Find a reliable appliance technician in Armadale VIC

My Fisher & Paykel DishDrawer dishwasher is repeatedly doing 3 beeps and won’t start a cycle. There was water in the bottom tray which I have fully dried, but the flood float switch is still stuck and the machine won’t reset. The drawer sits silent until I press START, then it gives 3 beeps continuously. I need someone experienced with DishDrawers to: • Pull the drawer out properly • Access the bottom tray • Manually reset/free the float switch • Dry underneath the float and switch area • Check for any small leak that may have caused the flood mode • Ensure the drain pump runs again and the machine starts a cycle normally No parts should be needed unless you identify an actual fault — this is most likely just a stuck float/flood error. Prefer someone who has worked on Fisher & Paykel DishDrawers before. Thanks!

We have a new battery Ring Battery Video Doorbell Pro and need to install it into the brick wall at front door

Moved into a new place, need my Bosch watching machine installed

Dishwasher plumbing connection set up in my apartment connect a dishwasher to my existing kitchen sink's water and waste outlets

Two installation quotes needed: 1 for new hot water system (replace current) installation in same place 1 for continuous hot water gas system to be installed outside the property I’m happy to purchase and supply it myself

My Miele Jubilee dishwasher won’t drain, leading to water pooling at the bottom. Think some debris is jamming the impeller.

Euromaid Washing machine that starts and the stops midcycle. Have tried cleaning the filter- looking for a firm price only

Our integrated (old) ikea dishwasher is leaking and requires new seals along the bottom of the door as it is leaking

I need help installing a heat pump pool heater onto a new stand next to my existing pool equipment (see photo attached). This job includes bolting the stand onto the concrete below (I have the bolts onsite), moving the heater onto the stand (I can help move/lift it), and plumbing the heater in to connect to my existing pool filter. The heater has already been delivered to my property. It's a Pool Set Eco-Heata 17kW, with installation instructions here: https://www.poolset.com.au/uploads/files/ECOHEATA-HeatPump-Manual.pdf

Bosch series 6 washer - getting error message E36, google says drainage issue but checked all pipes - nothing obvious so it might be the drum that needs tightening. I'm not really sure! Overall checkup for Fisher and Paykel washer and my Fisher and Paykel dryer would be great. Armadale. I have flexible availability :) thanks!

Asko dishwasher power not turning on have checked fuse box

We have an indoor drying room - a small room that we have installed wall heaters for drying our washing. We currently have an outdoor washing line attached to the wall but it's not big enough so we end up using a long fold-up line as well. It's unsightly so I want to get a proper line installed that maximizes the space and also looks like it's better quality workmanship. Lines need to run length of room. Either using an existing line system or building individual lines attached at each end. We haven't seen an off the shelf option that meets our needs but hopefully someone has a better solution. Will also need to remove the existing line and repair wall before adding new line. We are reasonable and prepared to pay for your time. Will revise the budget once I receive some quotes & understand how much the job is likely to cost.

We need a couple of new Drawers replaced 1. Double Oven Removed. Replaced with a Newly purchased Single Oven. - So modify the existing void to accommodate the smaller unit. 2. Modify Rangehood Cavity/Carcass to facilitate the New Rangehood. 3. Additional Small Repairs. 4. Note: All Electricals are already completed.

There is a water leakage from washing machine. Kindly help me resolve this issue. Thanks

Install new machine in 8th floor apartment and disposal/removal of the old one.

My anko washing machine is working but the door got stuck and I need to open it since I have clothes inside and understand if it works again. I have tried to open it in anyway.

I dried some shoes in my dryer and jts knocked the drum off. So it now won’t spin. Will need someone to take it down (heavy), remove the back panel and reset the drum, and replace. I can be around as an extra pair of hands jf needed

Beko 7lt Washing Machine (WMB 71231 LA) not completing cycle. Fills with some water then stops. Filter has been checked and ‘factory’ reset has been done (full power removal, door open/closed 12 times).

Gas was cut yesterday and now hydronic heating unit needs restarting. Gas supply restored.

I need to connect a washing machine for a client in armadale