Find a professional internal door contractor in West London

Install 1 internal door,

Fix a dent/hole in wooden internal door

Fit four internal doors. One has glass panels the other three are all wood.

I would like 3 doors to be hung. One is on a partition wall with frame.

Internal door needs hanging. Will need to cut to size also

Total 3 doors 2 doors need to remove and put new one with lock Another door also need to remove, repair jamb/head and put a new one with lock

Door install internal door

Two internal doors to trim, fit handlesand latches and hang.

Internal cellar door handle has loosened and been removed. Need professional handyman to repair/replace so as to avoid further door damage.

We need 9 internal doors hung, and the handles/locks installed on them. They are oak and may need cutting to size a little.

Take off existing door and fit new door The door is a walnut pre finished door need to cut 3 hinges and hole for lock and handle May need to trim the bottom but not sure Location of job - Ub2 4ej

Install seven new internal doors including new handles, latches and hinges. New doors measure 2000x760mm but will need trimming to fit as required

Three internal doors need to be rehung/adjusted as they do not stay closed when there is a draught.

I need to block up an internal doorway, take off the architrave, block up the hole with plasterboard and plaster over it. We need new skirting board where the door has been. I also need two small areas of cornice replacing in the same room where there has been some electrics replaced.

Trim and hang x4 internal doors. Also added handle ls to all

Internal door handles Change bathroom cabinets Hangto kitchen cabinets And some small jobs around the flat

2 internal doors correct widths...need hinges chiseled on doors and handle hardware fitted and shaved at bottom

I need someone to fit my bedroom door for me as I have no clue how to do it/what is needed

Have 5 doors plus handle need fitting.

I need someone to fix this door so it closes and stays closed. I have bought the handles and fittings already. There are then more similar potential jobs.