6 Roofing Contractors in Richmond

Hi, we have a two storey building with a rusted out 10m length section of guttering. The building is built to its site boundary so to repair it from the street would require a boom and traffic management. Frankly a big ordeal for meters of guttering. So thinking laterally, I'm looking for a switched on roof plumber or carpenter type who can help work out the best harness points, fix them to the timber structure and use them to either replace the gutter or just patch it up membrane materials. Open to ideas here. Thanks in advance.

Need a plumber to replace the existing down pipe (pictures attached). Current downpipe gets hit by cars driving by and pops out of place. I’d like to replace it with something more secure and something that does not rust as easily as the current one. Would also like to check the box gutter that keeps overflowing every time it rains.

The studwork is already in place, and just needs a piece of corregated iron or other roofing material outside the exterior back door, to provide shelter from rain for people entering or exiting building. And fixing / bolting onto the studs. I've run a quick tape measure and it's going to be approximately 150 x 135 cm - but would be a good idea if the person views and takes their own measurements also. Address is in Richmond. It's the back of a high end sex shop for women, so the person will need to be sufficiently open-minded and professional. I'm not sure how much materials will cost, so please feel free to post your fair cost to do, and to provide materials. The owner will be there on Monday between 11 am and 6.30 pm. Other times may be possible if you let me know when you are proposing. I will be there today teaching from 2 to 4 pm, so could potentially be today.

Need an old valley gutter removed and a new one fitted. This job involves removing the refitting the valley gutter tiles. The removing a piece of gutter that is holding a lot of water and refitting it on the correct angle with the proper grade of clips.

My roof is leaking and needs to be fixed. Two storey house. Most probably a tin roof.

Hi I need to mount 12 square x (30cm x 30cm) foam panels on my home office wall for soundproofing. Since it’s a rental flat they need to be mounted with command strips so wall is not damaged. Need to be aligned perfectly with desk and at appropriate height. Must have previous soundproofing experience.

I am looking for someone to extend downpipe along flat roof to the next box gutter downpipe. Images attached.

I need someone to come replace approximately 400 nails with roofing screws on a flat ground floor roof in a Richmond house. I will supply the nails and the drill.

In high winds, the whirly bird rattles and sends noise directly into a bedroom. Hopefully only requires a few screws into the roof to secure it.

I need a handyman to assist with repair of Cleaning of roof gutter and handle fixing. I do not need any replacement parts. Additional notes: Ladder required and tool box/screwdriver This task was created using a Template. You can still ask questions and make offers as you would on a standard task.

Roof gutter on 2 storey house rattling. Needs to be glued or cemented. Also some roofing sheets were not screwed down properly by the same roofers that installed the gutter.

Rivet/ seal top flashing to the sky light, Secure flashing left side of the sky light, Take apart cappings in flashing and seal/rivet, Seal over cap/flashing two chinneys, Reattach with anchors step flashings, seal the wall, and paint Clean two box gutters, and paint with antirust paint, Alter one spouting to instale spreader.

2 leaks on tile roof boxed gutter backs up too easily

Install waterproof sheeting/plasterboard as needed and tiles in a kitchen. Once tiled, install 2 x IKEA pot hanging racks. Finish off with any edging / beading as needed. We will supply the tiles, you need to supply everything else. Area is approx 1.5m x 600mm.

There is already a frame in place - it would need batons to be laid to lift the laserlite so it drains into gutter. Approx area is length 2m x width 3m. I am assumming suntuf solarsmart 2.4M lengths would be the roofing material - that retails at 37.50 a sheet so 4 sheets would probably cover the area - so I am guessing materials would be about $250 all up. So supply of materials to be included in any offers please.