Find a professional internal door contractor near you

Doors need trimming on the bottom and hanging. Probably a parliament hinge and then door knobs. Which I can supply. Doors are now too tall since the floor was raised.

3x internal doors to trim and fit. Need help with installation of hinges, handles and hardware. All doors and hardware purchased already, and will be onsite. Can provide some tools (e.g. drill) if needed. No need for disposal of old doors.

Removing existing and installing 3 internal doors liners, doors and architraves. 2 standard door sizes. One existing door width is not standard: slightly wider than standard 686mm and shorter than 762mm, so new door liner will have to be installed over existing liners to make up for the gap. Would also need painting of primed door liners and architraves with soft sponge roller not brush to avoid brush marks. Fitting of handles including drilling holes etc. also required.

Fitting of 11 internal doors including handles and improving door frame where necessary

two internal doors needing re-hung: 1. living room door, re-hang to face inward, also need filling/ tidying up 2. entryway door, currently doesn’t close and think needs planing to size - probably quite an old door and opens to a quite damp room/storage area

I would like a quote to replace four internal doors

Internal doors need fitting including handles. 5 doors in total

A need a new door trimmed and installed into the door frame including handle, and a handle installed into a pre-existing door. I have the door and a handle but no saw, or other equipment/ fittings other then shown

Help hanging internal doors and fixing frames

Two internal door frame fitting. Beginnings of frames have been fitted. But rest of frame and doors need completing

It's a Solid wall. I'd like our current door closed up (green arrow), and a new doorway added further down the wall, and framed, ready for me to add my own French doors. Just like picture 2 (neighbours house).

Roman blind is replacing a slightly smaller one which has snapped. I have tried to fix, and even fit a new door handle, but i cant get the screws in or even drill new holes.

I currently have an internal door, which opens from right to left. However, due to the setup of the living room. I want this door to open from left to right. So, ideally someone to come with a drill and few other bits.

Need two doors taken down and two doors hung upstairs on two bedrooms also new handles to be put on . Doors are here already please note the doors height wise are a couple millimetres too much so will need to be shaved down slightly . I’m located in Milton Keynes and will be home for the rest of the week so pretty flexible please make sure you have the relevant tools and equipment for the job .

Had new carpet laid and the door is now too long. Just needs a bit planed off the bottom

Three internal doors currently fitted with hush keep latches that are not working and don’t secure the doors shut. Need them all fixing or replacing.

We have bought 3 new bedroom doors for upstairs. It will need trimming to size, as well as the new hinges and handles fitted. Then finally be hung up please. We will do the painting afterwards when it is hung up :)

One internal door in good condition

Remove broken internal door handle and install the replacement that I have purchased. Put up one shelf above radiator in hallway.

We have 13 internal doors we want to change the handles. All door handles purchased. 9 are standard door handles 4 are bathroom locking handles. We have got 4 Bathroom Door Mortice Lock - 64mm, that require installation in the doors and frame. We do not have the tools for this. Existing door handles have a backplate length of approx 119mm The new door handles have a backplate length of 174mm and a backplate width of 42mm, whilst the lever measures 110mm. Happy to answer any other questions