Find a reliable appliance technician in Balaclava VIC

Hoshizaki ice machine water inlet leaking from inside when ice machine is turned on. I have a video I can send.

Our dishwasher leaks water whenever it runs - assume it needs a new seal. I have a replacement bottom seal but need it installed.

Need to replace and install new LED lights on the kitchen rangehood. I’ve already the replacement LED lights they just need to be installed. Rangehood Brand ILVE model IVUM60

Ghd hinge cap of straighteners need fixed

Hinge cap on my ghd straighteners has broken and my straighteners are sliding when I straighten my hair because the cap keeps falling out

Replace existing slide-out range hood with new plug-in model. Old unit out, new unit installed and tested

Hi Seeking a licenced tasker to instal a Gas Chef Stove - - take out Modern Maid Flinders stove - Instal Chef CFG503WCH replacing a Modern Maid Flinders, 54cm x 90cm - chef for gas leak in area - leave old unit on the nature strip Will accept first reasonable price and please include when you can complete the job please - Thank you -

Machine washing is playing-up and not cleaning or drying clothes. During the cycle, it makes strange sounds and often overflows with soapy water. At the end of the rinse and soon cycle, lots of water remains in the barrel.

We are moving out and need our gas stove disconnected.

Hi, I purchased my washing machine 2 months ago and unfortunately there is already a tear inside the rubber seal. I’ve received a replacement seal but I need someone with the right tools, experience and knowledge of washing machines to install it.

Hi, I’m looking for an experienced fridge/ freezer technician to diagnose and repair a built-in refrigerator this Friday (morning or daytime preferred). My boyfriend will be there to help in case small assistance is needed. Issue: The fridge is short-cycling — the compressor starts, runs for a few seconds, then clicks off. Details: * Issue started suddenly (was working fine before) Fridge and freezer stopped working * Built-in unit, so access to the rear (condenser/compressor) may be tight What I need: * Diagnosis of the issue * Repair (if feasible) * Quote including parts and labour Please include your experience with similar repairs and availability for Friday.

Smeg dishwasher requires troubleshooting and soldering of circuit board. Must be qualified appliance electrician.

Likely simple evaporator fan replacement (no cooling airflow) Looking for an experienced appliance/fridge technician to inspect and repair a built-in ILVE fridge. Details: • Model: ILREF256I (integrated unit) • Location: Balaclava (Carlisle St) • Access: First floor apartment with lift Issue: • Fridge not cooling, freezer only slightly cold • Compressor is running • No airflow or fan noise from freezer area • Unit has been fully defrosted for 48 hours Likely evaporator fan failure, looking for someone who can: • Diagnose properly • Replace fan if required (ideally same visit) Please include: • Experience with fridge repairs • Availability • Total cost (callout + parts + labour) Need this resolved ASAP 👍

We just moved to a new house and the Removalist didn’t connect the washing machine properly. Can you re install it?

I need help connecting a washing machine drain hose extension to the sink trap spigot under the sink. Details: • Washing machine already has the original drain hose installed • I have a hose extension, joiner kit, and hose clamps ready • Sink trap spigot outlet is already open and accessible • Just need everything properly connected and secured Job includes: • Join extension to existing washing machine drain hose using joiner kit • Attach hose to sink trap spigot outlet • Secure with provided hose clamps • Check connection and run a quick test for leaks/drainage

Washing machine has stopped working need someone to fix it please! F3 error.

Service and fine tune coffee machine

Need an over and cook top (single unit) disconnected from the gas.

Tisira oven not heating up. Element has been changed and still not heating up. Turns on fine.

Pretty sure it’s a blown fuse but need qualified electrician to replace and fix