Find experienced local tradies in North Bondi

I was installing a TV bracket when one of my power circuits started tripping. When the breaker is reset there's an audible "popping" sound, strongly suggesting a drill bit or screw has caught a cable behind the wall. Breaker is currently isolated and labelled off. What I need: • Diagnose and confirm the fault • Repair the damaged cable to AS/NZS 3000 standards (accessible junction box or rerun as required) • Insulation resistance (megger) test the circuit afterwards to confirm integrity • Issue a Certificate of Compliance for Electrical Work (CCEW) Site details: • Switchboard: modern Clipsal MAX9 with individual RCBOs per circuit — the affected circuit can be fully isolated without disturbing the rest of the house • Strike location: behind a heavy-duty articulating TV bracket. A light switch directly below the bracket suggests the cable is on a vertical run from that switch • I can remove the TV and bracket before you arrive, or leave it for you to drop — happy either way • ⚠️ Important: the wall is finished in a bespoke Monaco Grand Prix poster wallpaper that cannot be easily replaced or matched. Please plan to make the smallest possible access cut, and factor minimal wall disturbance into your approach. I'll handle wallpaper/plaster make-good myself afterwards. What I need from your quote: • Licensed electrician only (please include licence number) • Breakdown: call-out, labour estimate, materials, CCEW • Whether you'd splice in an accessible junction box behind a flush cover, or rerun the cable to the nearest accessible point • Earliest availability — not urgent but want it sorted this week Happy to send through additional photos of the bracket, switchboard, and likely strike location on request.

Need a tradie with public liability insurance to install my ANKR bike anchor to an outside masonry wall. Please confirm you have insurance in offer.

Fix drywall please - kicked it in sleep and need to replace it before moving out. There is renter friendly wall paper over the top of it currently

Need a simple plasterboard patched in my hallway. It either needs to patched, or cutout and patched. Hole/dent is roughly 10cm. No painting

Several smaller areas requiring patching and matching (as close as possible) to existing. Can do this as lump sum or happy to pay per day rate for skilled labour

Patch 2 Gyprock / Drywall holes (1 small around 4cm diameter, the other is around 30cmx20cm). In addition to reattach curtain rain which has been pulled out in 2 places from ceiling. I have the paint required to touch up

An old home intercom system has been removed from next to front door and on stairway leaving 2 holes. They need to be filled, gyprocked, patched and painted. I have the paint but I have no other material - I do not have render / gyprock materials etc

We recently have had new timber awnings put on the exterior of our house. Which need painting today or tomorrow. We have all the paint and painting equipment and ladders. The awnings required two coats of paint. I believe this is a 4 hour job. The cost showed here is for 4hours of work at $75 an hour. Can you please respond with your availability today and tomorrow to complete the work. Images are attached. Thank you for your time.

I have a small area behind an outdoor sink on a balcony that needs to be cement rendered it is approximately 1 metre x 1/2 metre. all the rest of the balcony was done but this was missed because of the sink being connected.

Regan's blind, reattach cupboard door, small plastering and painting

Front porch needs awning removed and replaced. Will provide measurements shortly but see photographs for details. It’s a little old and rusted. A straight replacement is fine.

Remove power point and make safe for wardrobe installation.

My Bosch oven is displaying Error code011. The manual says this is because a button was pushed in too long.(It was). It can be fixed by switching the oven off at the power so that the oven resets. I am not strong enough to pull the oven out by myself and need someone to do that for me so that I can reset the oven as suggested. It would be great if the job could be done on Monday afternoon. I can provide a parking permit for street parking.

Need outdoor wood sauna built - all parts have arrived just need it assembled

Retractable baby gate needs to be rebolted onto gyprock wall

It’s only one power point (left) out of the two that’s not working. The rocker switch for that one has been a bit dodgy/floppy (no click when switching from on/off) since we moved in, but it worked fine. Until now. Photo of the switch we need is attached, although we are happy to purchase this ourselves online unless you already have one. Note: there is a light switch in the middle that is in use so it needs this switch

I currently have a built in wardrobe. The interior needs to be removed ( it is currently bookshelves, a desk and drawers). I would then like an IKEA or Bunnings ready-made shelving unit to go into the carcass. Shelves need to be 40-50 cm wide. Would suit a joiner, carpenter, someone familiar with built in wardrobes and assembling ikea/ Bunnings flat pack things.

Looking for someone to build a built in wardrobe for a master bedroom. Wall is 3.5m long x 2.8m high. Open to hinged or sliding doors Also open to not completely built in since ceiling so high Have attached photos of a mock up of the type of style I’m looking for but open to suggestion

I need an installation of a 15amp power point.

Tidy up some patched holes in plasterboard walls and repaint to match existing wall finishes. Probably 10-15 patches in total. Should be about 2 hours work. Will supply the paint to match existing walls. See photos or patches that have been completed