Find an experienced door installer in VIC

After someone/a professional who knows how to install a dog door into a glass window. Will need all right equipment and tools and know how and experienced with this type of stuff

Install a pet door in our sliding door

Need someone to install colorbind fence door.

Supply , paint and install door

Looking for someone experienced with washing machine repairs to install a new door seal/gasket on my Hoover Dynamic Next 8.5 kg front-load washer (model DXA385AH/1-AUS). - New genuine door seal (43019277) already purchased. - old seal has been removed, the job is to install the new one. -Machine is accessible and already disconnected if needed -Should be a 30–40 minute job for someone familiar with front loaders Please bring basic tools required (screwdriver/pliers). Preference for someone who has done washing machine seal replacements before.

Need new Door installation including latch.. Door and latch including new hindge will be provided

Install a garage rear door. Size 720x2010x35

Replace outdoor door frame for garage. Paint door frame and door.

Need to replace the door lock with a dead-blot that has a snip inside so it can be opened from inside without a key. You need to provide the new lock as well. I have attached a photo of something similar for an example.

IKEA Wardrobe has been built already. Just need the following done: 1. Cut out skirting board where cabinets are being installed 2. Anchor IKEA wardrobe to the concrete wall using IKEA kit 3. Install doors on wardrobe 4. Finish by sealing all the gaps to the wall

Replace both bedroom door handles with key lockable handles. I do not have the handles as I don’t know the measurements. Prefer similar style to existing handles if possible but main priority is that the handles fit into the existing holes. The 2 doors need to be keyed differently. The apartment is in the CBD. Parking is available but vehicle not more than 2m high and a bit of an awkward park. There is a loading zone at the bottom of Drewery Alley,

Install old heavy door in bedroom

Total of 9 Door stoppers and 6 glove box holders to be installed. Door stoppers installed on metal doors. Glove box holders to be installed on tiles. Metal doors will require previous door stops to be removed. The holes will need to have silicone applied to them.

Hey ! I just need someone to come around and replace my door knob with one that locks :) I’ve attached some pictures but not exactly sure what information you might need. I’d like if it is the same style handle if possible.

Need to plaster this existing dog door and then put a new cat door inside to prevent pests and cold air from coming in. Plastering dimensions: 28cm*49cm Cat door to install (I will supply) :https://www.bunnings.com.au/hakuna-pets-large-cat-flap_p3962390

I’m looking for an experienced carpenter/cabinet maker to complete the final installation of two custom solid Tasmanian oak sliding wardrobe doors. This is a top-hung system (not bottom-rolling), so please read carefully. Overview - Qty: 2 sliding doors - Material: Solid Tasmanian oak (raw timber – no finishing required) - Size (each): 2510mm H x 1170mm W x 30mm T - Weight: Heavy solid timber What’s already done (~90% complete) - Top track is fully installed and fixed - Doors are already built to size - Opening/walls/floor are square - Flat timber floor (no slope) - Wardrobe carcass is complete Key clarification (important) This is a top-hung sliding door system with a low-profile floor guide, NOT a bottom roller/bottom track system. - Doors hang entirely from the existing top track - Bottom only needs a small guide to prevent lateral movement - Total clearance available: ~30mm (sufficient for this system) Bottom guide details - Low-profile plastic/nylon floor guide (shown in photos) Requires: - Routing a single narrow vertical groove into the bottom edge of each door - Fixing the guide to the floor - No bottom rollers, no full bottom track, no 50–80mm clearance required Scope of work - Route narrow groove in bottom of both doors - Supply & install suitable low-profile floor guide (or use supplied one if suitable) - Hang both doors on existing top track - Align/adjust so doors are plumb, stable, and slide smoothly - Install stops if required - Clean, professional finish Ideal person - Carpenter or cabinet maker - Experience with top-hung sliding doors - Confident routing grooves in solid timber - High attention to detail Photos provided: top track/hardware, floor guide, installation diagram, and wardrobe setup. Please quote including labour + any small hardware required. This should be a straightforward finishing job for someone experienced with this system.

Install handle and lock to external door.

I need the door to my crawl space repaired and reattached with a latch and slightly higher than it was before. I have sanded it down but it needs a little more work done to it which I could have done had I not injured my hand. I have the hardware and tools (if needed) for the task.

Need small Hakuna dog door installed. Please refer pics for dimensions of dog door and door I want it installed on. Please send me your offer.

We need 2 doors, 1 front door and a back door installation. The doors are new and need to be installed in current frames.