Find an experienced local venetian blind repair expert in VIC

I need help repairing venetian blinds. – 3 slats are broken and need to be replaced. Replacement slats can be taken from other blinds inside the house (no need to buy). – One side of the lift cord needs to be re-threaded so the blinds can go up and down properly.

We require 1 Venetian blind to be hung up. It is quite small and would only require one person

We had some painting done and the painters removed all the Venetian blinds (of course) but we cannot find where they put the wall fixtures or even work out what type of fixture we would need to buy. Photos below. There are approx 8 blinds to rehang but we’d need your help sourcing / providing the fixtures too. Cheers.

One of the cords on the Venetian blinds has ripped and needs to be replaced

Repair timber Venetian blind

Will need to supply and install blinds that are similar to the preexisting blinds. I believe they are 25mm aluminum Venetian blinds. Approx dimensions (W x H) are ~1.1/1.2m x 2.1m

I have a venetian blind with 3 damaged slats that need replacing. The slats are about 2.55m. long by 50mmmm. wide. Also, the cords that pull the blind need replacing. The size of the blind is: 2.55m. wide by 1.33m. drop.

a timber venetian blind needs a new open/close cord & internal mechanism that makes it work.

Small Venetian blind in my powder room is tangled and won’t come down. Need help repairing.

Timber venetian blinds inspection and repair

One of the cords on the Venetian blinds has ripped and needs to be replaced

Pulley cord on Venetian blind does not open and close the blinds - need that repaired. The pulley cord to lift and lower the blinds is fine though.

Install timber Venetian blinds (2) in existing pelmet. Including deinstall and disposing of existing Roman blinds.

I have two wooden Venetian blinds approx 2m width and 2.5 m when blinds are down. The string has bundled, and snapped so the blinds can now not be raised. I need the string replaced on both.

Pascoe Vale South Clean Venetian blinds . 2 blinds 2.5m wide 1.4 m long 2 Blinds 1 m wide 1.4 long 3 blinds 600 wide 1.4 long

I am supporting a client who has a disability. He resides in Corio Vic. He purchased a venetian blind from bunnings, but doesn't have the right drill parts to drill through the steel window frame. He would like someone to come out and provide a quote.

I have a set of venetian blinds where two of the cable mechanisms have stopped working - one of these will not lock into the raised position and the other won't raise at all. I'm hoping to get the central blind functioning again as this one is in front of the sliding door onto the balcony, if possible

One window with 3 sections (less than 1m) need venetian blinds installed. I have the blinds, they have been cut and are ready to hang. I have screws and plates, just not a drill or a spare set of hands.

The front room has timber venetian blinds on all windows. The largest of these has a fault, which means when I pull the string to angle the blinds (open / closed) nothing happens, and the blinds don't change their angle. There's a small plastic wheel or cog in the casing at the top of the blind which this string would normally spin, and it the wheel seems to have stripped its gears. We are loathe to replace the whole blind because of a faulty small plastic wheel mechanism. Does anyone know how to fix? - Due date: Flexible

Install bathroom Fan & Venetian Blinds (180cm X 210) Both have been purchased. Bathroom fan is a plug in. Can provide assistance if required. Prefer Thursday or Friday.