Find experienced local carpenters in Stanmore NSW

Stanmore - Two cupboard doors slightly brush against the floor - need trimming/planing/adjusting circa 2mm

Remove sliding drawer and change to 3 x Blum soft close hinges

Please someone with a drop saw cut a 2.4m timber board in half. It is sitting in our car port and we can’t carry it up to our 3rd floor apartment without it cut in half!

Replacing kitchen cabinet doors (2) and kitchen cabinet drawers (4) made of pine wood laminated

Water damages to two kitchen cabinet doors and 4 kitchen cabinet drawers. Need them replaced

We have two areas that need mdf, plywood or villaboard installed flush with existing tiles thanks

Looking for a cabinet maker to do a design phase only for two internal cupboards. One utilities/pantry cupboard and one laundry cupboard. To be in melamine. Includes: * Concept design * site anlyasis * Recommendations * project evaluation * Material guidance, specifications & finishings * budget costings While this is the design phase only, the selected tasker should be able to build the cupboards if design phase proceeds to the next step.

ikea wooden bed frame. 1 post of bed frame has come unscrewed, need a drill to go in the side to secure it.

We’re looking for a skilled carpenter or experienced DIYer to supply materials, build 3 framed timber panels for a bedhead, and deliver them to Stanmore. Build 3 individual framed panels based on provided diagrams Supply materials, including: • 95mm x 45mm Structural Pine for the frames • 4 x lengths of 35mm x 45mm Structural Pine (used to join panels on site and fix to wall) • Pre-drill screw holes in the 35mm x 45mm lengths so they’re ready to be used as joining battens for on-site installation Finishing not required (we will be cladding separately). Delivery to Stanmore.

Job Details: To create and fit “L” shaped Stainless Steel Benchtop approx 3500x620mm. Backed onto Plywood, with an integrated sink and cut out for cooktop.

I am looking to have created a vertical tall cupboard or vertical buffet to store plates and other kitchen appliances in my kitchen space. It is essentially to be freestanding and will not be touching other cupboards or areas of the kitchen. Measurements are easy for me to provide of course and I’m hoping to have half of the cupboard/pantry as shelves and the other half drawers. It does need to have doors so as to keep everything neat and not be open. I’m happy to get a phone call and provide any further details and photos of the space. Look forward to a response when you have time.

Door on shed needs to be repaired. Wooden gate needs to have closure adjusted as it swells in wet weather and won't close. Picture rails to support pictures to be installed in at least one room.

Strip out shelves and desk from wardrobe. The full height joinery panel on the right will need to be retained, so careful removal would be appreciated. Shelves and desk are glued, but also screw fixed to the wall and RHS joinery panel. Carpet is being removed so no need to be precious with that.

Sand and stain kitchen floor

Need a carpenter to fix broken floor- boards and other work. I will pay $400 per day

1. Retrofit desk in place of cubby hole and drawers 2. Add shelf to 2 cubby holes

Around 6 doors to be planed after carpet installation

New microwave does not fit on wood strips in cupboard used for old microwave. Laminate lifting on cupboard trim.

Looking for a subby to help my team complete two hard wood decks

One wooden plank of flooring has a hole in it that needs to be replaced. I'm looking to replace only the damaged section, which is between the joists. The plank is approximately 14 cm wide, and the thickness of the wood (cypress pine) is about 2 cm. The length of the area to be replaced is about 2 feet (60 cm). The hole itself measures about 15 cm, but there's also a crack that extends from the hole, measuring about 35 cm. There is access under the house thru crawlspace.