Find experienced local tradies in Elsternwick

Need a licensed electrician to inspect and replace a cracked kitchen power point. It previously buzzed once and had a burning smell, but is currently no buzzing, smell or heat. Please inspect the wiring for any damage/overheating and replace the power point.

Looking for an experienced carpenter/handyman to supply, replace damaged boards, and restore our L-shaped front verandah deck. 1. Board Replacement: Supply and install approx 16 linear metres of 80mm Jarrah decking boards to replace rotted/damaged sections. Remove and dispose of old boards. 2. Deck Clean & Restoration: Clean/prep existing and new Jarrah timber (approx. 21m² total area). Apply 3 coats of Feast Watson Black Japan finish (TBC).

Timber post supporting my upper level verandah has rotted at the base where it meets the planter box and garden bed. Need the rotted section cut out and a galvanised post stirrup installed so the post sits clear of the ground. Scope: - Prop the beam above while working - Cut out rotted lower section of post - Install galvanised post stirrup - Splice in new treated hardwood section to match existing - Fully seal and waterproof: treat all timber ends, seal the stirrup base, and ensure the planter edge is watertight to prevent any future moisture ingress - Touch up paint to match (paint will be supplied) Important: - Post is structural (supports upper floor), so please confirm you're comfortable with load-bearing repairs. Located in Elsternwick, easy side garden access.

Scope of work: -Supply and install a 15A weatherproof outdoor GPO (IP-rated, suitable for outdoor use) -Switchboard is located internally and less than 5m from proposed location of GPO (on opposite side of meter in photo) -Install on external wall under verandah (protected but still exposed to elements) -Ensure circuit is suitable for continuous EV charging load -Upgrade circuit/breaker if required (please advise if additional costs apply) -Test and ensure safe operation Requirements: -Must be a qualified and licensed electrician (VIC) -Must provide a Certificate of Electrical Safety (Compliance Certificate) upon completion -All work must comply with Australian standards

We have a few areas on the ceiling that need to be patched and plastered up so they look neutral with the rest of the ceiling. 6 areas

To complete the plastering of the skylight well. I can supply all materials. Dimensions are approximately 600mm x 1000mm

Replace approx 6m x 1.7m garage ceiling plaster to exposed joists after plumbing repair works. Surface to be ready for painting. Available material for use: - 3x Gyprock CSR 3600 x 1200mm 10mm 4.32sqm Plasterboard RE - 100x 6G x 3mm plasterboard screws - 1kg stud acrylic Screws have been removed from joists. Area under works to be cleared prior. Plan is for Knauf Sheetrock 55mm Plaster Cornice Cove (or similar) to be installed after then area to be painted (not included in this quote).

Place wood panel securely to then drill 2 holes to hang 20kg mirror onto gyprock wall

I need a licensed electrician to install a new power point on the wall shown. The only existing outlets are inside the laundry cabinet above the washing machine and are too far for the automatic cat litter box. Standard plasterboard wall. Requirements: 1. Supply + install 1x double GPO 2. Flush finish, no exposed cabling 3. Must be compliant + licensed

I have damage to a ceiling panel and it needs to be cut out and replaced. Please note: No painting required, just plaster work only. Ground floor, Easy access Panel size is 1440x980mm See attached photo for review and please let me know if you require further details. With thanks Pete

I need to get additional power points. Power point exist, just need to move locations. Photos below. I don’t need the wall patched. Just need the electrical point moved. Will get someone else to patch it up.

Installation of 3x 2x1m DIY awnings kits onto 3x separate sections of brick wall approx 3m high. Each kit has 3x brackets. I'll be available to assist if required as it looks like it'll be a two man job.

I need to move my barrel sauna (Revel Eden 4 person model) into a new location within my back garden. The sauna weighs around 330kgs and needs to be moved across about 4 metres of grass (without damaging grass) and then placed into a certain location that is slightly elevated (10-20cm). Could potentially use a pellet jack or open to other ideas.

Need help to instal this cabinet as this is heavy and seems like a 2 person job, but i am happy to help. I have bought Ramset Countersunk DynaBolt Plus Masonry Anchor for this job. 600mm wide cabinet in small bathroom.

We run an existing cafe and are looking for licensed, experienced tradies to help bring the space up to full council compliance standards. This is not a full fit-out — the cafe is operational — but we need assistance identifying and completing any minor works required by the council to meet health, safety, and building regulations. Possible tasks include: • Plumbing adjustments (e.g. installing/relocating a hand wash basin, grease trap checks, drainage fixes) • Electrical updates (e.g. safety switches, correct placement of outlets, lighting compliance) • Ventilation or exhaust system improvements • Fire safety compliance (e.g. exit signage, fire extinguishers, fire blanket installation) • Surface updates (e.g. applying washable finishes to walls, sealing floors) • Any other minor maintenance or updates required for compliance We’re ideally seeking tradespeople who have experience with food premises and council inspections, and who can either assess our current setup or act on a list of required changes from a prior inspection. Being able to provide compliance certificates where applicable is a must.

Looking for an electrician to add a power point to the wall for washing machine connnection. Already a power point in laundry but need an additional one

Reframe timber to create opening and re plaster. Opening approx 1000 x600mm.

Looking for someone to install a new outdoor (waterproof) power point outside next to hot water system. Internal electricity shown in the 3rd photo with x’s

I would like a quote for a 4m×2.5m electrical half-casette awning installation which needs to be installed in my garden. It will need an electrical connection to be made and mounted. There are downlights on the eaves of the garden, so the awning needs to be installed above it, being possibly mounted on the roof tile area

I’ve got a small hole needing to be filled under balcony of the unit above. Could you help in filling, smoothing it, then painting over?