Find a local electronics repairer in Armadale VIC

4-6 chips to white and blue/grey wallpaper and paint

Render the following: Photo 1 - Bottom of shared wall Photo 2 - Around air vent case Photo 3 - The face of the porch Render texture must match and blend in with existing house. We have a painter who will colour match the paint so render product does not need to include paint colour.

One side of my Sony Ultwear Wireless Noise Cancelling headphones have snapped. They are designed to snap inwards to take up less space in a bag, but it seems this one side has snapped off/too far. I believe should be an easy fix! Photos attached to give you an idea ☺️

I need to cut three slits into the stone Benchtops. Measurements will be approximately 70 cm X 10 cm. Need to be a clean cut

Looking for someone experienced with plumbing to replace the tap handles ( or cartridges) on my kitchen sink. Actual tap was recently changed, so likely only need the handles changed. Please let know if you will supply required parts, or if not what parts i should buy beforehand

Replace two washers in one sink area

Need 2 benchtops sanded back to bare timber. Possibly re stained with proper benchtop application in same colour.

Replace Caroma kitchen taps. Swapping exact taps, old for new.

I need a Carpenter or Handyman to silicone & seal kitchen cabinet kick-boards & identify and seal slightly larger gaps if required to prevent drafts and mice entering the house from the sub-floor.

Need a plumber to fix 2 leaky taps.

Install Philips Smart Lock on the front door - If the price is right I have 2 to install.

Assemble 2x KLEPPSTAD Wardrobe with 3 doors, white 117x176 cm

Hot water is trickling when turning it on. Cold taps running normally. Water is heated by gas. Gas working on stove tops. Potential valve issue or blockage? Accred plumber required please.

I need somebody to assemble a queen Kleppstad ikea bed. I have removed from bird and gotten to step 6/7 before stopping.

The shower rose is leaking and the taps are too hard to turn on and off. So we thought replace both to a similar product from Bunnings. Can we get a set for $200?

I have 3 tap handles on walls - one in the shower and 2 in above bathroom basins - that need tightening - they are falling off - and I have a lock in a bathroom sliding door that doesn’t work.

Alarm Hills Reliance NX-1508 Alarm, has gone crazy. Is not accepting alarm codes we have used - or Installer code 9713. It needs to be reset. It won't stop going off. Note - the image is when it was working. It has the alarm and service lights flashing now..

Need basin and vanity fitted. All taps to bath, shower and rose, laundry sink and washing machine taps. Thanks

I have a Phillips bridge home network system that connects to the lights and other devices. I’ve been away a few months and it’s stopped working. Wifi is functioning fine but I can’t figure out the problem.

Around 4 taps need to be fixed asap