install outdoor PowerPoint at a garage shed.

Need a person to wall mount my TV unit. This would also include running the wire through plaster board so that it can’t be seen. It’s 75 inch TV

Install 3.5kw split system into backyard room. Single story, wall to wall, exterior unit mounted off the ground. New install (not replacement) needs to include all electrical works necessary. Room already has electricity installed.

Safety report to be done for lease. Electrical switch board to be upgrade. Smoke Alarm hasn’t been used for the past years so battery may need to renewed.

Remove the old on off switches and replace with new switches in a single level older house

I have an enclosed LED light that has stopped working and needs it replaced with a standard oyster-style fitting. All wiring is in place, just a change-over is needed.

Require a licensed and qualified Electrician to add more switches/powerpoints to existing switchboard for a Business/Warehouse. Require attendance tomorrow between 1-5pm. Please provide your quote.

The generator won’t start and we have tried to fix it but have been unable to. It’s a Gentrax generator that runs at 4.5KV, serial number GT6300. We are pretty sure there is a minor problem with the fuel line. We need someone to come in and fix it for us, we are flexible with the date and open to offers / questions.