Find an experienced plumber in Windsor VIC

Need Cabinet Done Must be a registered business Must go trough Airtasker Need the job to be done ASAP Thank you

Replace old toilet and old sink in powder room Replacing the toilet with Highgrove Ollie rimless toilet Our house is old, so looking for someone with experience with older houses

Replacing the kitchen tap and install bidet. I can provide those two or you can offer if you have something The tap in the picture is the one broken and need to be replaced

Heat pump tank to be re-plumbed. Only jobs are to terminate incoming water and fit a pipe from that heat pump to an existing heat pump hws. We did have one pump for upstairs and another for downstairs.not necessary now. Electrics are disconnected and removed along with heating unit, so only the tank remains. We will drain it and remove it, just need water in terminated and one pipe to upstairs fitted to another existing, adjacent heat pipe (there is a branch to connect to on existing heat pump)

I have a dripping shower head that needs to be fixed

We have a tap that is running water. We may need a washer replaced or a new tap

Hey, I have a fridge thats on the fritz and I was wondering if anyone knew anything about fridges and can have a look at it. It seems thats the freezer is running over time and is below 0 kelvin and the main fridge section is warm. At least warmer than you'd want.

Regrout bathroom/laundry tiles with a grey grout (tiler to supply) to remove calcium stains, and install new freestanding vanity in same place as current wall-hung vanity. Dispose of old vanity. Install new mixer tap.

Salon basin pipe is leaking

Need a plumber to tap into an existing water connection and run it to other side of a store, then run waste back (will likely need to add a pump). Also add waste from existing coffee machine into mains.

I need someone to replace my old kitchen mixer tap with a new IKEA ÄLMAREN mixer tap. The old tap needs to be disconnected and removed, and the new one installed and connected. - Double sink setup - Water shut-off valve for hot is under the sink, cold likely needs to be turned off at the mains - New tap and parts are ready to go - Just need someone with the right tools and plumbing know-how to swap it over

Hot water does not come on strong, need you to check what the potential issue could be and then go from there.

There use to be two hair dressing washing basins here. I’d like to reinstall one. Help

New bidet bought from Amazon. Comes with all parts. Need a plumber to install it properly with no leaks in bathroom in a 1bhk. Quick job. Easy access to the taps for water flow.

Licensed plumber needed to source and replace shower taps and shower rose

I would like to have my parents old bath/shower removed and a shower installed instead,. The taps for the shower are already there, its just removal of old bath and an installation of new shower which is a better option for my parents now . The old bath is not suitable. The old bath is now a mobility issue for them as they have to step into a bath to have a shower. Im looking for a quote please. I can add photos soon.

Looking for someone to help cut through this laundry pipe to allow my washing machine to be pushed further toward the wall and fit in the cupboard. Pipe is 11cm total but probably need about 5cm off. This is a rental so need someone with the right tools who will do a clean cut. This modification has been approved by the agent/landlord. Would also appreciate a hand reconnecting the washing machine back up once the job is done! I work full time so either weeknights after 5pm or much more flexible during the weekend. Thank you! :)

Unclog sink drain. Water is draining slowly. This is a known / recurring issue - jetting of pipe required to remove tree roots.

Registered VBA Plumber required to rough in 50mm waste water pipe approximately 6 metre with 12 metres of copper/plastic (6m of hot and 6m of cold) breaking out into outlets ( 4 hot/4cold with stopcocks on each end ready for connection. See pics. Must come to site to give a written fixed price! It’s 2.5/3.5 hours work if you know what you’re doing 12-15 metres of plastic/ copperpipe. 6.5 metre of 50mm waste pipe A few 45° and 90° and three or four T pieces.

Shower drain is blocked. Can’t reach blockage myself as the pipe curves.