Find an experienced handyman in Bentleigh East

Hi, I need help fixing a wooden drawer that isn’t sliding smoothly and levelling/adjusting a bathroom door. Please let me know if you can do both jobs and provide a quote. Thank you

I need mount one camera to the outside wall of my house there three holes need to be drilled

Fix hole in plaster. Sand. Paint

Fix hole in wall with plaster, sand. Paint wall.

The sliding back door is getting very stuck and difficult to open and close. Looking for someone experienced with sliding doors to inspect and fix the issue. It may need adjustment, track cleaning/repair, or roller replacement. Please bring the necessary tools and let me know if any parts would be extra.

- Supply and installation of new, plain flat-panel white cupboard doors. - Replacement of all existing drawer fronts to match. - Approximately 12 cupboard doors and 8 drawer fronts (to be confirmed by measurement). - Preferably a matte or satin white finish. - Interested in a handleless design, ideally push-to-open mechanisms or integrated finger pulls, depending on cost. - Reuse existing hinges, drawer boxes and runners wherever possible. - Ensure any exposed cabinet frames match the new doors. - Close off some of the existing open shelving with matching doors, if affordable. Happy to use budget-friendly materials such as white melamine/laminate

Fly screen sliding door 80*202

To have my roller screen curtains placed back onto my sliding door window after l

Full installation of Kaboodle laundry cabinets, benchtop and full plumbing /installation of new sink and tap. Small room (longest part is 2080 mm). Hardware list and design/measurements of the installation are in the images below. Also require existing sink and sink unit to be ripped out and disposed of.

Update: Had a tasker assigned to the job, they have already mounted the side tracks. They had to travel because of a family emergency and are unable to finish the task. I need an experienced blind/shutter installer to mount two heavy, motorised outdoor zip blinds onto the solid brick face of my alfresco area ​Mounting System: This is a track-supported system. There are no top wall brackets. You must mount the two side tracks to the brick first, and then the heavy top cassette drops down into the top of the tracks. ​The Lift Height: The top of the tracks sit at 3080mm high. The main headboxes are very heavy and must be lifted over 3.1 meters high to slot down into the tracks. ​Equipment Required: You MUST bring a second person, a material lifter (like an SLA hoist), or a mobile scaffold to safely raise and guide the cassettes. ​The Surface: Mounting directly into the solid brick face. You must bring a hammer drill, masonry drill bits, and heavy-duty masonry anchors for the side tracks. (already installed, but may need adjustment for final installation) ​Electrical: Physical mounting only. You just need to route the exposed cables safely; a licensed electrician will be handling the hardwiring separately.

Front door isn’t operating as should. Doesn’t open properly gets jammed and handle seems loose and not aligned with latch

Drill 8 holes and screw in pull up bar

I need a new easyshed built, including anchoring to concrete. Looking for someone who has built these before.

I have purchased a new toilet seat that just needs to be attached

Install a supplied stainless steel roller catch - door is timber, frame is from aluminum. This is the part to be installed -> https://www.bunnings.com.au/legge-15211-heavy-duty-roller-catch-stainless-steel_p0190206

Just need a long ladder help me put chain back to roller need 4.2M Ladder

Looking to replace front door with a glazed door for more light. Standard door size 820x2040. Wanting to keep original door hardware. Open to offers

Two odd jobs: 1. Install new single roller blind (current double blind needs removing) 2. Install 3 floating shelves

We have installed a new in wall toilet and require the plaster to be finished off and prepared for painting

Needing some door frame repairs, painting, sanding and cleaning + nail fill in holes