Find an experienced flooring expert in Melbourne City CBD

45 m² hybrid flooring installation. Floorboard supplied. Need to remove the carpet and take the rubbish away.

Supply install hybrid flooring floor plan provided and the area you have outlined, the carpeted zones for replacement are the living area, dining area, and both bedrooms. Kitchen, bathroom, entry, and balcony are excluded. Calculated areas are as follows. Living 3.8 × 2.8 = 10.64 m² Dining 2.1 × 2.8 = 5.88 m² Bedroom 1 2.6 × 2.3 = 5.98 m² Bedroom 2 2.6 × 2.8 = 7.28 m² Subtotal (floor replacement area) 29.78 m² For supply purposes, carpet should always be allowed with a cutting and waste margin. Recommended allowance (10%) 29.78 m² × 1.10 = 32.76 m² Allow 33 m² of flooring for replacement.

Looking for a quote to get hybrid flooring installed with a soundproofing layer. The room is around 22sqm (5.5 x4) It has an existing carpet that would need to be removed. Preferably need someone certified as I have to get this approved by my building. I can supply the floor and soundproofing layer.

Install commercial vinyl stair tread overlays (high-traffic, water-resistant) I’m looking for an experienced flooring installer to supply and install commercial-grade vinyl stair tread overlays on an existing staircase. The stairs are MDF and were previously carpeted. Requirements / scope: • Supply & install commercial-grade vinyl stair treads • Suitable for high traffic and wet mopping • Non-slip finish required • Install matching vinyl stair nosing • Prepare surface by scraping loose fibres and sealing MDF with bonding primer • Secure with appropriate vinyl/MS polymer adhesive Staircase details: • Straight internal staircase (17 steps) I pay for materials separately

Looking to get new laminate flooring installed in 3 rooms (2 beds, 1 living area) in a Melbourne CBD apartment. Floors are currently bare concrete as previous flooring removed after water damage. Approximate sqm size of flooring needed is 34m2.

Hi - We need someone to do the following - 1. Pick up laminate flooring from West Melbourne. 2. Delivery to apartment in Lonsdale St Melbourne. 3. Remove carpet and dispose 4. Prep underfloor if needed - can be an 'extra' on top of the price. 5. Lay 3mm rubber underlay. 6. Lay 12 mm laminate boards in approx 40sqm(2 bedrooms and a living room. needs to be done in late december after Christmas, or early Jan(before 10th).

Supply, cut, and install timber laminate flooring in our new office. There is enough clearance below the door to lay on top of the existing floor. Unsure what laminate to use, but looking at something low cost - similar to: https://www.bunnings.com.au/hanwood-7mm-2-41m-doe-grey-laminate-flooring_p0381251 2nd floor, elevator and stair access - we are located on 220 Collins St. Total floor area is 28sqm.

I am seeking a quote for the supply and installation of water-resistant hybrid flooring at my apartment (Franklin St, Melbourne CBD). The work is to commence from 1st September (the apartment is currently occupied/booked until then). Scope of works: - Removal and disposal of existing carpet (approx. 3.3m x 2.4m living area) -Supply and install water-resistant hybrid flooring with acoustic underlay that complies with BCA minimum requirements (62 dB). Preferred options: 5mm Impacta Mat or 2mm Hush Platinum (or equivalent). -Installation of transition strips: --Between the new flooring and existing kitchen tiles --At the entry doorway to the common hallway (please advise if a special transition is required here). -Ensure works are carried out in accordance with Owners Corporation requirements: --Acoustic performance to prevent noise transfer complaints --No damage to common property (any damage to be rectified) --Works to be conducted during business hours only --All trades must hold appropriate public liability insurance If access arrangements are required, I will coordinate with the building’s Caretaking Team in advance. Please provide your quote and estimated timeframe. If possible, also confirm product options available and warranties on flooring and installation. If you can email or call me, I can provide further information such as a floor plan and photos to assist with the quotation. Thank you and I look forward to your reply. Kind regards, Philip Hosemans

install hybrid flooring to my new shop i got all the materials just 15-20 sqm

This is an office flooring installation job. The existing ground is a cement floor. Install 1216x196x12MM laminate and EVA rubber underlay and MDF scotia, total area 64 SQM.

Buying an apartment in the CBD....Exhibition Street...dedicated parking available...lift access to floor. Have about 45 square meters that I want to lay down new flooring. Flooring supplied by Kustom Timber. Black Japan plank 190x1900. https://kustomtimber.com.au/timber-product/black-japan/ Have vinyl flooring at present that I will remove before I take possession. Hoping to have installation completed before end of September after the new kitchen arrives. New flooring to go around the kitche. Now looking for quotes.

Require quotes for installation of new flooring in an apartment (located on St Kilda Road Melbourne). The area requiring flooring is approximately 45sqm (Bed 1, Bed 2, Dining, Living and kitchen). All existing carpet, underlay and grip boards have been removed and been disposed of. Concrete slab is clean and been filled where previous grip boards were removed. Depending on cost and timeframe to instal, I’d be happy to go with either: Option 1 – Install some variety of hybrid or vinyl sheet flooring. The bodycorp has been quite specific about the underlay needed (pre-approved underlay is the 5mm thickness CalmMat Acoustic Rubber Underlay). Option 2 – Install new grip boards, underlay and carpet throughout. The apartment is going to be a rental property so looking for cost-effectiveness, durability and timely installation. I am happy to source the products from a supplier if that helps save time. There is basement carparking on site (van size). I have some filler and caulk on hand (but will likely need some adhesives etc). Let me know if you need any further information to quote.

I am after a quote for floorboards for a 1-bedroom apartment. Require floorboards only in the kitchen & lounge/ dining area (carpet to remain as is in the bedroom). The total area I would want the floorboards in would be between 35 - 40 meter. If you could advise me on laminate and vinyl both - I would prefer the water-resistant quality. Also, the difference in price and quality for 5mm, 7mm and upwards. Any additional costs for carpet removal, furniture moving etc. to be included in the quote as well. This is for an apartment on St Kilda Road. I would need the spec sheet of the floorboards that will be installed, the quote to outline the scope of works, certificate of currency for the contractor doing the works. Thanks Saryu

I need to cover the living room area of my rental apartment with laminate floorboards But the landlord has requested I preserve the original carpet flooring as is. So I would essentially need to create a floating floor.

Looking for quotes to remove old carpet and replace with hybrid flooring and new carpet in a 2 bedroom apartment. Flexible with dates and time. Thanks.

We need some help laying some simple Bunnings floorboards which we have already purchased into a small shop approx 88 sqm in the Melbourne cbd . Must have experience and qualified.

In need of a labourer or apprentice to help assist a carpet layer on job sites. Job will include, assisting to move furniture around, sweeping and scraping sub-floors, vacuuming ripping up existing materials ect

HYBRID FLOORING INSTALLERS + LAMINATE INSTALLERS

INSTALL HYBRID FLOORING AND LAMINATES

Install the scotia around the skirting board through five rooms. approximately 80 Sqm. - Due date: Flexible

Professional floor polisher required to rid stain （cat pee), the stain must disappear and restored to original colour of floor，

I’ve had marble flooring scratched and I would like to get them polished

Requiring assistance in polishing living room area Flooring is made of engineered timber, can provide specifications for you to ensure it can be polished. Happy for you to come to inspect prior to works to make sure. Find attached floor plan, only living area to be polished.

Looking for an experienced floor board polishing specialist to sand a small space, remove marks and apply clear stain. Please quote for the full scope of works, so payment is fixed and no hidden extras. Thanks Lounge/dining/kitchen and hall. Boards are an engineered timber. Entire apartment is 100 square so estimate of timber floors is approx 50 squares. Floors only require a light sand, more photos to be provided next week.

Indoor 14.5m2 - Floor sanding and polish Outdoor 1.1m2 - Floor sanding and polish Works to be completed preferably past 3pm (commercial area) The floor is in generally good condition for sanding.

Hoping to get an estimate to do my kitchen floor, maybe 9m2. Should be fairly straight forward An epoxy floor is currently existing.

Concrete needs patch and repair, grind and seal. About 100 - Due date: Before Wednesday, 30 November 2022

Bar in Melbourne CBD. Approx 200m2.

I need sanding and polishing of floorboards in the lounge /kitchen area of the apartment on 27 Little Collins Street . To be done within a week. Price negotiable - Due date: Needs to be done on Monday, 4 July 2022

We have a pop up gallery on Little Collins Street, in Melb CBD. The floor (46sqm) is marked with shoe/stiletto marks and has notable dirt in places. The shop is a temporary pop up, a complete sand and re-polish not needed, but a significant and noticeable improvement on the current floor is necessary. See photos for reference. - Due date: Before Wednesday, 25 May 2022

Looking for someone to sand and polish timber floor with high heel marks. Approx area 30sqm. Must have own floor polisher/sander. Prefer to do it tonight as we need it for tomorrow.

I need to get existing floor boards sanded and polished in a kitchen area

Sand all 15 tables and polish them

Looking for some quotes for a bedroom. 2.8 x 3.2m. Polish existing slab and seal it. Similar to a terrazo look. Located in fitzroy. Ground floor apartment with street entry. No stairs or lift. Anytime before or after 14 April.

I need an experienced floor sander/polisher to fill, sand and polish this timber floor in Yarraville. Floor boards look like Baltic Pine and there is 13 sqms to be done. Will require a stain to go a couple of shades darker.

25sqm living room area timber floor. There are stains soaked in so it needs sanding + staining + coating. Maybe just half of the area as the rest are covered by sofa and carpet.