Find a local console repairer in St Kilda VIC

Bosch Maxx 8 condenser dryer (WTE86302AU). The dryer starts normally, the drum spins and runs for about 1 minute, then stops and the “Container” warning light comes on. I have already: * Cleaned the lint filter * Cleaned the condenser/heat exchanger * Cleaned internal ducts and lint build-up * Unplugged and reset the machine The machine has been partially disassembled and thoroughly cleaned, but the fault remains. Looking for someone experienced with Bosch dryers to diagnose and repair the issue.

**BUDGET IS FINAL - DO NOT OFFER IF ABOVE WHAT IS SET PLEASE** Looking for an experienced painter available today in St Kilda. The job: Wall is prepped and ready. Original green has been sanded back, grey primer applied, and one coat of Dulux Vivid White and Snowy Mountain Half is already on. I need a professional to apply the final coat to a clean finish and correct any imperfections. Scope may also include: Touching up or repainting adjoining walls Ceiling work if needed Taping and masking Light sanding where required What's supplied: All paint (Dulux Vivid White + Snowy Mountain Half), drop sheets, and basic tools. Note: I'd suggest bringing your own quality roller and brushes as what I have is basic. Who I want: Someone who does clean, professional work and can get results today. Send a message with your availability and any relevant experience.

I have purchased replacement parts. Replace (see photos) - basin taps and faucet - bath taps and faucet - shower fitting and taps - hose for toilet - bottle trap for sink - bath waste - floor waste Im planning to tile over the existing tiles on the wall where the bath taps and faucet and shower taps are located. So these will likely need adjustment for changing set-back.

Description: Looking for an experienced painter to complete an end-of-lease repaint/touch-up for a small studio apartment. Scope of Work: - Repaint walls with standard indoor white paint - Touch up marks/scuffs on walls - Repaint/touch up bathroom walls and ceiling as needed - General freshen-up to help prepare property for end of lease inspection Property Type: Studio apartment Requirements: - Please bring your own painting equipment and supplies - Must have experience with end-of-lease painting jobs - Clean and professional finish required - Protect floors/furniture and clean up after completion Please include your quote, availability, and any previous experience/photos if available.

I have about 7 chips off concrete that need filling. As soon as possible please

I replaced the washers on my taps as they were leaking but now they are leaking from under the sink too

Install new kitchen tap and washing machine in/outlets beneath sink

I’m looking for an experienced handyman to remove the kitchen kickboard (toe-kick panel) to access the space behind the lower cabinets, clean the area, and seal all gaps/openings to prevent possible rodent/possum entry.

Need gaps/cracks sealed with silicone around the perimeter of a small studio apartment to prevent bugs coming from neighbouring units. Work includes skirting boards and any visible window frame cracks. Clean, neat finish required. Budget: 150(approx 2 hours work). Please bring tools and silicone. WED 1.30 - 3.30 OR THUR 3-5PM

Disconnect and cap water outlets in the kitchen and replace new mini stops and new flexible hoses on toilets

Power keeps tripping, not sure what electrical item is causing it. Only my apartment is having this issue in the building. Issue began today. Need someone either tomorrow, Sunday or Monday. Sooner than later is better. - please note I believe the locks require a special key that electricians may have…

See photos please, some of it is cement sheet. I don’t need a complete fix just something minor

We need help fixing a toilet that only fills up very slowly and flushes irregularly. Also have a shower that leaks water at the shower head at the point where it is joined to the wall and a couple of taps, that drip if not turned off very tightly.

Just need someone to install new dashcam system and GPS. Too many cords for me to hide.

Need somone with a working car to help jumpstart my car.

I have a large, lightweight (bonded felt) lampshade that needs to be installed in a new location. This location currently does not have a lampshade. The wiring will connect to an existing 6-panel switch (only 4 panels are currently in use). Attention to detail is critical: the lampshade must hang at the exact same height as an identical lampshade in the adjacent area. The new electrical cord (I have) will need to be measured, fixed, and cut to achieve the correct drop. Precision and careful installation are essential for this task.

Dishwasher (Fisher & Paykel DD60SI7) Trips Safety Switch When Heating – Needs Repair Description: Fisher & Paykel dishwasher trips the safety switch every time it reaches the heating stage (when water gets hot). • Other appliances in the house work fine without tripping • Issue is consistent and repeatable • Suspect faulty heating element or internal wiring • Need an experienced appliance repair technician (preferably licensed electrician) who can test and repair the dishwasher Please include your experience with dishwasher repairs in your response.

Assemble Kleppstad wardrobe, from new 4 wooden dowels were put in the wrong hole in the shelve section and will need pliers to come out or reverse drill. Silly mistake on attempting to assemble myself, they arent hammered in to far. Does not to be drilled into a wall, will be a stand alone unit. Would like to get this done Sunday evening or Monday morning.

Taps to be removed and a stop / block nut placed over them. Will be tiled over.

Walls have gaps at bottom where old skirting boards were removed, need to fill gaps with sand cement render and top with white plaster, must be accurate job , no kicking out at bottom as has to be ready for new skirting boards … work must be accurate Apologies. Photos coming. Please check back tomorrow. Thanks