Find an experienced handyman in Bentleigh East

Fly screen sliding door 80*202

Full installation of Kaboodle laundry cabinets, benchtop and full plumbing /installation of new sink and tap. Small room (longest part is 2080 mm). Hardware list and design/measurements of the installation are in the images below. Also require existing sink and sink unit to be ripped out and disposed of.

Update: Had a tasker assigned to the job, they have already mounted the side tracks. They had to travel because of a family emergency and are unable to finish the task. I need an experienced blind/shutter installer to mount two heavy, motorised outdoor zip blinds onto the solid brick face of my alfresco area ​Mounting System: This is a track-supported system. There are no top wall brackets. You must mount the two side tracks to the brick first, and then the heavy top cassette drops down into the top of the tracks. ​The Lift Height: The top of the tracks sit at 3080mm high. The main headboxes are very heavy and must be lifted over 3.1 meters high to slot down into the tracks. ​Equipment Required: You MUST bring a second person, a material lifter (like an SLA hoist), or a mobile scaffold to safely raise and guide the cassettes. ​The Surface: Mounting directly into the solid brick face. You must bring a hammer drill, masonry drill bits, and heavy-duty masonry anchors for the side tracks. (already installed, but may need adjustment for final installation) ​Electrical: Physical mounting only. You just need to route the exposed cables safely; a licensed electrician will be handling the hardwiring separately.

Front door isn’t operating as should. Doesn’t open properly gets jammed and handle seems loose and not aligned with latch

Drill 8 holes and screw in pull up bar

I need a new easyshed built, including anchoring to concrete. Looking for someone who has built these before.

Broken hinge for bedroom and laundry door and a broken drawer , a heavy mirror needs to be installed on the wall

Need a handyman to assemble a 132 inch UST projector screen and mount on wall. Full instructions provided, will provide screenshot as example

My sectional garage door has stopped working. The cables on both sides have come loose and need to be re‑wound and adjusted. I need someone to check the drums, shaft and spring tension, then re‑align and balance the door so it operates smoothly again. The spring is already released By making an offer, I’m assuming you have current liability insurance and have priced your quote based on the scope of work above.

The strip lighting under the kitchen cupboards isn’t working.

I have purchased a new toilet seat that just needs to be attached

Install a supplied stainless steel roller catch - door is timber, frame is from aluminum. This is the part to be installed -> https://www.bunnings.com.au/legge-15211-heavy-duty-roller-catch-stainless-steel_p0190206

I have a block out blind that is run by remote control and it wont go fully up and when I put it down it rolls o to the floor.It needs to be reset

Just need a long ladder help me put chain back to roller need 4.2M Ladder

I these 2 roller blinds to be put back on my sliding door/window area

I’m looking to have the flywire replaced in 4 existing sliding flyscreen doors as soon as possible. Each door is approximately 2200mm high x 620mm wide. I already have the sliding flyscreen doors and frames, so I only require the existing flywire to be replaced and fitted. Could you please let me know your price for all 4 doors, your earliest availability, and whether the work can be completed onsite. I’m located in Bentleigh East and am ready to book immediately if the price and availability suit.

Looking to replace front door with a glazed door for more light. Standard door size 820x2040. Wanting to keep original door hardware. Open to offers

Two odd jobs: 1. Install new single roller blind (current double blind needs removing) 2. Install 3 floating shelves

We have installed a new in wall toilet and require the plaster to be finished off and prepared for painting

Needing some door frame repairs, painting, sanding and cleaning + nail fill in holes