Find an experienced plumber in Donvale

Hi, we would like to take a new hot water connection from the existing hot water system on the ground floor and run it approximately 15 metres to the second floor, connecting it to the existing hot water line upstairs. Please note that an on-site inspection will be required before proceeding. We would also like you to check the water pressure and confirm whether our existing hot water system can provide sufficient pressure and hot water flow to the second floor. Could you please provide us with a quote for this work, taking the above requirements into consideration?

Install hose style bidet for this bathroom (Can provide bidet if required)

Toilet is constantly leaking.

Need washing machine hooked to the drain - never had a spigot type connection before. I think the hole in the side of the wooden cabinet will need enlarging.

Gas cooktop installation 70cm

I need to replace my kitchen sink tap. I will provide the new tap.

Change old tap which is loose for new one.

Hot water system is not working . It takes a long time for hot water to come

Removes the existing cistern, wall hung type. Install new cistern, you supply. Price offered is fixed n Final.

install 500kPa pressure reducing valve at master meter - 3 unit site the water pressure is 800kPa, causing severe water hammer . Supply and install a high-flow 500kPa Pressure reducing Valve at master meter. must be a licensed plumber. Pressure Reducing Valve not Pressure limiting valve.

Main issue is water leaking inside the toilet bowl. I believe I need to replace some Cistern parts but I need a licensed plumber to check this first, and then install the Cistern parts if required. I bought the following from Bunnings - Fluidmaster® UNIVERSAL REAR-ENTRY INLET VALVE TALLATION KIT - Fluidmaster® UNIVERSAL TOILET CISTERN DUAL

Clogged sink that has an insinnkerator built in

Install of a tap for a sink basin

Toilet is constantly running, water flowing into the bowl. Brand/model as per photos.

Hi, I need help fixing a slow leak under my kitchen double sink. The Situation: We recently replaced the kitchen mixer tap and had to disassemble the PVC drainage pipes underneath. Since putting it back together, there’s a persistent drip from one or two of the joints (see photos). What needs to be done: Identify the leak: Check all PVC joints and the connection to the sink strainers. Re-seal/Re-align: Correct any misaligned pipes or worn/pinched rubber washers. Materials: Please bring standard PVC washers/seals or thread tape in case the existing ones are damaged. Note: The middle shelf can be removed for better access (as shown in the photos). Requirements: Experienced with kitchen plumbing and PVC drainage. Must bring your own tools and common replacement washers/seals. Please test for leaks with running water before finishing.

Need a plumber to install the fridge water supply

I would like to get my bathroom shower waterprrofed as I notice the water leak amd would like to get it properly sealed and waterproofed. Current pictures of where i can see the gap that needs ro be sealed.

Job Title: Hot Water Pipe Installation – 15m (Labour + Materials) Job Description: Looking for an experienced plumbing labourer to: • Disconnect and remove a small hot water unit located in the roof space. • Cap off old connections properly. • Supply all required materials (pipes, fittings, insulation, brackets, etc.). • Run approximately 15 meters of new hot water pipe from the main hot water system downstairs to upstairs. • Connect to the existing upstairs hot water line. • Test the system and make sure there are no leaks. All labour and materials must be included in your quote. 3111 Donvale Please send your total price offer.

Need to remove old washing machine and get the new one from my garage to laundry which is literally next door to the room

REPLACE A TAP ON A 15000 LITRE WATER TANK ON SITE