As it’s an awkward space, but very deep, I want to utilise it for storage. I rent, so my options are limited. I am getting quotes to see if this is within my budget at the moment or if I have to wait - please help me understand the breakdown of your quotes, providing some idea of cost of materials as well as labour. The space starts off 91cm tall and ends off 245cm tall after 255cm along the ground. All the stuff in the photo would me gone obviously. Thank you!

Hi, I need some MDF that I've already bought to be nailed to a dividing wall I've already had installed.

Wooden shelving have broken off from the wall in retail store back room 3 shelves in total - Due date: Needs to be done on Friday, 16 December 2022

Recently did my whole floor however one section of the hallway seemed to have an issue and didn't cure properly. Looking to fix just this section - about 1msq - Due date: Flexible

I have a piece of wood which was used as a shelf. We need to store it easily so we need it cut into 2 pieces. However we would like it to be able to be used again in one piece. So we are thinking cutting it and with some wood behind and some holes and some longer nuts and bolts we put them on the back so you can really notice the cut when it's put back together. It's too big to fit in our storage, so i'm thinking we cut it in half. Then two pieces of wood in the behind. Nail the wood to the board Then drill 3 holes into the new wood. And use nuts and bots when we want to use it again. Then remove them and store easily. The dimensions outside are 220cm by 150cm There is a carpark here where you could drive in, cut it and then drive out - Due date: Flexible

We would like our shelves in our storage until to be taken apart and preferably reused by a builder or carpenter. We hope this helps to avoid any disposal or landfill fees. Due date: Needs to be done on Friday, 16 September 2022

Need help with the final steps of assembling a garden shed. x1 side panel and panel with door have been attached. Just need help with attaching the final 2 side panels and roof. Pinnacle Hardware Garden Shed 1.51W x 0.77D x 1.52Hm - Due date: Flexible

Kitchen Joinery Installation required. Please see render images attached. Technical drawings will be provided to installer. All items will be delivered, on-site ready for installation. - 10 x base cabinets. - 10 x upper cabinets - 13 Panels and fillers All joinery to be installed, panels to be scribed neatly, doors and drawer faces to be adjusted, all items cleaned and ready for use. Installer details: - Must have all your own tools and fixings - Must be able to problem solve and ensure the project is installed to a high standard - Will be required to wear our company shirt - Ongoing work for great, easy going installers that want the work and have a 'can-do' approach to their work - Due date: Needs to be done on Monday, 11 April 2022

We are moving to a house in Ultimo soon. It has a kitchen cupboard designed for a fridge that wont fit the fridge we are planning to buy. We are looking for a carpenter/tradesman to remove the whole cupboard, take away the materials (doors and shelves) and leave the space looking as neat as possible. The cupboard has four doors (see photos) a shelf and bottom plinth/step up on the floor. - Due date: Flexible

I would like to install folding or sliding doors in the corner to protect IT equipments please refer the photo for more details Every thing will be from carpenter Including timber door accessories and lock Commercial Property. Its a office

I would like a custom made kitchen shelf made and installed in my kitchen. I have attached a photo of my kitchen and a picture of a shelf that I would like (or similar) above my kitchen sink. It will be almost 1m45cm long. It is on plasterboard (I think...it is hollow) so I think it will require brackets. I also want to install a rail underneath for hanging cups (I have attached a pic of this too). Due date: Flexible

I need someone to help me with kitchen renovation design

Hi, I’m looking for someone to build 4 x shelves and 1 x whiteboard for our room. Please make sure to have all the tools you need to build this and also to remove the waste into our bin room. - Times 9-5pm - No one will be assisting - Preferred date: Monday 10 Jan 2022 Let me know if you have any questions. - Due date: Needs to be done on Monday, 10th Jan 2022

Hi, I need 2 people to build 4 x shelves for our room. Please make sure to have all the tools you need to build this and also to remove the waste into our bin room. - Times 9-5pm - No one will be assisting Let me know if you have any questions.

Fridge does not fit in space. Need the skirting board shaved back for it to fit in. Will be 10 min job. - Due date: Needs to be done on Friday, 17th Dec 2021

Structural certificate required for timber framing for granny flat.

Need carpentry skills person to saw out a cupbard shelf and floor board, plus install a header board for plumber to fit a dishwasher on Monday. Circular saw preferred for clean cut. - Due date: Needs to be done on Sunday, 12th Dec 2021

Build a 16.25 m squared deck, including two recessed stairs and a face on the side of the deck to the ground. The deck is 0.5 metres high and does not need any railing. Please advise what wood you would use. If you would also do the staining please quote this but quote the amount separately. - Due date: Needs to be done on Tuesday, 18th Jan 2022

I need to make 4/5 outdoor picnic table. Length = 95 cm Wide = 80 cm Table top height= 2 cm or less Table height= 2+30= 32 cm 4 legs Must be foldable or legs can be detachable. Must be light weight, coz we need to carry them to different places. Material: cheap as possible

Install approx 27 lineal metres of wood skirting boards (SK9031 profile). Refix 2 x cupboards to wall. Sand 6 lineal metres of 140mm floorboards. Hang 4 m metal lacework.