Find experienced local tradies in Paddington NSW

I'm looking for an experienced gyprocker/plasterer to supply and install plasterboard in a small room, as shown in the attached photos. The building is brick construction, and the intention is to glue the plasterboard directly onto the existing brick walls and fix plasterboard to the ceiling. Scope of Work Supply all required gyprock/plasterboard and installation materials. Deliver materials to the property. Install approximately 30 m² of plasterboard to the walls, glued directly onto the existing brickwork using a suitable method. Install approximately 15–20 m² of plasterboard to the ceiling, including suitable fixing to the existing ceiling structure. Install and finish all corners, joints and edges. Finish around the window opening, doorways and other wall openings with appropriate corner beads and trims. Set all joints and corners, apply joint compound and sand the surfaces to leave them smooth and ready for painting. Leave the work area clean and tidy upon completion.

1. Installation of a lightweight aluminium gutter kit for an outdoor awning, 2.8m long. Requires fixing of supplied rivets and screws, coring of the colourbond gutter for the downpipe and glueing/fixing of pvc fittings to ground. As the awning is adjacent to an alumium pergola, so 2-3 louvres may need to be removed to access the awning properly. 2. Fixing of 2 x brass house numbers to the front wall of the house. Needs drilling into brick and services check 3. About 8 x coat hooks (each with 2 screws) to be installed throughout the house, some behind timber doors, some into brick in the hallway. Services check needed for the hallway 4. Fixing of a 20m hoselink hosereel in the front garden. Will require 4 x drill holes and services check 5. Fixing of 1 x small aluminium ikea outdoor cupboard on top of an identical one. We will assemble the unit, just need help to fix the top one to the wall.

Hi I require a renderer to render a wall and patch up another. Wall is 2m high x 4m long and patching up is bottom of walls where garden beds used to be approximately 6m x 500 height

I’m looking to have someone repair and re-render a small facade which is approximately 3000mm high by 5500 mm wide. Note that part of the facade is already painted and the area across the top to the garage door is marine ply. I have a few length of corner bead on site.

Install a frameless standoff glass balustrade using materials I supply on site. Balustrade is located more than 5m above ground level, so it must be installed and certified to AS 1288 / AS/NZS 1170 by a suitably qualified and licensed tradesperson. Materials on hand: • 15mm frameless standoff glass panels: 850W × 1280H ×6, and 750W × 1280H ×3 • Summit 30×21mm Nanorail Deluxe handrail 5800mm (satin) ×2 • Summit Nanorail Deluxe rigid glazing rubber 2900mm ×3 • Summit 30×21mm Nanorail Deluxe wall plate extended (satin) ×6 • Summit 30×21mm Nanorail Deluxe 90° joiner (satin) ×1 • Glass standoffs 38×25mm (satin, SS2205) ×48 Note: fixing rods are NOT supplied — please include any missing items in your quote. Scope: • Labour-only install of the above into the existing structure, glass 15mm toughened with Nanorail top rail fixed into structure • Confirm supplied standoffs and fixing details suit 15mm panels for a balustrade above 5m per AS 1288 before commencing • Flag anything missing or any recommended change to the fixing approach prior to install • Provide a Certificate of Compliance on completion from a licensed/qualified trade, expressly noting the balustrade is more than 5m above ground Requirements: • Appropriate trade licence and insurance — please state licence number • Quote labour only; advise availability and lead time Site: inner Sydney. Please confirm you can certify to AS 1288 at this height before quoting.

Looking to supply and install NCC compliant Paddington lace balustrade. 4200mm long piece 820mm side piece

Hi there Request the removal of some peeling plaster, then to replaster and repaint of the following areas: 1. KITCHEN - remove the peeling of the old plaster above the kitchen sink and replastering. Would like to discuss options for the bulk head beam over the sink area which requires replastering. Replaster pillar in kitchen near the light switch and rear walls (2 areas) facing the outside car port. Would like to get a quote for painting the entire kitchen area (including the ceiling) 2. LAUNDRY - remove peeling paint on the rear wall and repaint 3. MIDDLE BEDROOM - remove peeling paint and repaint wall Many thanks Kind Regards Andrew Urquhart My details Andrew Urquhart

Hi everyone, I’m looking for an experienced painter/waterproofer to quote on patching, sealing, waterproofing and painting an exposed rendered wall on my property. Job Details: • Wall size: Approx 6 metres long × 3 metres high (the grey area) • Surface: Grey unpainted cement render and timber header/aluminium flashing (the section clearly shown in the attached photos – not the painted brick wall next to it) • Location: East facing wall, accessible from neighbour’s property • Condition: Multiple fine hairline cracks across the render. There is also evidence of a small amount of internal water ingress, likely coming through the joints or cracks. • Required work: • Thorough cleaning of the surface • Repair and patching of all cracks and any loose render • Proper sealing and waterproofing using a breathable system suitable for exposed rendered walls in Sydney’s weather • Apply quality exterior masonry paint (colour match vanilla ice cream paint colour adjacent) • Keep all existing weep vents clear and functional Access is from the corrugated iron roof below. Please confirm safe access and any height equipment for agreement from the neighbour. Photos attached (3 images showing the wall from different angles). Please reply with a detailed quote including: • Total price (incl. GST) • Scope of work and recommended products (especially the waterproofing system) • Preparation steps • Estimated timeline • Any warranty on the waterproofing and paint • Your experience with similar exterior render waterproofing jobs

My salon ceiling has water damage and a small section around a downlight that has cracked. The ceiling will likely need the damaged plasterboard cut out, replaced, patched and made ready for painting. Photos attached. Ideally someone who has experience with ceiling repairs and downlights. The leak has already been resolved but the ceiling now needs repair. Location: Paddington. Please quote including materials if possible. We have the paint available on site.

Wall mount a 60 inch Samsung tv on a gyprock wall, will require stud finder

Mounting 1 x LG OLED 55 inch TV to plasterboard wall, PLUS mounting 3 x paintings (< or = 5kgs ea.) to plasterboard wall. You will need to supply all the necessary specialised hardware (hooks, screws to hold TV wall bracket) and have all the tools to complete the job.

We need an awning replaced at a bookstore in Paddington. All tools and ladder will need to be brought, we have the awning here, it’s needs attaching to the pole. We’d like it done today if possible. Please let us know asap!

I need the ceiling repaired from some water damage. 3 distinct areas of damage - see photos I just want to repair damaged areas. Will need to include painting as well The whole ceiling is 4x3.5m

I need to mount a base for an indoor clothesline, but the area where it needs to mounted has been patched before and isn't strong enough to hold it. I need a new piece of plasterboard about 300mm x 300mm to be inserted with some internal backing to serve as an anchor. Unfortunately are no internal studs in the area around where this is going to be mounted.

Roughly render an outdoor bench seat that has been built out of bessa blocks and concrete. Need: - rounded edges - slight fall on seat so water runs off - sandy finish Need: - Rounded edges - slight fall on seat surface - acrylic render with sandy finish

An outdoor small awning (2x2.5m) to be built & installed in courtyard.

I own a small retail store and need a few tasks done today. I need a sign drilled into the store front and then we have an old black awning and I just got a new pink one I’d like to replace it with. Will need your own tools and ladder

Re-render some of the walls and render the trim of flower bed / patio

Wood/ timber expert to match a missing timber stairway balustrade (see photos) if not via the Airtasker ecosystem suggestions are most welcome.

We have a indoor sauna that needs the glass door hung/installed with the brackets. We’ve tried to hang it ourselves and can’t quite get the alignment correct so that it fits properly in the doorframe. Photo attached. It’s similar to hanging a glass door in the shower to a fixed glass panel.