Hire an Electrician for any job from $25/h in St James

Power point is not working the circuit seems ok.

I need a phone socket installed in my unit, to connect my FTTB TPG internet connection. The unit is the middle of the CBD. Parking is provided on the premise.

I’m enquiring for quotation to remove and installation of combi oven, looking for one contact to do jobs (requires gas, electrical) - remove the existing Rational Combi Oven (GAS) - 10 trays - install a new one combi oven 20 trays (electrical - requires 3 phase wiring) At Chippendale Another job, - remove the existing Rational Combi oven (electrical) - 6 trays - install the Rational Combi oven 10 trays from previous outlet to this outlet here (GAS) At Westfield Sydney Looking for anyone can do this job

I have a Clipsal light switch in my bedroom, it is broken and I am looking for someone to fix it and replace it with a new one the same model for me. I assume the cost would include this set of Clipsal light switch as well, please refer to the image as shown.

Possible loose connection not sure what the issue is, need an electrician to come have a look

Hey there, my name is Ying. I need to hire a electrician / handyperson to help me in Pitt St, Sydney NSW, Australia. Need completion of works today. What do you need done? Repairs, Maintenance, Electrician What is the type of property? Restaurant & Bar Which areas of the property need work? Fix male and female toilet light Fix male toilet switch Replace kitchen plug Install Light at bottom of the step Erect and install 2x signs Fix loose plank Tighten screw on tap

Electrician needed to install electrical part of solar panel installation, Training provided , must be licences NSW& have white card & right to work in Australia

Lighting flickers and looses heat. Today light smoke from connection where cord comes out of the straightener

Wall sockets Outdoor down lights Aerials

Hi, I have moved into an apartment and when I connected by NBN internet connection I am not getting the speeds I am paying for. It is suspected that the reason is due to the phone line being split by a splitter. I'd like it to be wired in a way that only one port is active. I am located in Ultimo and available during the day. Thanks

I have two switches in the kitchen they need to be replaced completely. The wires will have to cut away from the old ones and reconnected to the new ones. THe reason for this is that the previous installation was the dodgiest of all job where they tried to glue the switches to the wall and the glue seeped all over the wires.

I need 1 PowerPoint moved about a meter 2 additional power points 1 power supply wire extended about a meter can be loose Under floor heating installed (maybe at a later stage) Ready today/ tomorrow

I need an electrician to come and supply and replace 3 halogen transformers in my bathroom. Very quick and easy job. Should take less tham 30mins. I'll pay $120 plus the cost of the transformers say $10 each

Install light sensor at rear porch. Easy task, less than 2 m height above deck. Petersham

We would need someone to bring a tall ladder with them and clean three light fittings and the sign outside of our business.

Upgrade complete single phase S/B 6C internals. Remove all existing fuses/circuit breakers and perform complete upgrade for single phase switchboard for 6 circuits including the installation of individual safety switch circuit breakers and upgrade to the main switch. All to be installed in existing sub board enclosure. Preferred breakers: ABB, Hager, SE Suburb: Carlingford NSW

My bedroom ceiling light and fan has stopped working. It is switched on and off by a hand held remote. We changed the bulb and batteries but still no change. It is probably from the 70's.

Licensed and insured electrician required to change lighting in the kitchen and bathroom to LED: 1. Main kitchen lighting has two fluorescent tubes which sit end-to-end. Magnetic ballast with starters. I bought new LED tubes with starters. Thought it would be a direct swap but only got one LED tube to work momentarily and then none worked at all. Would like to use my new LED tubes. Open fittings. One fluorescent tube still working. 2. Secondary kitchen lighting has two capsule halogens in enclosed fittings in the rangehood. Bulbs blown/never worked. I have no LEDs for these fittings. 3. Bathroom lighting has two halogens in enclosed fittings. One is an oyster fitting, other is a downlight. The bulb for the downlight has blown. The oyster light is still working. I have no LEDs for these fittings. Please advise if your offer includes or excludes new LED bulbs/fittings.

remove pendant light fitting

The air conditioning plug needs to be replaced as well as the power point which is broken with the switch not working. They are both old and the plug is the old style with the big earth part and won’t fit into an extension chord. Want to change both to the new style as replacement parts can’t be found. The pictures will tell the story. Need help ASAP.