Find an experienced plumber in Albert Park VIC

JOB: Splice hot water line & run to outdoor shower SCOPE: • Existing Thermann continuous flow HWS (installed & operating). Splice into hot water line and run new line ~20m to outdoor shower location — approx. 75% along house exterior, 25% underground via pre-dug trench. • Relocate existing garden tap and tee cold water supply (existing line accessible) to same area. • Route includes several bends around the house • All piping insulated per AS/NZS 3500.4, UV-protected above ground, lagged and sleeved through the underground section. STAGING: • Stage 1 (now): full pipe run, rough-in to fixture location incl. capped tee, pressure tested. • Stage 2 (after deck construction): fit-off outdoor shower system, commission, verify 50°C delivery. SUPPLY & SITE: • Plumber to supply all pipe, fittings, insulation and consumables — quote to itemise materials. • Trench pre-dug by owner. QUOTE TO INCLUDE: • Materials and labour itemised, with Stage 1 and Stage 2 labour separated. Licensed plumber required. Photos of route and fixture locations available on request.

One of the taps (ad also the drainiage are leaking in the bathroom basin. I have removed all parts - and changed the o-ring, but leak is still occuring.

Plumbing two bath rooms and a laundry

Bar water tap and kitchen jet cleaner to be fixed

Unclog kitchen sink so it drains properly. Baking soda + vinegar trick no longer working

4 taps need to be change in 2 bathrooms

Fix my leaking tap. WaterMark brand leaking from middle, see photo.

We have a slow block in our toilet which links to shower. It drains but very slow. Believe it needs an auger to clear it.

Hi. I’m looking for someone to help with a few small maintenance jobs (photos attached). • Screwing in a door handle that has come off • Screwing in a cupboard handle that has come off • Fixing a toilet seat that is loose/has come off • Fixing a shower head that is loose/has come off

Task: Fix a continuous low-volume leak running into my toilet bowl from an in-wall concealed cistern. The System: • Brand/Model: Viega Prevista 80mm Slim Concealed Cistern (with Bowden cable actuation). • Toilet Pan: Flaminia (back-to-wall/wall-hung). Current Status & Diagnosis: I have already diagnosed the issue and partially disassembled the toilet. The leak is caused by a degraded rubber flush valve seal (bottom washer), which has also left some black/brown sludge at the bottom of the tank. • I have removed the outer push-button faceplate and unclipped the green and grey Bowden cable blocks. • I have turned off the water supply at the internal brass isolation valve. • I have completely removed the internal fill valve and disconnected the braided flexi-hose. • Current state: The central flush valve (with the yellow base and dark grey top) is currently unseated but wedged diagonally inside the tank window. I cannot get the clearance to pull it completely out. What I need you to do: 1. Extract the wedged flush valve assembly through the access window (no tiles need to be removed). 2. Supply and fit a new Viega flush valve seal (typically part #786137 or 8310.20, but please confirm). Note: I will reimburse you for the cost of the seal separately upon presentation of a receipt. 3. Clean the black rubber sludge/debris from the plastic seating ring at the bottom of the tank to ensure the new seal sits perfectly flat. 4. Reassemble the flush valve, reinstall the fill valve, reconnect the braided hose, and reattach the Bowden cables, cover plates, and faceplate. 5. Turn the water on and test to ensure the leak has stopped. Requirements: Please only make an offer if you have experience working with slimline concealed cisterns (specifically Viega or Geberit), as the access window is very tight.

The hexagonal connector is burred and I am unable to take the tap out and replace the washer so I think I need a new garden tap it’s a 10 minute job

I’m just looking for a quote before booking in, these taps are worn out, there is no gradual increase or decrease in pressure for either temp, it’s either all hot or all cold depending which is turned on first, would prefer to replace with a mixer if not too expensive

My fridge can be connected to the water supply for filtered water and ice. Nearest water supply is 1.5m from fridge. Access ideally under floor boards. House is on stumps.

I need my dishwasher serviced today.

We urgently need a licensed and registered tiler with shower waterproofing experience to repair a leaking shower in our apartment. A plumber has already inspected the issue and confirmed: • No pipe issues • The problem is a failed shower waterproofing membrane • Shower will likely need to be pulled up, re-waterproofed, and re-tiled Why it’s urgent: • Leak first noticed 7–8 days ago • Assessed by a plumber 2–3 days ago • Over the last few days the issue has escalated • Water is now affecting the apartment below (leak through ceiling) • Vinyl floorboards in our apartment are lifting due to water damage Requirements: • Must be a licensed & registered tiler • Proven experience in shower waterproofing • All relevant qualifications & registrations required • Not looking for a handyman — qualified trades only Timing: • Job needs to start ASAP • Ideally Wednesday or sooner

Hi! I need help fixing a leak coming from my fridge’s bottom freezer (Melbourne). Water is pooling on the floor and I checked it’s due to a frozen defrost drain. The fridge itself works perfectly otherwise. What I’m Looking For: • A technician or someone experienced with fridge/freezer repairs • Ability to clear/repair the defrost drain

I need the this old toilet cistern to be replaced

I have a leaking kitchen tap that needs repair.

When using our upstairs shower, water leak through downstairs ceiling. Plumbing work is needed. Also need to install a new shower head and mixer tap.

Water keeps running in toilet