Find a local electronics repairer in St Kilda VIC

I have the new taps and spout To be replace, (And using an old part from the kitchen taps Replacing existing shower tap,)

Looking for someone to supply and change the washers in my bathroom for both the basin and shower

Remove weatherboard Jack up floor add 5m and 6. New Stumps . Very good access Underfloor 600mm access Jack up to level Add 5m of bearer and 4 new stumps Under kitchen Add 1 new stump

Quick job to replace old taps with new ones. St Kilda location. Sunday 23rd Aug ideal otherwise most week nights after 6pm ( not possible during day as I’m at work).

Ave Revo 15 speaker has a crack/ hole from being dropped, sound from drivers is fine just causes rattling when at high volume as on of the screws holding the casing together isn’t catching anymore

Instal new taps (x4) & new faucet (x1) on wall that got re-tiled. The old taps and faucet have already been removed. I have already got the new taps and faucet.

** EDITED with more detailed requirements Looking for an experienced cabinetmaker or joiner to install a fully integrated Ikea kitchen with custom size benchtops. More 3D design files will be available when required. Cabinets: already assembled, they simply need installation. There are no overhead cabinets. Benchtops: need modifying so shall require accurate measurements and cutting as well as cutting the openings for sink and cooktop. See photos for more explanation on the most difficult cuts.... Additiolnally, excess materials to be cut for shelving (also to be installed). All finishes like silicon and edge trimming for cut bench tops to be included in quote. Benchtop joins to be mason mitre joins Island Bench: To be secured to tiled flooring Appliances: RangeHood and dishwasher to be installed (plumber booked) Requirements: Must have proven experience with IKEA installations and bring all necessary tools for onsite benchtop cutting and drilling into tile flooring. Timing: Dates around the 23rd July Please quote

Bosch Maxx 8 condenser dryer (WTE86302AU). The dryer starts normally, the drum spins and runs for about 1 minute, then stops and the “Container” warning light comes on. I have already: * Cleaned the lint filter * Cleaned the condenser/heat exchanger * Cleaned internal ducts and lint build-up * Unplugged and reset the machine The machine has been partially disassembled and thoroughly cleaned, but the fault remains. Looking for someone experienced with Bosch dryers to diagnose and repair the issue.

Looking for a registered plumber to come and snake my shower drain as it’s clogged. Also to swap over like-for like taps. I’ve got the taps I just need someone to do the install. New taps are: https://www.amazon.com.au/gp/aw/d/B09P1H4LF9?psc=1&ref=ppx_pop_mob_b_asin_title https://www.amazon.com.au/gp/aw/d/B0B12KMZGD?psc=1&ref=ppx_pop_mob_b_asin_title

**BUDGET IS FINAL - DO NOT OFFER IF ABOVE WHAT IS SET PLEASE** Looking for an experienced painter available today in St Kilda. The job: Wall is prepped and ready. Original green has been sanded back, grey primer applied, and one coat of Dulux Vivid White and Snowy Mountain Half is already on. I need a professional to apply the final coat to a clean finish and correct any imperfections. Scope may also include: Touching up or repainting adjoining walls Ceiling work if needed Taping and masking Light sanding where required What's supplied: All paint (Dulux Vivid White + Snowy Mountain Half), drop sheets, and basic tools. Note: I'd suggest bringing your own quality roller and brushes as what I have is basic. Who I want: Someone who does clean, professional work and can get results today. Send a message with your availability and any relevant experience.

I have purchased replacement parts. Replace (see photos) - basin taps and faucet - bath taps and faucet - shower fitting and taps - hose for toilet - bottle trap for sink - bath waste - floor waste Im planning to tile over the existing tiles on the wall where the bath taps and faucet and shower taps are located. So these will likely need adjustment for changing set-back.

Description: Looking for an experienced painter to complete an end-of-lease repaint/touch-up for a small studio apartment. Scope of Work: - Repaint walls with standard indoor white paint - Touch up marks/scuffs on walls - Repaint/touch up bathroom walls and ceiling as needed - General freshen-up to help prepare property for end of lease inspection Property Type: Studio apartment Requirements: - Please bring your own painting equipment and supplies - Must have experience with end-of-lease painting jobs - Clean and professional finish required - Protect floors/furniture and clean up after completion Please include your quote, availability, and any previous experience/photos if available.

I have about 7 chips off concrete that need filling. As soon as possible please

I replaced the washers on my taps as they were leaking but now they are leaking from under the sink too

Replace existing resistor on circuit board

Install new kitchen tap and washing machine in/outlets beneath sink

I’m looking for an experienced handyman to remove the kitchen kickboard (toe-kick panel) to access the space behind the lower cabinets, clean the area, and seal all gaps/openings to prevent possible rodent/possum entry.

Need gaps/cracks sealed with silicone around the perimeter of a small studio apartment to prevent bugs coming from neighbouring units. Work includes skirting boards and any visible window frame cracks. Clean, neat finish required. Budget: 150(approx 2 hours work). Please bring tools and silicone. WED 1.30 - 3.30 OR THUR 3-5PM

The power cord isn't working it's making the beeping sound but not heating up

My GHD hair straighteners have just started showing a red light and making a zapping noise. Happy to post the item or drop them off at your locatio.