Find experienced local tradies in East Melbourne

Weld balustrade together, currently in three sections and needs to be cut & welded so can be installed on front porch. Welds to be ground back flush at completion.

Install wire balustrade on granny flat staircase, 4 steps in total, on both right and left side. On the landing and staircase handrail

We have a small portion of the ground floor ceiling that had a water leak. There is some water damage to the ceiling and cornice an also some holes that were cut to find the source. I’ve attached photos. We have paint to repaint but could also do that ourselves if preferred

Our sauna is not turning on it needs to be reset but the wood cage needs to be removed (with allan key/ screw drivers) a sauna clean would also be great but not essential

Hi there I wanted to get a quote on installation of walk-in wardrobes and built in wardrobe units purchased from China for my new build. All diagrams and directions are available to assist with assembly.

The verandah is floor is timber, tongue and groove, L shaped and 26sqm. The job is to punch the nails (some nails on the outer edge are sitting proud) and then sand the verandah (sander must have dust bag) ready for sealing.

I am replacing an old built-in oven and need a licensed electrician to assist with electrical work. Tasks required: Disconnect the existing hard-wired oven connection inside the oven cabinet. Install a proper 15A oven power point inside the oven cabinet so the new oven can plug in. Check and replace one wall power socket (double power point) that makes a buzzing sound when a power board is plugged in. Details: • Existing oven: Electrolux 60cm built-in oven (approx 3.1kW).• Current oven connection is hard-wired with a taped connector behind the cabinet.• The new oven will require a 15A plug connection.• Oven cabinet depth is approx 560mm.• Please install the oven socket inside the cabinet (preferably rear corner) so the oven can slide in fully. Also one wall socket nearby produces a buzzing sound when a power board is plugged in. I would like it checked and replaced if necessary. Requirements: • Must be a licensed electrician• Please bring required parts (15A oven power point and standard double power point if replacement is required)

Need to render some external brick of front of house 3 poles External fence front Garden bed front

We need a new Power point installed about 5 m from The Switch box

Professional pleaster required to : 1. Backfill and plaster 3 x wall and 1 Ceiling hole ( Plasterboard supplied ) 2. Ceiling joint repair, requires cut out and plaster 3. 2 wall scrim repairs ( photo's not clear ) Plaster Finish to be Level 4 rpreperation for painting

Impact damage on dry wall, need to be replaced. 50x 60 cm

I’ve recently extended an existing 6m rendered planter box wall by approx 350mm in height using a timber frame and blueboard. I’m looking for an experienced renderer to render the new blueboard section so it matches the existing rendered finish and colour (Paperbark) as closely as possible. Scope of works - Render newly installed blueboard / lightweight wall section only - Match existing render texture and colour (Paperbark) - Small, tidy job. About 2 sqm. - Easy access and clear work area - Estimate half day work Requirements - Proven experience rendering blueboard - Supply own tools and materials - Neat finish required to blend with existing wall Timing - Urgent – ideally within the next few days

(1) Remove and cap off 2 power points and 1 outdoor light in carport which are both not functional (2) Remove and cap off isolation switch for heater. Note, switch is not functional as heater has been removed (3) Cover exposed wiring to power point in bedroom (4) Install fire seal to switch board

I’m looking for a professional to measure and quote for custom internal aluminium flyscreens for multiple awning windows in my home. Some windows are in the kitchen and bathrooms and have internal winder handles, so flyscreens will require custom cut-outs. I may proceed in stages, starting with key windows first and adding more later depending on the quote and workmanship. Please quote per window and advise on mesh type for different areas.

Need a plasterer for a couple rooms in a townhouse. Pics attached. Message me for more info

Need assistance with removing roof rack and x2 awnings from my house. The roof rack and awnings are already off the car, but will have trouble disposing of so need assistance with this. The roof rack is from a Land Rover Discovery, and the 2 awnings are approx 2.5m long Pic of the rack and awning when on the roof

Replace power point in bath room and light fitting in hall way

Patching and plastering multiple holes and damage on a plaster wall ready for painting. Can provide materials or reimbursement for materials.

Install 32 a plug in garage. approximately 10m from power box. Single storey house on a slope as shown in picture, tiled roof, subfloor access. You supply all materials required for the job. Price inclusive of airtasker fee, GST.

The damaged area is around 2ft x 1ft. Need it repaired asap. Help can be given.