Find a professional kitchen sink installation service in London

The kitchen sink is already perfectly fitted and sitting inside the countertop cutout. I just need a handyman to crawl underneath to tighten the mounting clips it came with so it is supported, and connect the plastic waste pipe/P-trap underneath. It is a straightforward job which should not take longer than an hour. All parts should be there.

There's an ongoing foul smell from kitchen sink. I need someone to investigate the cause and provide a quote for remedial works.

Leaking kitchen sink waste in a rented flat. The seal on the plughole waste flange has failed - water runs down from the flange as soon as the tap is run. Needs the sink strainer removed, old seal cleaned off, refitted with a new washer and fresh silicone. Please also check and reseal the compression joints on the waste pipe while you are under there, as the leak may not be limited to the flange. There is a waste disposal unit fitted to the other bowl. Note there is a plug socket inside the cupboard so please take care. Tenant is living in the property and will let you in - I am the landlord and based abroad, so timing to be arranged with him directly.

**1. Refit roller blind bracket** Roller blind bracket pulled out of the window reveal. Plasterboard anchors have torn out. Need old holes filled and both brackets refixed properly, either into the uPVC frame head or into solid material behind the plaster. One window, under an hour. **2. Reseal two kitchen sink areas** Failed sealant along the worktop to upstand joint at two separate sink areas in the same kitchen, plus around the base of the mixer tap at each. Rake out old sealant, clean and dry, reseal with mould resistant silicone colour matched to light quartz. Also tighten the taps underneath if there is any movement. Both Blanco undermount sinks.

My drop in kitchen sink has fallen out

Replacing kitchen sink tap Available tmr 1-3 pm or after 5;30 pm

Kitchen sink and mixer tap fitting after removal of old dual taps, which as I am physically disabled I cannot do. This is such a small task, so to make it worthwhile your visit I will pay you for fitting and removal

A round sink, with a left handside draining board and a single tap.

I need a handyman plumber to install my new water2 filter under my kitchen sink.

Everything is fully prepared and ready to go. Connect a replacement induction, old hob is already removed, hole is cut to size, and existing 32-amp wiring is ready).Connect a new tap and plumb the waste for an undermount sink (the sink is already glued and fixed in place).The workspace is completely clear and clean. Could you let me know your availability looking for asap!

These 3 smoke alarms have been detached from their position. I want that re-fitted and want to make sure that they are working. Also, there is a small leak in the kitchen sink tap. Needs to be investigated and fixed.

Brita Tap Filter is currently installed in Kitchen Sink. That has to be uninstalled and old tap has to be installed back.

My kitchen sink is blocked, I have tried different products to unblock it but nothing worked. I have unscrewed one of the pipes below the sink but didn't find anything.

We just need a straightforward kitchen sink and tap replacement. We’re replacing the existing sink with a new Bower 1000 x 500mm 1.5-bowl stainless-steel sink and fitting a new GROHE mixer tap, which I’ve already bought, as shown in the photo. Everything will be supplied and ready to fit. It should be a small, straightforward job. Please send me your best quote.

Unblock kitchen sink slow moving

I’m looking for a plumber to repair my kitchen sink waste pipe. The existing P-trap/U-bend has come apart and I haven’t been able to refit it correctly. I purchased what I thought was the correct replacement, but it appears the fittings/washers aren’t compatible with my existing pipework. Job required: * Assess the current waste pipe setup. * Supply any correct fittings/washers if needed. * Replace and fit a new P-trap/U-bend. * Ensure all joints are watertight and test for leaks before leaving. The sink is currently unusable as the waste pipe has come apart (see photos). Please let me know: * Your availability. * Whether you’ll bring any standard 40mm waste fittings that may be required. * Your total price including any small parts. Looking to have this fixed as soon as possible.

I think the u bend is blocked and will need removing and cleared. I have tried baking soda and white vinegar followed by a stronger sink cleaner, and whilst it is better it is still not draining.

I’m looking for a plumber to attend and investigate a drainage issue in my kitchen. The problem started while the water from the washing machine start to back up into the kitchen sink, and the sink is now draining very slowly / has become blocked. The washing machine and kitchen sink share a common waste pipe, so there may be a blockage further down the drainage line. I would like someone to come out, identify the cause of the blockage, and carry out any necessary unblocking works.

Kitchen sink is blocked, water starts coming out of other sink for some reason. Tried one shot it didn’t do anything, also tried long metal snake to unblock but it didn’t do anything

There is a slow leak coming from the kitchen sink which I don’t know how to fix and would like some help from a plumber.