Find experienced local carpenters in The Rocks

Hi, I’m looking for someone experienced in marble/stone benchtop repairs. There are some yellow stains on the marble benchtop, as shown in the attached photo. It appears that the surface protective film/coating may have been stained or discoloured rather than just having normal surface marks. I’m looking for someone who can inspect the benchtop and advise whether: the stained surface layer can be removed, repaired or recoated; or the affected section / entire benchtop needs to be replaced. Ideally, we would prefer to repair or restore the existing benchtop if possible. Please let me know your experience with this type of repair and your estimated cost. Photos are attached for reference.

Installation of cabinetry for hotel refurbishment in Darling Harbour ie wardrobes, bedheads or kitchens ( depending on skill level). All cabinetry will be supplied & delivered to the rooms ready for installation. 4-6 months ,5 days a week work. 4 installers required. Experienced installer or carpenter preferred Hourly rate negotiable.

Make a small cabinet using melamine or similar light weight material dark grey colour, front door with push opening, empty to slide over a solid for cover Measurements W: 500mm, D: 600mm, H: 610mm I have working drawings ready

We have a round wooden table, 185cm in diameter, in a meeting room that is quite old and has become sticky. We would like someone to sand it back, and re-polish it, please.

Setup one room office: build shelf set, drill pictures into wall, setup tv stand

Custom Wooden Inlay for Outdoor Countertop – Varnished Finish 📍 Location: The Rocks, Sydney NSW (Heritage-listed building) 📝 Job Description: We are looking for an experienced carpenter or joiner to supply and install a custom wooden inlay for an outdoor bar-style bench top. The surface currently has a metal frame with a plain inlay (approx. 4.5m long). We'd like a high-quality wooden top inset, finished in a darker, warm timber tone with a smooth varnished finish, suitable for outdoor conditions. Scope of Work: Site inspection to measure and assess Source and cut timber (e.g., spotted gum, blackbutt, or similar) Prepare and install into the existing metal frame (flush fit preferred) Sand, varnish/seal for weather resistance (ideally a satin/matte finish) Optionally, repolish timber deck boards if skilled and available Requirements: Experience with custom joinery or outdoor carpentry Ability to work within a heritage setting (non-invasive fixing preferred) Must provide examples of previous similar work Timing: Flexible but ideally completed within the next few weeks. Photos available on request. Site visit can be arranged.

Cabinet drawer screws have fallen out. Need to be reinstalled with 25mm 10G chipboard screws

Many shallow scratches on varnished French wooden table

Looking for someone to please assist in constructing a custom desk out of wood. Very simple design, no drawers or shelves . measurements (in cm) 85 H x 120 W x 62 D

I have a table top that needs fitting to a base. It’s a stainless steel top then a corian top on that. The table base needs 10 counter sunk threaded screws installed. They need to be tapped and counter sunk into stainless steel. Then the corian too needs glueing on. - Due date: Needs to be done on Sunday, 31 December 2023

Remove stain from wood and to treat it - Due date: Flexible