Find an experienced handyman in East Sydney

Looking for an experienced handyman to assist with a few small maintenance jobs in my apartment: 1. Laundry cupboard doors The two cupboard doors are no longer closing properly and do not sit flush together when shut. I suspect the hinges may need adjusting, repairing, or replacing. 2. Toilet seat The toilet seat has become loose and needs tightening. 3. Shower tap The shower tap appears to be loose and does not fully stop the water flow unless it is tightened excessively. Looking for someone to inspect and fix the issue if possible. Please bring any basic tools you may need. Ideally looking for someone with experience in general household maintenance and minor repairs. Location: Darlinghurst area, Sydney Please provide your availability and any relevant experience when making an offer. Thank you!

2 d roller blinds; 1 x 2.1, 1 x 2,4 to be installed in a house

I am looking for an experienced and meticulous handyperson to hang a gallery wall consisting of approximately 15 frames of various sizes in my apartment. The Space: The gallery wall is located on a sloped wall in a loft space (above a staircase). The wall height slopes from approximately 2.7m up to 4.5m. Because of the incline and the height, you must have the appropriate equipment to safely complete the job. What You Need to Bring: 1. Adjustable/Staircase Ladder: You will need a ladder that can safely operate on carpeted set of 10+ stairs to reach the highest points of the wall (up to 4.5m). 2. All Hanging Hardware: I am providing the frames, but you will need to supply the necessary hanging hardware (hooks, wall anchors, screws, or heavy-duty picture hanging strips). The frames range from small (30x40cm) to large (60x90cm), so please bring a variety of weight-appropriate hardware. 3. Tools for Precision: A laser level, measuring tape, drill, hammer, and any other tools required to ensure perfect alignment. What I Will Provide: 1. All the framed artwork ready to be hung. 2. A specific layout plan/blueprint showing exactly where each frame goes. Important Note: Precision is key for this job. The layout requires exact spacing between the frames to look right. Please only make an offer if you have prior experience hanging complex, multi-frame gallery walls and have the specialized ladder required for this space.

1. Internal Door Adjustment * One internal door does not lock properly when closed. * Door appears slightly misaligned and needs adjusting so the latch catches correctly. 2. Front External Door Repair * Part of the front door frame/panel is deteriorating due to age and material is falling out. * Area needs to be filled/repaired, gap-filled where necessary, and painted. * Only the repaired section requires painting. 3. Bedroom Windows – Possible Water Ingress * Swelling/damage visible above both bedroom windows. * Needs inspection to identify where water may be getting in and repair as required. 4. Ceiling Gap Filling * Black dust/debris is falling through from the ceiling area. * Gaps/cracks need to be sealed/fillled to prevent further debris coming through.

Install and wall mount IKEA BESTÅ TV unit (floating install) Assist with clean cable concealment and positioning

Need experienced plasterer/gyprocker for wall joint setting and finishing in older Rozelle cottage. I have removed the horizontal timber battens/join strips from the internal walls. Looking for someone experienced to: - Pre-fill gaps - Tape long wall joints - Apply 2–3 coats - Feather out nicely Feel free to provide additional cost for sanding/paint prep Materials already purchased: - Gyprock Paper Jointing Tape - CSR Gyprock Base Coat 45 - Gyprock Less Mess Topping Compound There's around 50 lineal metres of joints to fill Please include: - Your day rate or estimated total cost Location: Rozelle NSW

“Installation inspection and AS1851 tagging/service for a new extinguisher and fire blanket.” Install a brand new FirePro 4.5kg ABE fire extinguisher. Two hole bracket ( already here ) to be drilled into masonry wall. Extinguisher and Blanket have been purchased and ready here for you to install. Proper certification to provide to strata management. Drill provided if need be. Shop is a small 30sqm cafe space. No gas or deep frying - just a kettle and a small induction cooktop.

I am replacing the roller blinds in my kitchen and bathroom so will need the existing ones to be removed and the new ones installed

I need a very simple shelf made to fit this sink in my back room as a kitchenette. It's an usually angle so need measurement and sizing up Please send me your quotes

I want to install a shower hob (prefab or otherwise) to help redirect the water in the wet room setup of my bathroom. The floor undulates so I want to do this to ensure water from the shower only goes down the shower drain. Looking for an idea on pricing and timing for remove of shower screen, hob install, waterproofing and tiling, reattach shower screen

Location: Flood Street, Bondi. Toilet seat has become loose and needs to be secured

Install a 1.5m curtain rod and hang curtain (both on site already) & install some led strip lighting under booth seating (on site already)

I need someone to replace my door handle on my back door and replace my lock on my letter box.

Install ring cam into brickwork above front door

Replace door Jam, hang door, install ahndle and lock

Install Securiguard SHS1K Safe ASAP 🔧 I’m looking for someone experienced to install a Securiguard SHS1K safe as soon as possible. The safe needs to be securely anchored into a concrete floor inside a wardrobe. Installer must supply their own tools (masonry drill etc.). Anchors are already provided. Safe details * Model: Securiguard SHS1K * Weight: 18 kg * Dimensions: approx 260 mm × 200 mm * Fixing holes: 10 mm pre-drilled mounting holes * Installation surface: concrete floor inside wardrobe * Anchors supplied: Ramset AS1060W AnkaScrew masonry anchors * Requirement: secure compliant bolt-down installation Location: Darlinghurst NSW Timing: ASAP ⏱️ Please include: * Availability * Experience installing safes * Quote 💬

Cement render of painted masonry walls

Hi, I need someone to fix a sliding wardrobe mirror door. The mirror seems loose (possibly silicone or frame issue) and needs to be properly secured back in place. The sliding door is still there, but the mirror may need re-gluing or refitting. Looking for someone experienced with: • Mirror repair or replacement • Sliding wardrobe doors • Glass or handyman work Please bring your own tools and materials if needed. Photos attached. Location: Ryde Flexible with time.( prefer this sunday)

My bathroom has a concertina door and I want to replace with a hinged door. There are hinges and door strike on the door frame from before. I also have a solid wooden door that can be used which has hinges and door lock already installed. However this door needs to be cut and reduced by 1 inch roughly to fit. Open to a carpenter getting a hollow core door if thats easier. Located in Ambarvale, NSW

Repair the outside of the door and reinstall one hinge. - View all the details of this offer: https://www.airtasker.com/offers/01KCFT5JGGCPEVWQ01V50VE8JQ