Find experienced local carpenters in Alexandria

We have 3 x 22mm thick plywood desk tops that measure 1000 deep x 2200 wide. We need these cut down to 800 deep x 1500 wide. The desk legs can then be shortened and the table tops reattached to the tops. - Due date: Flexible

Replace damaged boards Sand and stain 10m2 - Due date: Flexible

Saw off the edge of a wooden daybed and make sure it can fit into the balcony space in our apartment. - Due date: Needs to be done on Thursday, 16 November 2023

The concrete front patio is tired dirty and needs to be cleaned. Am also looking for advice on painting or otherwise refinishing to make it look fresher. Looking for quotes - Due date: Before Friday, 8 December 2023

Hi, I’m looking to have my timber floors stained from a light to dark photo. The dimensions of the floors and stairs are: Floor space Total = 30 m2 Stairs 17 x Stairs (85cm x 33cm) The floors are currently polished in a light colour and would be looking to make them a very dark (almost black) matte finish. - Due date: Before Sunday, 12 November 2023

Remove existing water damaged skirting board to apartment bedroom. Replace with similar (or as close as possible)profile pre-primed skirting. Appropriately mitre all joints and allow correct space for carpet to be placed beneath skirting. Appropriately join to door architraves. Approximate lengths/dimensions and photo of existing skirting attached. Experienced carpenters only. Remove all waste and clean up. Cost of new architrave will be separately reimbursed. - Due date: Before Friday, 17 November 2023

Looking for a small angled ramp for my sausage dog to help her get out of our back door onto the balcony. Her little legs and long back don’t make for the perfect stair case enablement. I’ve attached pictures of our makeshift rubber staircase but it’s still very ridged and not comfortable. Open to suggestions on materials, but weather proof or treated wood would be preferable. Measurements are approx: Depth from wall/door: 400mm Hight from floor to door: 180mm-200mm Width of Ramp: ~ 600mm Thanks in advance! I’ve set a budget here but am flexible and understandably different materials and efforts will increase or decrease this amount. - Due date: Flexible

Needing two of these benches made out of ply-wood. Ideally finished the same. They are about 2m long, 40cm wide and 45cm high. - Due date: Flexible

After some thinking I decided to turn the wall removal into a proper renovation that will require construction skills, certified electrician involvement and some basic carpentry. Brief description of work below, please quote for an inspection and pricing only. - apartment renovation, 4th floor with a lift. Alexandria, NSW - new flooring (floor boards and carpet, installation only) and skirtings (approx 50sqm) - 2 x new stud walls (approx 5lm) - 1 x new sliding cavity door - relocation of 3x power points and an intercome, additional power point and lighting to be discussed - 3x ikea wardrobe put together - removal and disposal of existing flooring, door and wardrobe I’m happy to wait for the right person who will approach the task professionally and with care, but ideally to be done before Christmas.

Old wooden bench has a couple of pieces missing. I can buy the wood but do not have the skill (or equipment) to cut and fix in the right way. - Due date: Flexible

A wall in my apartment looks to have moved. The kitchen cupboards, kitchen bench and floor skirting have come off the wall. It is a plasterboard wall, so no cracks are visible. My strata had their builder state the damage is due to the age of the kitchen (15 years), not because the wall has moved. They said I need to get an engineer to confirm the wall has moved in order for them to be liable. Looking for an engineer to inspect if anyone can assist. If you can confirm it is building movement by the photos, even better (as that’s all that my strata did. Their builder did not inspect). I need an engineer with a company ABN to write on letterhead their view on why I have this damage. - Due date: Flexible

I am looking for a carpenter to install skirting boards for 3 bedrooms and the living area also, install door handles for the internal doors. I have the materials ready. - Due date: Needs to be done on Saturday, 21 October 2023

Build garden shed 900x 450x 1800 Have the door , make wood frame into concrete walls and make floor and roof . I’ll provide materials - Due date: Before Wednesday, 20 September 2023

We require a dowel timber wall, and wooden table top for our existing reception desk. This would include the following: - Creating the timber dowel for the reception desk (see link below) - Create a wooden table top, to place on top of the reception desk. This should have a roundover/bullnose edge. - Be at site to attach it to the reception desk The sizing is as follows: - 2x Side Panels: 103cm x 76cm - 1x Front Panel: 304cm x 76cm - 1x Top Panel (just a wooden plate, no dowel): 310cm x 106cm Thickness of these panels can be whatever is deemed reasonable (e.g. 2-4cm) See link below for instructions on what we are looking for: https://www.bunnings.com.au/diy-advice/home-improvement/walls/how-to-create-a-dowel-timber-feature-wall The photo attached is an example of what we want design-wise, but it would be a wooden tabletop instead. This quote also includes sourcing of wood. We would preferably want Tasmanian Oak. - Due date: Before Sunday, 1 October 2023

This timber window frame needs to be resanded/finished. It’s exterior and in first floor. There’s not access to window frame via the window. Will need tall ladder etc - Due date: Flexible

Install cupboard to walls. All drawers are Already pre-assembled. See pics below. Have 3 bedrooms. Just looking fr the price for one bedroom to assemble and instal wardrobe and desk - Due date: Needs to be done on Saturday, 12 August 2023

laminex Benchtop 68 cm X 170 cm Installers - Due date: Flexible

Looking for someone to make a giant Christmas Gift box for a campaign set. We need a 1.5 x 1.5 x 1.5m cube with one open side, and one removable side (5 sides in total) for someone to stand inside that can be turned onto the side. Ideally would be painted but not necessary. This will need to be assembled on set. There will be no weight applied to the box but would prefer for the wood thickness to be as thick as possible (2cm+ ideal) Happy to explore other materials as long as it can withstand the weight of people standing inside. We can arrange pickup if this is not possible. Happy with whatever material works best as we will likely get the outside wrapped in vinyl adhesive but would like the inside to be painted if possible and have a smooth look finish. Also happy to explore a slightly smaller size depending on wood sheet sizing availability. Please ask if you have any questions - Due date: Needs to be done on Friday, 11 August 2023

Need a Carpenter for window woodwork - Due date: Flexible

We need a photo wall built. You will need to supply the materials and build the wall on location in our photo studio. The wall needs to have wheels so it is mobile to move around the room. I have attached reference images of example mobile photo walls. Approx. measurements will be 3m wide and 2.5m tall but can confirm with the selected Airtasker! - Due date: Before Friday, 30 June 2023