98 Electricians in Sydney City CBD

Need an electrician to remove two pendant lights in living room and install two new ones.

Looking for a certified electrician to make up a 25m 32a 3phase 5pin extension lead and deliver to Circular Quay

Electronics repair of projecta IC2500 charger see photos of burnt out section

Out hot water unit system doesn’t have power even that the switch is on and we need to figure it out why and fixed it.

Hi I need a qualified electrician to test and tag our shop equipment Shop located in Sydney CBD Please quote We have numerous equipment to tag test and tag though Thanks

Light has a bad contact and turns off every time after a few minutes It’s above a kitchen bench top so all wires can be accessed

enamel paint supplied - black semi gloss No place to do it here (I had the balcony draped up but took it down when another tasker accepted the listening, then didn’t contact me). I don’t want / have the skills to do it myself 😂👍 The table has been dismantled ready to be picked up etc Table is 115cm diameter so not large Top NEEDS electric sand, I kinda (very much so!) stuffed it up. The base will also need a hand sand to fix my terrible attempt at painting. You must be able to electric sand the top so it’s really flat! Will need to be collected and dropped back in Alexandria.

Electrical sub-contractors required. Various repair works across Sydney. Ranging from small call outs (consistent) to larger renovations. Please send me rates. To start first job tomorrow.

Electrician needed to extend the two existing power points to support a Cooktop, Oven, Range hood and a Dishwasher. There are three existing power points in the kitchen but none of them support the above appliances. At the moment there is no plan to remove the hard wall (gyprock surface) to do the electrical work. Please specify whether your quote is if when the work is done without the hard wall or not. I am setting a nominal price here. Quote me your price.

I would like to install new 12 volt battery / solar panel / bilge pump / radio etc to small sail boat on a swing mooring in Sydney harbour - I have all the equipment

We took the office from previous tenants so that we "took over" many different electrical units and have no idea which one was for what. Besides, our office Internet is not stable at all while we already have the best plan from Telstra. Therefore, we are looking for someone who's professional and is able to come to our office to have a look and make the problems fixed.

- replace oyster light with attached led light fitting - remove ceiling lamp and just install Edison screw light fitting . No light fitting required . Just an Edison screw Sydney cbd

The switch in the kitchen is broken. Need to be replaced. Located in Sydney CBD

We are located in the Dymocks Building in the Sydney CBD. We have put a new datarack and cabling from our suite which feeds through to the IDF room on the floor (level 7). We need this wiring to be put into one of the spare ports. Then you will need to go to the MDF room in the basement and using a tracer, identify which port it corresponds to as there is no accurate labelling. Then we need you to connect this port to the NBN port (which has already been identified and labelled so that our internet service can function. You will need a tracer to do this job quickly otherwise it will take you hours to go through the thousands of ports in the MDF room.

Need a sparky to install 30 down lights in a 3 bedroom single storey home in the southwest. Currently it has single globes.

I need 2 x fans installed in Cessnock, I have the fans, just need an electrician to remove the lights and install the fans ( they have wall mounted controllers)

Need an experiences electrician to hook up 3 downlights - cabling and everything is already there.

My Electrolux washing machine (Time Machine) needs servicing. It is working OK but keeps stalling mid-way through the cycle. I live in the Rushcutters Bay area (near the park), Estimated 2 hours for this task ($50 per hour).

I tried to hang my swing chair on my ceiling light and I broke the cables. Hope some electrician can repair it and also help enhance the ceiling light let me hang my chair or can install my chain seperately .

The main switch is triggering. Tried to disconnect all electrical items but the problem is not resolved Area: Chippendale