Find experienced local tradies in East Melbourne

Sauna Technical Support. Description: We're Vital+, an Australian wellness brand, and we're organising this job on behalf of one of our customers in VIC. The customer has a XEN infrared sauna that need a hinge part swapped out. We have provided the part we just need a confident handy person or technician to attend the customer's home and assist with aligning and securing the hinges so the glass panels close correctly and flush. What's involved: Attending the customer's address (details provided upon acceptance) Assisting with the replacement of the new hinge part Ensuring the panels close flush with no gap No tools should be required beyond basic hand tools Important: Please handle with care. This is a glass sauna unit. The customer will be home and can assist where needed. This is an authorised service call on behalf of Vital+. If you have experience with sauna assembly, flat pack furniture, or glass panel fitting, that's a bonus, but any confident handy person should be able to manage this.

The plaster wall of the garage is damaged, need to be filled and sand and probably repainted. Damage is about 30 cm long

I need a licensed electrian to help wire a hanged ceiling light. I've hanged the light, but just need to wire it to a new cord through the ceiling. The light is upstairs and there is roof access. the closest switch board has one switch and an adjustable wheel.

We recently had done electrical work done and need some spot plastering to cover the holes left behind/channels created. We also need some repair/patching on an area damaged by water. Photos show the work required.

CARPENTER NEEDED — internal wall frame, plasterboard, insulation + pre-hung door install (supply and install) Looking for an experienced carpenter to supply all materials and build one internal partition wall from scratch, including a pre-hung door. This is a full supply-and-install job. Please provide an itemised quote — **materials and labour separately**. ________________________________________ Scope of Work: 1. Wall Frame • One internal stud wall: 3.65m wide × 2.45m high • 70×35mm MGP10 pine framing • Studs at 450mm centres • Top plate, bottom plate, and noggins included • Wall spans full width of room, fixed to existing walls both ends • Ground floor is timber flooring 2. Door Rough-In • Frame door opening to suit 820mm × 2040mm pre-hung internal door set • King studs, jack studs, and header to standard spec • Carpenter to calculate exact rough opening dimensions based on pre-hung unit specs • Install Bunnings Hume 2040 × 820 LH pre-hung door set (door leaf, jamb, and stop) • Fit architrave both sides • Door to open, close, and latch correctly upon completion 3. Insulation • Fit Earthwool SoundShield R2.5 wall batts within stud cavity prior to boarding 4. Plasterboard • Both sides lined with 10mm CSR Gyprock (2700×1200mm sheets) • Cut and fit around door opening, screw fixed at correct centres • Board only — no taping, setting, or plastering required 5. Cornice • 55mm CSR Gyprock cove cornice both sides of new wall, adhesive fixed ________________________________________ What is NOT in scope: • Taping, plastering, or painting • Any electrical or structural work • Anything not listed above Budget $1000 to $1200. Itemised quotes only — materials and labour listed separately. If your quote exceeds this range, please explain what drives the difference. To Apply: Briefly describe your experience with internal wall framing and door hanging. No generalists please.

Section of plasterboard wall damaged and needs repair. Hole goes through to the wall cavity, with exposed framework visible. Approx A4-page size or larger (attached for reference). Looking for someone to: • Patch/replace with new sheet • Sand, set and paint to match existing white wall finish Photos attached. Happy to answer any questions before you quote! :)

I am looking for an Electrician to install an extra power point and an antenna point on the wall for the TV. Cutting the board is not an issue since that will be covered using wall panels. It is a double storey house. There are existing power points and antenna point straight down below on the same wall that can be used.

Render brick wall 6300x2200 White or light colour finish as it will be painted with a mural

Meet up to discuss plastering works - new and repair

Need patch repair done remove vent and patch had water sitting intop Ful patch and paint

Job suitable for newbie plasterer/handyman. I need a first coat of plaster applied to three walls (approx. 20 sqm total) to fill gaps between the bricks and slight levelling. All materials will be supplied. You are welcome to bring your own tools if preferred. Minimal prep and cleaning required, as flooring will be replaced. The job is expected to be completed on the same day (estimated 3–5 hours). Property is a ground floor apartment with private parking available directly beside the unit for easy access.

I’m looking for an experienced tradesperson to install a stainless steel wire (cable) balustrade on my internal staircase. Holes are already drilled and aligned

I’m looking for an experienced plasterer/painter to repair a hole in my ceiling. The hole is approximately 20cm x 20cm. The job includes: * Patching the hole with plasterboard * Finishing and sanding the area smoothly * Repainting the ceiling in white to match the existing finish Please bring your own tools and materials, and ensure the final result blends in well with the surrounding ceiling. Flexible with timing, but would prefer this done within the next few days.

Paint newly rendered walls.

There is just small patches damaged from installing the decking. Need the job complete by tomorrow. I posted 2 photos where it needs repaired and the colour

Hi, We need an electrician to install a power outlet (GPO/power point) in our walk-in closet. There is already a light in the room with a switch, but currently no power point available. Looking for someone experienced who can safely install the outlet and ensure everything is compliant. 📍 Location: Balwyn North 🕒 Flexible with timing Please bring your own tools and let me know if you need any more details. Thanks!

Need an experienced plasterer to repair a small hole in our internal plaster ceiling above the staircase (see photos). The damaged section needs to be cut out, patched with new plasterboard, set and sanded smooth, then painted to blend in with the existing ceiling. Please supply all materials, provide your own ladder/access equipment suitable for a stair void. Looking for someone who has done ceiling patch repairs before and can achieve a neat, seamless finish.

Need plaster patching for holes after removing ducted heating and evaporative cooling vents. Require base coat + top coat + sanding, no painting needed. 8 holes in total

Looking for an experienced plasterer/handyman to repair a ceiling plasterboard hole. Job Details: Ceiling hole repair (see photo) Patch and install new plasterboard Set, tape, and sand ready for painting Ensure smooth, flush finish with existing ceiling Materials: I will supply all materials (plasterboard, compound, tape, etc.) You bring your own tools Location: MelbourneTiming: Must be completed by Saturday this week Requirements: Experience with plasterboard/drywall repairs Clean, professional finish Able to match existing ceiling level and texture Please quote for labour only and include your availability. Photo attached for reference.

We need a new Power point installed about 5 m from The Switch box