Find experienced local tradies in Sydney Eastern Suburbs

I need to run a connection from the living room space to two locations with ethernet jacks. 1 port one floor up directly above the living room. Another one 5 rooms away. Both cable runs could go long the outside of the house if in wall/roof or floor cabling is difficult. (If networking is your thing, you could connect a basic mesh system or ubiquity but I'm happy for just the cable and wall plugs to be installed. The house is brick. I'd also like a powerpoint installed directly opposite a powerpoint on the other side of a brick wall.

Need to just replace a power point in the kitchen, if we can get this done tomorrow that would be great. Cheers

Cut out and patch / set 2x vacuum duct ports and 1x controller (light switch size). I will provide Gyprock sheet, you are to provide all other materials.

We have a planter box around the terrace (see pictures), it was waterproofed some years ago (perhaps 5-7 yrs ago, not sure) but is now leaking again (we filled it with water and confirmed it is leaking). The job is to: • Remove the existing rendering (and the parts of the membrane that are still on it) at the bottom and on the sides of the planter box • Redo the rendering at the bottom and on the sides of the planter box Someone else will then re-waterproof on top of the render. Supply all material, cleanup the site after and take away the old render / rubbish The planter bed size: • Surface of 6.75 m2 (bottom) + planter bed walls • L Shape of 6 m x 2.5m - 45cm wide • Walls of 60cm height.

I need an area of gyprock installed on ceiling and around door frame. The lights have been removed. Also join at kitchen to be repaired Mew frame might be needed 1.2m x 2.8m + 1.2m x 2m

Window Tinter or Tradesman needed to apply blackout film to three windows in the master bedroom. As per the images, we started to do this ourselves but were not able to finish the job as it requires two people and a 3+ metre ladder. The highest point of window is approx 3.5-4 metres high. The ladder is only needed for the larger window which is approximately 2 metres high and 4 metres in length. The blinds may need to be removed and then screwed back in as the film needs to cover all of the window (especially the top section) so no light can come through. The job will only take approximately 1.5 - 2 hours. Black out film is provided. Need someone ASAP.

we have removed a portion of a wall and need the edge rendered, height approx 2.7m and edge is one brick thick. need done asap

Patch 2 Gyprock / Drywall holes (1 small around 4cm diameter, the other is around 30cmx20cm). In addition to reattach curtain rain which has been pulled out in 2 places from ceiling. I have the paint required to touch up

We have already done a base paint to the wall but I want it to look “rendered”. I’ve attached a photo of what I want it to look like. The photo is also attached of what it currently looks like.

Install plasterboard to ceiling cutout Height low 2.4 Area to fix about 2 m2 Street parking ok

Dismantle / demolish a large 6 door built-in robe . Size approx 3850x 2750 . Robe built onto the walls, no back panels. Has internal shelves , hanging and drawers . Take away all rubbish .

Have recently repaired a roof leak and now need one sheet of gyprock replaced. The opening itself is about 600x400mm but would prefer a 2400x1200mm replacement.

Install an RCD Power Point in my meter box.

Instructions: 1) patch hole on ceiling with gyprock 2) cut out section of return air box to allow air flow into the unit 3) cut in and install 45x45 man hole into patched section to allow for access to the unit in future if required

Hi. I need a handyman to fix a small hole (maybe 7-10cm big) in gyprock. Can you please give me a quote? Ideally, I’d like this done tomorrow but I am flexible (this weekend is good too). Thanks! I also need someone able to light sand and paint.

I purchases two of these aluminium awnings which I need installed above my external solar battery in the side lane of my house. Size is 0.8m x 1.2 m https://www.carportsandoutdoors.com.au/products/aluminium-bracket-awning-white?variant=49021840064819

I’ve recently had some exterior walls finished in acrylic render and need them painted. Total area is around 70 sqm. Also need the back deck lightly sanded and coated with teak oil. Please quote for 1 day’s work only (labour only) at this stage. Materials will be reimbursed separately. Details: • Painter to supply paint, teak oil, and materials (I’ll cover cost on top of labour). • Two paint colours to be colour-matched to existing finishes. • Single-storey home with easy access. • Work needs to be completed this week. • Preference for experienced painters/handypeople with photos of similar work.

We’re looking to have someone (likely 2 people) hang an 3Mx2.5M awning outside. It weighs 300gs/m and will be going into our concrete wall.

Looking for an experienced renderer to complete a small job this Friday (weather permitting). Scope: • Render both sides of a small garden wall (approx. 2.4m long x 1m high) • Render one side of another garden wall (approx. 6m long x 1.5m high) • Total render area: around 14–15 sqm • Existing double-brick walls, clean and ready for prep Finish: • Smooth or light-textured cement render suitable for exterior paint • Include waterproof additive • All materials, prep, and cleanup to be included Access: Easy access, outdoor area, hose and power available. Timing: Prefer Friday, but flexible for weekend if needed. Please include examples of past work and confirm if you can complete this week.

Install a TV bracket on a rendered brick wall in a bedroom. It is to hold a 32 inch tv.