Find professional window and door services in Melbourne

Sliding door pin won’t slot in due to damage on base. Door also needs to be checked for water damage on bottom section, plus sealant on right hand side of door which is worn away.

Superlift GDO-5 garage door opener won't open, power is on but not activating.

Rolling door screw are missing

The door seems to be sitting slightly out of alignment, so the latch doesn’t line up correctly with the strike plate and the door cannot close properly. Looking for an experienced handyman to: * Inspect the door and hinges * Adjust/re-align the door as needed * Adjust the latch/strike plate if necessary * Make sure the door closes and latches properly Photos attached for reference. Please bring the necessary tools and hardware. Ideally, this should be a straightforward door adjustment rather than replacing the door. Location: Port Melbourne

The door handle is loose and the bathroom fan is not working

We have a very wobbly door handle on our apartment front door. The plate is pulling off because the door is sticking a little at the top. I have tired to plug the screw holes and tighten things up but it has only worked temporarily. I would like to get the following done: - Plain the door to remove the sticking - Somehow fix the existing lever so it's not wobbling and pulling off - Add a separate lock higher up that has a key externally and a snib internally. The door leaf is timber but the frame is steel.

Awning Window Inspection & Repair Inspect and repair an existing aluminium awning/projected window that is intermittently failing to close and seal correctly. The window is part of an aluminium curtain-wall/grid façade and is located at height. Issue The awning sash is currently unable to close fully against the frame, leaving a visible gap. The issue has previously been intermittent but is now preventing the window from closing flush. The window appears to have an aluminium friction-stay/awning operating mechanism and multiple locking/engagement points. Scope of Works - Inspect the awning window and identify the cause of the incomplete closure. - Inspect the sash for alignment, movement or sagging. - Inspect the friction-stay/awning operating hardware for wear, damage, binding or misalignment. - Inspect the locking mechanism, cams and keepers for correct engagement and alignment. - Check that the sash is closing evenly against the surrounding frame and seals. - Adjust and realign the sash and hardware where appropriate. - Lubricate/service suitable moving hardware where required. - Replace worn, damaged or failed hardware if necessary, subject to approval. - Test the window through multiple opening/closing cycles following repair. - Confirm that the window closes fully, operates smoothly and engages the locking mechanism correctly. Window to close fully and flush with the surrounding frame, with the locking mechanism engaging correctly and the sash operating smoothly and safely.

I want someone who can repair commercial automatic sliding doors

Install 2 door handles. Previous handles have been removed. Refer images, a bigger hole is required. Sliding laundry door needs adjusting/shortening and it is too tight to the bottom carpet.

Our washer and dryer are a couple of millimeters off fitting. Need to remove the sliding door to install them. Also the washing machine’s inlet hose is too short so it needs a new one at 3m to be safe. You’ll need to supply this please & take any rubbish with you. We need it done Sunday 16th August around 10am as we have to be out of the house by noon.

Handyman to tighten tap of kitchen sink and fix bathroom door knob

Repair 2x wooden door. Fix door handle that’s sticking. Fix hinge on cupboard door

Need a handyman in to fix the door downstairs leading to the carpark of office space. The issue is with the top door hinge, seems to be bent (and is catching). This was the issue last time. I think this was probably damaged when previous tenants moved out as they most likely forced the door wide open.

Location: Windsor Budget: $40 per door Looking for someone experienced to install new door handles on 6 internal doors. * Old door handles have already been removed. * New handles are ready to be installed. * Some doors may need minor carpentry/adjustment around the existing latch/strike area to ensure the latch fits snugly and operates correctly. * Looking for a neat, professional finish. * Ideally someone experienced with door hardware/carpentry. 6 doors × $40 Please only quote if you’re comfortable with minor adjustments to the doors/latch openings as required.

Our kitchen door doesn't close, i think because floor has been redone to a higher level than original. It looks like someone has already tried to file back the bottom. Can you get it to close cleanly, with enough clearance so building movements won't have it jammed in future?

Door not closing correctly scraping on the top right hand corner. Need door to be fixed

A bedroom door has come off one of its hinges and needs to be re-secured.

Need someone to hang pictures in a wall (see attached pictures) and repair the bottom of a sliding door.

The hinges have come out of the side wall of the wardrobe. I need someone to rehang it. Preferably put bigger wall plugs in.

Pneumatic screen door closer We are looking to have a pneumatic screen door closer replaced and refitted onto the existing screen door. .